Dakota Digital LED Tail Lights LAT-NR330 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
LAT-NR330
LED Tail Lights for 1940-53 Chevrolet Pickup

MAN#650210

Kit includes:

Installation: 40-53 Chevrolet Pickup

1. Remove the screw that holds the lens on and remove from the housing.
2. Remove the light bulb(s) from the socket(s).
3. Disconnect the tail light wires from the vehicle. (If there is no place to disconnect the wires, the
wires will need to be cut and will be spliced to the LED assembly later.)
4. Remove and save the screws that ho

Summary of the content on the page No. 2

6. Work the cable from the LED assembly through the hole in the back of the tail light housing from inside the housing. 7. Place the LED assembly into the tail light housing. For original housings, a countersunk screw, nut and washer is provided for the bottom hole. The screw should go into the housing from the back and the washer and nut should hold the bracket against the back of the housing. For some reproduction housings, the narrow bottom of the LED assembly bracket fits into a slo

Summary of the content on the page No. 3

LED wires Tail light Red Driver’s Turn Green Passenger’s Turn Green Ground Black 12. Attach the ground wire ring terminal to a good chassis ground and secure the LED assembly cable to prevent the cable from shaking and breaking the ground wire. 13. Repeat the steps above for the other tail light. 14. Test the tail lights, brake lights and turn signals. If the turn signals do not flash, you will need to upgrade your flasher. If you are replacing only the rear turn signals you should be ab