Summary of the content on the page No. 1
INSTALLATION AND OPERATION MANUAL
Version 08/04
© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved.
Summary of the content on the page No. 2
WARNINGS AND NOTICES NOTICE This game is intended to be operated for amusement purposes only. It is not to be operated in violation of any federal, state, or local laws or regulations. As the owner and/or operator of this game you are responsible for its operation in compliance with such laws and regulations. The factory settings for this game may require adjustment in order to comply with the laws and/or regulations in the jurisdiction where the game is located. It is the sole responsibi
Summary of the content on the page No. 3
Congratulations! Congratulations on purchasing Silver Strike Bowling from Incredible Technologies! For ease of use this manual has been broken down into four main sections: Installing Silver Strike Bowling as a Kit - Page 3. Silver Strike Bowling as a Dedicated game - Page 17. Operator Menus - Page 21. Troubleshooting and Reference - Page 39. A more complete table of contents can be found on the next page. Silver Strike Bowling Features Ø Up To 8 Players Can Play Together ?
Summary of the content on the page No. 4
TABLE OF CONTENTS CONTENTS PAGE CONTENTS PAGE WARNINGS AND NOTICES (Inside Cover) I Hardware Tests 28 FEATURES 1 Hardware/Software 28 TABLE OF CONTENTS 2 System Info 28 KIT INSTALLATION SECTION 3 USB Info 29 Kit Package Contents 4 Version Info 29 Recommended Tools 6 Check Hard Drive 29 Installation Preparation 6 Check Cooling 30 THE CABINET 7 Silver Strike Settings 30 Cabinet Selection 7 Player Cost Schedule 31 Preparing the Cabinet for Installation 7 Value
Summary of the content on the page No. 5
Silver Strike Bowling Kit Installation Silver Strike Bowling™ Version 08/04 Page 3 © Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law. All other marks are the properties of their respective owners. All rights reserved.
Summary of the content on the page No. 6
Kit Contents (Including Part Numbers) Please refer to these IT part numbers when placing orders. Included in the Silver Strike Bowling Kit (Part # 925000265) should be the following: A bag of parts is included in your kit and the contents can be found on the next page. Silver Strike Bowling™ Version 08/04 Page 4 © Copyright 2004 Incredible Technologies, Inc. All Rights Res
Summary of the content on the page No. 7
Kit Contents (Including Part Numbers) - Continued Please refer to these IT part numbers when placing orders. Keep in mind most of these basic parts like screws/washers can be found at any hardware store. Your bag of parts (Part # 900265030) should include (at least): NOTE: PLEASE RETAIN ORIGINAL SHIPPING BOX FOR SERVICE AND REPAIR. NOTE This kit is designed for use in cabinets with JAMMA cable and wiring installed. If you do not have a JAMMA harness already installed in t
Summary of the content on the page No. 8
Recommended Tools Have the following tools ready before you begin to install this kit: q ¼" Nut Driver q 7/16" Socket or Driver q 11/32" Socket q Phillips Head #2 Screw Driver q 9/32" Drill OR 5/16" and ¾" Drill Bits q 1 1/8" Hole Saw or Drill Bit q Small Flat Blade Screwdriver q Jig/Sabre Saw q Router q Push Button Nut Socket or Large Adjustable Pliers q X-acto® Knife or other Sharp Knife/Razor Blade q Wire Cutters q Scissors q Tape Measure q Putty Knife q Decal Roller/Squee
Summary of the content on the page No. 9
The Cabinet Cabinet Selection You can choose either a new cabinet or a used cabinet for your Silver Strike Bowling game. Reusing a cabinet is by far the most cost-effective way to maximize the return on your initial investment. In either case, all you need to provide is the cabinet with a monitor, JAMMA harness, coin and bill acceptors, working fluorescent/marquee lights, and speakers. We provide the rest. The end result is a new game at a very low cost. When selecting a cabinet, kee
Summary of the content on the page No. 10
Game Electronics I/O Board Installation NOTE: Before installing any electronics make sure cabinet power switch is in the OFF position and the cabinet power is unplugged from the wall. Silver Strike Bowling comes with a specially designed I/O board that works with your cabinet's already installed JAMMA harness. The I/O board is used as a connection interface between the JAMMA and the Nighthawk Chassis. Refer to the diagram on page 9. 1. Mount the I/O board into the cabinet using 6
Summary of the content on the page No. 11
