Summary of the content on the page No. 1
R
OWNER’S MANUAL
32” TFT LCD DIGITAL TV WITH DVD PLAYER
HDLCDVD325
TV/CABLE MODE SELECTION
When shipped from the factory, the TV/CABLE menu option is set to the “CABLE” (Cable Television) mode.
If not using CABLE, set this menu option to the “TV” position.
IF CONTACT WITH CUSTOMER SERVICE IS REQUIRED
PLEASE HAVE THE MODEL NUMBER READY PRIOR TO THE CALL
CUSTOMER SERVICE – 1-800-289-0980
ORION WEBSITE
FOR INFORMATION ON OUR OTHER PRODUCTS, PLEASE VISIT OUR WEBSITE AT
www.orionsalesinc.com
Before o
Summary of the content on the page No. 2
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. CAUTION: TO REDUCE THE RISK OF ELECTRIC The exclamation point within an SHOCK, DO NOT REMOVE COVER equilateral triangle is intended to alert the user to the presence of important (OR BACK). NO USER-SERVICEABLE operating and maintenance (ser
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions. 2) Keep these instruction. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the groun
Summary of the content on the page No. 4
SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunshine. When placing on a shelf leave 10 cm (4 inches) free space around the entire unit. 10cm Notes when mounting the LCD TV/DVD on a wall • When installing the unit on a wall, allow at least 6 cm (2 1/2 inches) clearance between the rear of the LCD TV/DVD and the wall. Clear
Summary of the content on the page No. 5
Features LCD color TV With DVD/CD player Unique space saving design combines a 32” LCD color TV and a DVD/CD player. A DVD disc has much more capacity, but is the same size as an audio CD disc. The Picture/Audio quality of a DVD exceeds other software. The picture quality is higher than Super VHS video cassettes. The audio quality is higher than an audio CD. The DVD also has special options; audio language selection, subtitle language selec- tion, or multi-angle, etc. The DVD PLAYER can play bac
Summary of the content on the page No. 6
Contents Playback operation Before using your unit Preparation.................................................38 IMPORTANT SAFETY INSTRUCTIONS .....3 SAFETY PRECAUTIONS ............................4 Status display of disc .................................38 IMPORTANT NOTICE .................................4 Playback procedure ...................................39 Features .......................................................5 Special playback ........................................40 Conten
Summary of the content on the page No. 7
Disc Playable discs Disc type and logo mark content CAUTION: • Only the left types of discs can be played on this unit. Audio DVD-ROM, CD-ROM, SVCD, CVD, VCD, etc. cannot be + played. Video DVD Video • 8cm discs can be played directly. If an 8cm disc adapter is (moving used it will cause errors. pictures) • If you insert an irregular shaped disc, it may get stuck and cause a malfunction. Audio CD-DA • The use of a ring protector or other disc accessories will cause errors. • This unit is to be u
Summary of the content on the page No. 8
Location of controls Top POWER button EJECT button SKIP buttons INPUT button MENU button STOP button VOLUME UP/DOWN buttons PLAY button CHANNEL UP/DOWN buttons Front Remote sensor POWER indicator Left Side Right Side DISC slot Headphone jack S-VIDEO AUDIO (L/R)/VIDEO IN (VIDEO2) jacks 8 5X10101A[EN] P05-12 8 3/2/06, 4:01 PM
Summary of the content on the page No. 9
Location of controls (continued) Rear CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: SHOCK HAZARD-DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. S-VIDEO IN (VIDEO2) jack VIDEO/AUDIO (L/R) IN (VIDEO2) jacks RF (ANT) IN jack VARIABLE AUDIO AC IN socket COMPONENT AUDIO (L/R) IN jacks (L/R) OUT jacks HDMI IN jack COMPONENT (Y, PB, PR) IN jacks COAXIAL DIGITAL HDMI AUDIO (L/R) IN jacks AUDIO OUT jack S-VIDEO IN (VIDEO1) jack VIDEO/AUDIO (L/R) IN (VIDEO1) jacks Variable TV-screen ang
Summary of the content on the page No. 10
Remote control Page POWER Power On/Off 14,15,38,39 DISPLAY Call TV information 16,20 Call DVD information 38 TV/DVD Switch between TV/AV and DVD 14,38,39 5 (EJECT) Eject a disc 39,56 0-9 Direct channel selection of TV 15 Input setting 23,26,41,42,45,47 Enter a password 19~21,54~56 VOL +/– Adjust volume of TV 15,16 MUTE Switch off the sound 16,20 SLEEP Sleep timer 16 SETUP/TV MENU TV mode - Display menu of TV 14,17~26,28~37 DVD mode - Call up initial setup mode 43,44,51~55,57 DVD MENU Display DVD
Summary of the content on the page No. 11
