Summary of the content on the page No. 1
V-AVD99
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 5” TFT
DISPLAY AND TV TUNER
Instruction manual
DVD/CD/MP3- 5”
TFT .
Summary of the content on the page No. 2
V-AVD99 Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ...............................................................................................................................................2 Important safeguards .............................................................
Summary of the content on the page No. 3
V-AVD99 Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser be
Summary of the content on the page No. 4
V-AVD99 Accessories Remote control ISO connector USB cable Mounting parts: Keys 2 pcs. Rubber protector 1 pc. Rear mounting bolt 1pc. Instruction manual Consumer information Warranty card Black front panel case Receiver 4
Summary of the content on the page No. 5
V-AVD99 Installation/Connection Installation method 5
Summary of the content on the page No. 6
V-AVD99 Disassembly of the control panel Before disassembly of the control panel, power disconnection is required. Then press EJECT button. The panel will fall down to horizontal position. Push the panel leftwards. Meanwhile put the panel towards yourself to the right. Attaching of the front panel Firstly insert the left part of the front panel into the left part of the main unit, have the concave part of the panel hold the protruding point of the main unit. Insert the right side of the front pa
Summary of the content on the page No. 7
V-AVD99 Electrical connection Notes: The user can connect the 4 RCA to the external amplifier; please connect “backstage (rear) out” to the “rear input” of the external amplifier. When you use the Dual zone play function for Radio/DVD/SD/MMC/USB, the Front out should be connected with the front speaker (L/R) for the 7
Summary of the content on the page No. 8
V-AVD99 Radio function, and the Backstage out should be connected with the rear monitor for the DVD audio output. Note: The parking wire is connected with brake signal; for safety, the programs can be seen on the monitor after braking the car. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may
Summary of the content on the page No. 9
V-AVD99 Output connection chart Note: Before connecting the front/rear monitors with the unit, the total electric current of the rear monitor cannot be bigger than 2A, and the cathode must be connected with the “P. GND” derivation cable of the unit, otherwise the image of the monitor will be disturbed by the volume of the unit. 9
Summary of the content on the page No. 10
V-AVD99 Rear camera and amplifier output connections For your driving safety, please link your brake detecting wire with low power level, and keep it controlled by manual brake switch. Wire should be high power level and the unit cannot play DVD or VCD disc. And this caution displays on the screen: “Warning. Please stop watch video player”. 10
Summary of the content on the page No. 11
V-AVD99 Panel controls Front panel 1. BAND button 2. POWER/SRC button 3. L/R/TA/AF button 4. MUTE button 5. TOUCH SCREEN 6. EJECT button 7. OPEN buttons 8. NEXT/PREVIOUS buttons 9. UP/DOWN buttons 10. PLAY/PAUSE button 11. RC sensor 12. RESET button 13. USB jack 14. Microphone Inner Panel 15. V in 16. A in 17. VOLUME knob/SEL button 18. CD slot 19. GPS card slot (option) 20. SD/MMC card slot Top view 11
Summary of the content on the page No. 12
V-AVD99 Remote control 1. MODE button 2. POWER button 3. GOTO button 4. REPEAT button 5. STOP button 6. DISP button 7. PREVIOUS/CH-/NEXT/CH+ button 8. ENTER button 9. Cursor buttons (LEFT/RIGHT/UP/DOWN) 10. TFT-ANGLE button 11. Digit buttons 12. MUTE button 13. EJECT button 14. BAND button 15. MENU button 16. PLAY/PAUSE/AMS button 17. VOL+/VOL- button 18. SEL button 19. SETUP button 20. TITLE button 21. PBC button 22. R/L button 23. ZOOM button 24. N/P button 25. SUB-T button 12
Summary of the content on the page No. 13
V-AVD99 Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the
Summary of the content on the page No. 14
V-AVD99 General operation In any mode (except for VIDEO) touch the screen once, and then press EXIT on the top left-hand corner to enter the source menu. 1. POWER button, press to turn off the unit; 2. SETTING button, press to enter setting mode; 14
Summary of the content on the page No. 15
V-AVD99 1. You can set: clock (press +/- icons near H (hour) and M (minute)) 2. TFT on/off/auto (automatic screen off) mode 3. Camera view (left (normal) or right (mirror)), if the rear view camera is connected, 4. Radio frequency (Europe, USA1, USA2, Japan, Russia). Choose “Russia” to enable enhanced frequency range 5. Choose the language (option) 6. Press EXIT to exit General setup menu Note: The operations in this menu are available via touch screen. Press the item you want to adjust on the l
Summary of the content on the page No. 16
V-AVD99 3. TFT UP button, press to change the angle of the panel upwards; 4. TFT DOWN button, press to change the angle of the panel downwards; 5. EJECT button, press to eject the disc; 6. RADIO button, press to choose radio mode; 7. DVD button, press to choose DVD mode; 8. SD/USB button, press to choose SD or USB mode; 9. GPS button*; 10. TV button, press to choose TV mode; 11. AUX button, press to choose AUX mode; 12. B.TOOTH button (option); 13. TFT ON/OFF button, press to turn on or off TFT
Summary of the content on the page No. 17
V-AVD99 Volume control Press VOL+/- buttons on the RC or rotate VOL knob on the unit to adjust the volume level. Mute function Press MUTE button on the panel or on the RC or MUTE button on the touchable screen to disable the sound. “MUTE” will appear on the display. Press these buttons again or press VOL+/- buttons on the RC or rotate VOL knob to resume the volume. Blank screen Press and hold MUTE button on the unit to disable the picture and have the blank screen. To resume the picture, press M
Summary of the content on the page No. 18
V-AVD99 Radio operation This unit is equipped with a touch screen. To perform various operations you can use buttons on the RC, on the front panel as well as screen touchable buttons. Band selection Press BAND button repeatedly to select FM1, FM2, FM3, AM1, AM2. Display will show the wave band, frequency and preset station number if already stored. To select a band you can also press BND button on the touchable screen. Note: Please don't switch the band quickly, otherwise, you will see there is
Summary of the content on the page No. 19
V-AVD99 Store function You can store up to a total of 30 radio stations in the memory (18 FM, 12 AM). To store a station: - Select a band (if needed) - Select a station with CH+/- buttons on the RC. - Press and hold for 3 seconds a number button (1-6) on the RC or press the corresponding station button on the touchable screen, under which you want to store the station. To recall a station: - Select a band (if needed) - Press a number button (1-6) briefly to recall the stored station or press t
Summary of the content on the page No. 20
V-AVD99 PTY (Program Type) function Press PTY button on the touchable screen to turn the PTY function on. Press these buttons to select a program type. 2 seconds later the unit will automatically search a broadcasting station of such program type. Notes: When PTY is selected, the radio starts to search corresponding PTY information and stops of the corresponding PTY information is detected. If corresponding PTY information is not found, normal radio reception is resumed. AF (Alternative Freque