Please refer to the following diagram as well as a detailed diagram on page 45 for correct placements when connecting cables to the I/O board: Additional Instructions For Low or Medium Resolution Monitors: To connect to a low or medium resolution RGB monitor refer to the figure below: 1. Connect one end of the 6 ft. SVGA video cable to the video out of the Nighthawk Chassis. 2. Connect the other end of the 6 ft. SVGA cable to the I/O board video in J501. 3. Connect the Red, Green,
Summary of the content on the page No. 12
Nighthawk Chassis Installation The Nighthawk Chassis houses most of the game electronics and hardware into one box that can be easily installed. Verify that the Nighthawk Chassis Power Switch is in the "ON" position. 1. Locate the area on the floor where the chassis will be placed. Make sure there is enough clearance to plug in cables. q The Nighthawk Chassis measures 19" W x 7" H x 11" D. 2. Relocate and secure any wires to make room for the chassis. 3. Place the chassis so it sit
Summary of the content on the page No. 13
Cabinet Identification Device Installation The Cabinet Identification Device or C.I.D. is an innovative and important component. This device permanently identifies your cabinet as Silver Strike Bowling. It should remain even if another component such as the I/O board or chassis is replaced. The C.I.D. has a unique number to individualize the cabinet and is referred to as the Cabinet Identification Number. 1. Attach the C.I.D. to the inside side of the cabinet using the 2 - #6 X 1” H
Summary of the content on the page No. 14
Trackball Preparation Install the metal trackball plate by following these steps: 1. Cut out the template (see template-page 49) with a pair of scissors along the noted line. Tape this template to the top of the control panel as far away from the monitor as possible, making sure that the trackball will clear the cabinet beneath it. NOTE: Installing the trackball as far away from the monitor as possible will prevent players' hands from hitting the monitor glass when rolling the trackball
Summary of the content on the page No. 15
Control Panel Overlay Installation - Continued 5. While holding down the overlay over the attached area, very carefully turn over one side and remove the exposed backing. Gently lay down the exposed overlay from the center outward, smoothing with your hands or a roller as you go. Be sure the overlay remains straight and square. Repeat the process with the other side of the overlay, so the entire surface is affixed to the control panel. Make sure all bubbles have been pressed out for a
Summary of the content on the page No. 16
Finishing The Kit Side Decals and Marquee Included with your Silver Strike Bowling kit is a set of decals to place on the side of your cabinet and a brand new marquee. This will help identify your new game as Silver Strike Bowling. By placing and installing these correctly it can help give players instant recognition, even from a distance. Side Decal Installation The following are the instructions on placing your side decals correctly on to the cabinet: 1. Locate the place where
Summary of the content on the page No. 17
Dip Switch Settings SW202 Dip Switch Settings 0 = OFF 1 = ON Positions Function 4 3 2 1 0 0 0 0 Default 1 0 0 0 Enter Operator Mode Menus SW200 Dip Switch Settings 0 = OFF 1 = ON Position Function 4 3 2 1 1 1 1 1 Default - Switch Is Not Used SW201 Video Dipswitch Settings 0 = OFF 1 = ON Position Video Resolution Scan Rate Monitor Video connection 4 3 2 1 Mode 0 0 0 1 1 6
Summary of the content on the page No. 18
Silver Strike Bowling™ Version 08/04 Page 16 © Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law. All other marks are the properties of their respective owners. All rights reserved.
Summary of the content on the page No. 19
Silver Strike Bowling Dedicated Version Silver Strike Bowling™ Version 08/04 Page 17 © Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law. All other marks are the properties of their respective owners. All rights reserved.
Summary of the content on the page No. 20
Dedicated Cabinets Dedicated Contents (1) Silver Strike Bowling Dedicated Cabinet (1) Silver Strike Bowling Manual (1) Monitor Manual (1) 4 Leg Levelers (1) Security Bar If any parts to your dedicated cabinet are missing/damaged please contact IT's Technical Support at 847-870-7027 x121. The Cabinet NOTE: Diagrams for the Nighthawk Chassis and the dedicated I/O Board can be found on page 44. Volume and Test Switches Your cabinet comes equipped with a bank of buttons
