Sanus Systems NFCD user manual

Summary of the content on the page No. 1

Assembly Instructions for Model: NFCD
Thank you for choosing a Sanus Systems Natural Media Tower. The Model
NFCD is designed to keep your collection clean and organized by storing up to
430 CDs or 230 DVDs, all in one convenient location.
If you do not understand these directions, please contact Sanus at 800.359.5520
or www.sanus.com. Check carefully to make sure that there are no missing or
defective parts. Our customer service representatives can quickly assist you
with assembly question

Summary of the content on the page No. 2

Supplied Hardware: (Full Size) Cam - H Cam Pin - I Plastic Dowel - J Qty. 4 Qty. 4 Qty. 4 Machine Screw - K Wood Screw - L Shelf Pin - M Qty. 4 Qty. 4 Qty. 56 Step 1 - Attach Feet to NFCD Base Insert a Machine Screw (K) into each Foot (C); then using the regular screwdriver, attach the Feet to the NFCD Base (B). Diagram 1 B C C C K K C K K Step 2 - Insert Cam Pins into Side Panels There are two holes that are centered on each side of the Side Panels (E), and 12” [304.3 mm] from each end. Using

Summary of the content on the page No. 3

Step 3 - Insert Cam into Center Support. Place a Cam (H) into each of the four holes in the Center Support (D) NOTE: Each Cam has an arrow on it. Using a phillips screwdriver align each Cam so the arrow is pointing toward the small hole on the edge of the Center Support (See Detail - A). Diagram 3 Cam - H Small Hole D Cam Hole Cam - H Small Hole Detail - A Step 4 - Secure Side Panels to Center Support. The Cam Pins (I) installed in each Side Panel (E) line up with the small holes in the edg

Summary of the content on the page No. 4

Step 5 - Attaching NFCD Top Panel Stand the unit up so that the notched bottom of each Side Panel is facing down and the smooth top edge is facing up. Tap a Plastic Dowel Pin (J) into the holes in the top edge of each Side Panel (E); then, align the holes of the NFCD Top (A) with the Dowel Pins and the slot across the NFCD Top with the Center Support (D). Firmly press the NFCD Top onto the Dowel Pins and Side Panels, until it is firmly seated. NOTE: Once the NFCD Top is attached, it may not

Summary of the content on the page No. 5

Step 7 - Installing Glass Shelves Stand the NFCD Media Tower upright. Place the Shelf Pins (M) into holes in the Side Panels where you want the Glass Shelves (F) to be located. Each Glass Shelf requires four shelf Pins. Place the Glass Shelves (F) in the NFCD Media Tower. Diagram 7 M F Step 8 - Attach Name Plate Attach the Sanus Name Plate (G) In the desired location. Diagram 8 G Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02.28.06 (100028) Customer Service: 800.359.5520. See com