Summary of the content on the page No. 1
Stainless Steel Gas Grill
USE AND CARE GUIDE
MODEL NO.: 720-0289
® ®
FOR OUTDOOR USE ONLY
K15Y06P-1
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Summary of the content on the page No. 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions…………………………2~6 Using the side burner…………………… Placement of the grill………………………6 19 Care & Maintenance ………………. 19 Trouble Shooting………………………… SECTION TWO 20~22 Side shelf Assembly………………………7 SECTION SIX Side shelf handle Assembly………………..8 Exploded View…………………………….. 23 Battery assembly……………………………9 Parts List ………………………………….. 24 Condiment assembly……………………… 9 Grilling Hints…
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS ***** WARNING ***** FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open Lid. 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be
Summary of the content on the page No. 4
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING DO NOT USE ALUMINUM FOIL TO LINE Do not try lighting this appliance without first THE GRILL RACKS OR GRILL BOTTOM. reading the “LIGHTING INSTRUCTIONS” section This can severely upset combustion airflow or of this manual. trap excessive heat in the control area. Gas Installation Codes INSECT WARNING!!! Spiders and insects can nest A statement that the installation must conform with in the burners
Summary of the content on the page No. 5
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING: Always keep your face and body as far away from the burner as possible when lighting. WARNING: IMPORTANT! BEFORE LIGHTING… Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present. Only the pressure regulator and hose assembly supplied with the unit should be used. Never sub
Summary of the content on the page No. 6
SAFETY INSTRUCTIONS CHILDREN SHOULD NOT BE LEFT ALONE OR TESTED IN ACCORDANCE WITH ANSI Z21.58a • UNATTENDED IN AN AREA WHERE THE GRILL IS CSA 1.6a-2006 STANDARD FOR OUTDOOR BEING USED. NEVER ALLOW THEM TO SIT, COOKING GAS APPLIANCES. THIS GRILL IS STAND OR PLAY ON OR AROUND THE GRILL AT FOR OUTDOOR USE ONLY. ANY TIME. Check your local building codes for the proper DO NOT STORE ITEMS OF INTEREST TO method of installation. In the absence of local CHILDREN AROUND O
Summary of the content on the page No. 7
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, burner under unprotected combustible construction. Use only in well grate or immediate surroundings as these areas become ventilated areas. Do not use in buildings, garages, sheds, extremely hot and could cause burns. Use only dry breezeways or other such enclosed areas. THIS UNIT IS FOR potholders. Moist or damp potholders on hot surfaces OUTDOOR USE ONLY. may cause burns from steam. Do not use a towel or bulky
Summary of the content on the page No. 8
SIDE SHELF ASSEMBLY 1. The screws used to attach the side shelf are already screwed into the left side burner And right side panel(see the figure below).loosen the screws from the left side burner And right side panel, install the side shelves and tighten screws as the figure show below. Attention: The left side shelf should be screwed from outside into inside with 4pcs screws, the right side shelf should be screwed: a. the upper 2 screws to the right panel should be screwed from in
Summary of the content on the page No. 9
SIDE SHELF HANDLE ASSEMBLY 1. The screws used to attach the side shelf handle are already screwed into the side shelf handle(see the figure below).loosen the screws from the side shelf handle, align with the holes in the side shelf, and secure into the holes on the right side shelf of the grill. K15Y06P-1 8
Summary of the content on the page No. 10
BATTERY ASSEMBLY In order to install the battery, remove the ignition button housing. Please keep the positive pole of the battery facing toward you. Insert the battery into the housing. Replace the ignition button housing after battery is installed. CONDIMENT RACK ASSEMBLY Assemble the condiment rack inside of the left door. 9 K15Y06P-1
Summary of the content on the page No. 11
CLOSE PROPANE TANK ASSEMBLY 1. Attach regulator to the propane tank by turning the regulator handle clockwise (FIGURE 1). 2. Turn off LP supply at cylinder when appliance is not in use. g 1. Put the gas tank into the gas tank tray. Then tighten up the gas tank retention kit for fixing the gas tank as shown in the figure 1 below. 2. Here are two buttons “A” and “B” on gas tank tray, the “B” button is fix the gas tank tray, if you want to pull the gas tan
