Dakota Digital HLY-2000 user manual

Summary of the content on the page No. 1

Dakota Digital
SERIES II
VFD DIGITAL INFORMATION SYSTEM
The latest in digital technology for the
motorcycle enthusiast.
INSTALLATION AND OPERATION MANUAL
Please read this before beginning installation or wiring.
MODEL HLY-2000
SPEEDOMETER/TACHOMETER
INFORMATION SYSTEM
Dakota Digital
FAX: (605) 339-4106
Phone: (605) 332-6513
Falls, SD 57107 Sioux
3421 W. Hovland Ave.

Summary of the content on the page No. 2

POWER GROUND SPEEDOMETER SPEEDOMETER CALIBRATION adjustments are made for 7-10 seconds. Once the speedometer is reading correct release the function switch. The new calibration will be saved if no 7. speed reading will begin decreasing until it is released. next time the function switch is pressed, the speed reading will begin increasing until the function switch is released. The Press the function switch. The 6. Drive at a known speed. Following another ve

Summary of the content on the page No. 3

TACHOMETER tACH”. TACHOMETER RED LINE/SHIFT INDICATOR TURN SIGNAL & HIGH BEAM INDICATORS Beam TRIP ODOMETER The goes on the inside and the sealed switch cap attaches from the outside. trip reset handle was on your original speedometer. The function switch be mounted into the hole where the The sealed push button function switch supplied with the system will operate the trip odometer. It can reset the trip odometer. The trip odometer will read from 0 to 999.9 m

Summary of the content on the page No. 4

NEUTRAL INDICATOR NIGHT DIMMING LOW OIL PRESSURE AND LOW VOLTAGE INDICATORS TURN SIGNAL CANCEL OUTPUT WIRING YELLOW BROWN speed/tach system. The sensor needs to be mounted within 1/8” of the teeth on a final drive gear. The gear-tooth sensor kit consists of a two-terminal sensor and a harness to connect it to the the in-line connector on the speed/tach system. The adapter harness for using a stock transmission speed sensor converts the triangular connector to have the cable modified or replaced

Summary of the content on the page No. 5

WARRANTY For warranty coverage, you must first call to receive an RMA#. SERVICE AND REPAIR A return authorization number (RMA#) for products being return for repair is required. Dakota Digital FAX: (605) 339-4106 Phone: (605) 332-6513 Falls, SD 57107 Sioux 3421 W. Hovland Ave. Do not send any money. We will bill you for the repair charges. telephone number where you can be reached during the day. your RMA#, a complete description of the problem, your full name and address (street address

Summary of the content on the page No. 6

Speed Sensor Attach the foam tape Connector to the case just below Cable Driven the chrome bezel. Speed Sensor Rubber Mounting Studs Main Harness Connector Connector Main Harness Mounting Brackets Harness Adapter Speed Sensor Connector Speed Sensor sensor. Mounting hardware and speed sensor connection for the clip-in system with an electric, transmission speed Mounting hardware and speed sensor connection for the bolt-in system with a speedometer cable. the clip in style. bolt-in. The ru