Remote control (continued) Inserting Batteries Open the battery compart- Install two “AAA” batteries Replace the compartment 1 23 ment cover in the direction of (supplied), paying attention to cover. the arrow. the polarity diagram in the battery compartment. Operation • Aim the remote control at the remote sensor and press control buttons to operate. • Operate the remote control within a 30° angle on either side of Approximately 15 feet the remote sensor, up to a distance of approximately 15 fe
Summary of the content on the page No. 12
Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see page 13 for Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) Connect the 75 ohm cable from the combination Antenna Antenna VHF/UHF antenna to the antenna jack. Jack Jack If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the use of the 300-75 ohm matching tr
Summary of the content on the page No. 13
Cable TV connections This TV/DVD has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company. FOR SUBSCRIBERS TO BASIC CABLE TV SERVICE Antenna For basic Cable TV service not requiring a Converter/ Jack Descrambler box, connect the 75 ohm
Summary of the content on the page No. 14
Setting the on-screen display language You can choose from three different 1 Press POWER to turn on the unit. languages (English, French and Spanish) for the on-screen displays. 2 Press TV/DVD to select the TV mode. Press SETUP/TV MENU. The TV menu screen will appear. 3 4 Press or to select (SETUP) menu. SETUP LANGUAGE ENGLISH CLOCK SET TV/CABLE CABLE AUT O C H MEMOR Y ADD/DELETE :SELECT :ADJUST 5 Press or to select “LANGUAGE”. SETUP LANGUAGE ENGLISH ENGLISH / FRAN AIS / ESPA OL CLOCK SET
Summary of the content on the page No. 15
TV operation 1 To turn on the unit, press POWER. 2 Adjust the volume level by pressing VOL + or – . The volume level will be indicated on the screen by white bars. As the volume level increases, VOLUME 32 so do the number of bars. If the volume decreases, the number of white bars also decreases. Set the TV/CABLE menu 3 TV - VHF/UHF channels option to the appropriate CABLE - CABLE TV channels position (see page 17). Press the Direct Channel Selection 4 buttons to select the channel. ANT TO SELECT
Summary of the content on the page No. 16
TV operation (continued) CH / Press and release CH or . The channel automatically stops at the next channel set into memory. For proper operation, before selecting ANT ABCD channels, they should be set into the memory. 12 See pages 17 and 18 “Memorizing channels”. DISPLAY Press DISPLAY to display the current information on the screen. When the TV receives a digital signal, press SUN Jan 01 12:00 PM once, the digital information will appear. 51-3 Moon Star CITYHD Remaining Time 0:20 TV-Y7 En
Summary of the content on the page No. 17
Memorizing channels This TV/DVD is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV/DVD’s memory. This TV can receive up to 250 VHF/UHF channels and 500 cable TV channels. To use this TV/DVD with an antenna, set the TV/CABLE menu option to the TV mode. When shipped from the factory, this menu option is in the CABLE mode. TV/CABLE sele
Summary of the content on the page No. 18
Memorizing channels (continued) Automatic memory tuning Press SETUP/TV MENU in the TV mode. 1 The TV menu screen will appear. 2 Press or to select (SETUP) menu, then press or SETUP to select “AUTO CH MEMORY”. LANGUAGE ENGLISH CLOCK SET TV/CABLE CABLE AUTO CH MEMORY ADD/DELETE :SELECT :ADJUST 3 Press or . The unit will begin memorizing all the channels AUTO CH MEMORY available in your area. EXIT : CANCEL Depending on the reception PROGRAMMING NOW condition, it may take PLEASE WAIT a
Summary of the content on the page No. 19
Setting the V-Chip An age limitation can be set to restrict children from viewing or hearing violent scenes or picture that you may choose to exclude. The restriction applies to “TV RATING” and “MOVIE RATING” if this data is transmitted. You may set this restriction separately. To use the V-Chip function, you must register a password. To register password 1 Press SETUP/TV MENU in the TV mode. The TV menu screen will appear. 2 Press or to select (LOCKS) menu. LOCKS V-CHIP SET NEW PASSWORD :
Summary of the content on the page No. 20
Setting the V-Chip (continued) To set the V-Chip Press SETUP/TV MENU in the TV 1 mode. LOCKS V-CHIP SET Then press or to select NEW PASSWORD (LOCKS) menu. :SELECT :ADJUST 2 Press or to display the password entering mode. Use LOCKS PASSWORD Number buttons (0-9) to enter your password, then press ENTER. The LOCKS menu appears. [0-9] : SELECT ENTER : SET EXIT : END 3 Press or to select “TV RAT- ING”. Then press or to display LOCKS V-CHIP SET the desired rating. V-CHIP OFF TV R