Summary of the content on the page No. 12
TO MATCH LIGHT THE GRILL 1. If the burner will not light after several attempts then the burner can be match lit. 2. If you’ve just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the HI setting, continue to press the knob until the burner ignite
Summary of the content on the page No. 13
GAS HOOK-UP Only the pressure regulator and hose assembly supplied LP Gas Cylinder must be fitted with Overfill Protection Device with the grill should be used. Any replacement pressure, (OPD). regulator and hose assembly must be specified by the grill manufacturer. LP GAS HOOK-UP: This is a liquid propane configured grill. Ensure that the black plastic grommets on the LP cylinder Do not attempt to use a natural gas supply unless the grill valve are in place and that the
Summary of the content on the page No. 14
PRECAUTIONS • Never store an LP gas tank indoors. If you store your gas A tank of approximately 12 inches in diameter by 18-1/2 inches grill in the garage or other indoor location, always high is the maximum size LP gas tank to use. You must use an disconnect the LP gas tank first and store it safely outside. OPD gas tank which offers an Overfill Prevention Device. This safety feature prevents the tank from being overfilled which can cause malfunction of the LP gas tank, regulator and
Summary of the content on the page No. 15
LEAK TESTING GENERAL Gas flow check: Although all gas connections on the grill are leak tested at Each grill burner is tested and adjusted at the factory prior to the factory prior to shipment, a complete gas tightness shipment; however, variations in the local gas supply may make check must be performed at the installation site due to it necessary to adjust the burners, the flames of the burners possible mishandling in shipment, or excessive pressure should be visually checke
Summary of the content on the page No. 16
INSTALLER FINAL CHECK Specified clearance maintained 24” from Unit tested and free of leaks. combustibles. User informed of gas supply shut off valve All internal packaging removed. location. Knobs turn freely. Burners are tight and sitting properly on orifices. PLEASE RETAIN THESE INSTRUCTIONS FOR Pressure regulator connected and set for 11.2” W.C. LP gas. Gas connections to grill using FUTURE REFERENCE. hose & regulator assembly provided (pre-set for 11.0” water c
Summary of the content on the page No. 17
OPERATING INSTRUCTIONS General use of the grill and rotisserie The skewer for the rotisserie is assembled into the motor Each main burner is rated at 10,000 BTU/hr. The main grill assembly by placing the pointed end into the motor, and burners encompass the entire cooking area and are side then sliding the grooved bushing into the slot at the ported to minimize blockage from falling grease and debris. opposite side of the grill. The thumbscrew for the grooved Above the burners are sta
Summary of the content on the page No. 18
LIGHTING INSTRUCTIONS WARNING: IMPORTANT! BEFORE LIGHTING… Approximate Inspect the gas supply hose prior to turning the gas 1 1/2“ Flame “ON”. If there is evidence of cuts, wear, or abrasion, it Height must be replaced prior to use. Do not use the grill if the odor of gas is present. Only the pressure regulator and hose assembly supplied with the unit should be these conditions exist call our customer service line. If used. Never substitute regulators for th
Summary of the content on the page No. 19
LIGHTING ILLUSTRATIONS Main& side burner lighting illustration Rotisserie & Searing burner lighting illustration Step to light the rotisserie burner: Push and turn the rotisserie knob to ”IGNITE/ON” Step 1: Make sure the lid is open. position and hold for 3~4 seconds, then push electronic ignition button at the same time until burner Step to light the searing burner: Step 2. Push and turn main or side burner knobs Push and turn the searing
Summary of the content on the page No. 20
USING THE SIDE BURNER control knob counterclockwise to the “HI” position. If WARNING: IMPORTANT! the burner does not light, turn the control knob to USING THE SIDE BURNER: “OFF”. If the smell of gas is detected and the igniter is Inspect the gas supply hose prior to turning the gas not functioning, immediately turn the control knob “ON”. If there is evidence of cuts, wear or abrasion, “OFF”. Allow 5 minutes for any accumulated gas to it must be replaced prior to use. Do not use t
