Summary of the content on the page No. 1
TOSHIBA Satellite A100/
Satellite Pro A100
Portable Personal Computer
User’s Manual
i
Summary of the content on the page No. 2
Copyright © 2006 by TOSHIBA Corporation. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form without the prior written permission of TOSHIBA. No patent liability is assumed, with respect to the use of the information contained herein. TOSHIBA Satellite A100/Satellite Pro A100 Portable Personal Computer User’s Manual First edition December 2005 Copyright authority for music, movies, computer programs, data bases and other intellectual property covered
Summary of the content on the page No. 3
TruSurround XT, WOW HD, Circle Surround Xtract, TruBass, SRS 3D , Defini- tion and FOCUS technologies are incorporated under license from SRS Labs, Inc. InterVideo and WinDVD are registered trademarks of the InterVideo Inc. WinDVD Creator is trademarks of the InterVideo Inc. Other trademarks and registered trademarks not listed above may be used in this manual. Macrovision License of Notice This product incorporates copyright protection technology that is protected by methods and claims of ce
Summary of the content on the page No. 4
❑ Use only the AC adapter and batteries that are approved for use with this computer. Use of another type of battery or AC adapter may risk fire or explosion. ❑ Before you connect the computer to a power source, ensure that the voltage rating of the AC adapter matches that of the available power source. 115 V/ 60 Hz in most of North and South America and some Far Eastern countries such as Taiwan. 100 V/50 Hz in eastern Japan and 100 V/60 Hz in western Japan. 230 V/50 Hz in most of Europe, t
Summary of the content on the page No. 5
❑ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ❑ Consult the dealer or an experienced radio/TV technician for help. WARNING: Only peripherals complying with the FCC class B limits may be attached to this equipment. Operation with non-compliant peripherals or peripherals not recommended by TOSHIBA is likely to result in inter- ference to radio and TV reception. Shielded cables must be used between the external devices and the comput
Summary of the content on the page No. 6
BSMI Notice (Taiwan Only) EU Declaration of Conformity TOSHIBA declares, that the product: Satellite A100/Satellite Pro A100 con- forms to the following Standards: Supplementary Information: “The product complies with the requirements of the Low Voltage Directive 73/23/EEC, the EMC Directive 89/336/EEC and/or the R&TTE Directive 1999/05/EEC.” This product is carrying the CE-Mark in accordance with the related European Directives. Responsible for CE-Marking is TOSHIBA Europe, Hammfelddamm 8,
Summary of the content on the page No. 7
This Class B digital apparatus meets all requirements of the Canadian Interfer- ence-Causng Equipment Regulations. Cet appareil numérique de la class B respecte toutes les exgences du Règlement sur le matériel brouileur du Canada. Modem warning notice Conformity Statement The equipment has been approved to [Commission Decision “CTR21”] for pan- European single terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences between the individual PSTNs provided
Summary of the content on the page No. 8
Japan regulations Region selection If you are using the computer in Japan, technical regulations described in the Telecommunications Business Law require that you select the Japan region mode. It is illegal to use the modem in Japan with any other selection. Redial Up to two redial attempts can be made. If more than two redial attempts are made, the modem will return Black Listed. If you are experiencing problems with the Black Listed code, set the interval between redials at one minute or
Summary of the content on the page No. 9
If you have any questions about your telephone line, such as how many pieces of equipment you can connect to it, the telephone company will provide this infor- mation upon request. Telephone company procedures The goal of the telephone company is to provide you with the best service it can. In order to do this, it may occasionally be necessary for them to make changes in their equipment, operations, or procedures. If these changes might affect your service or the operation of your equipment,
Summary of the content on the page No. 10
Instructions for IC CS-03 certified equipment 1 The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protec- tive, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user’s satisfaction. Before installing this equipment, users should ensure that it is permissible to
Summary of the content on the page No. 11
Notes for Users in Australia and New Zealand Modem warning notice for Australia Modems connected to the Australian telecoms network must have a valid Austel permit. This modem has been designed to specifically configure to ensure com- pliance with Austel standards when the country/region selection is set to Austra- lia. The use of other country/region setting while the modem is attached to the Australian PSTN would result in you modem being operated in a non-compliant manner. To verify that t
Summary of the content on the page No. 12
❑ Some parameters required for compliance with Telecom’s PTC Specifica- tions are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliance with Telecom Specifications: (a) There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and (b) The equipment shall go on-hook for a period of not less than 30 seconds between the end of
Summary of the content on the page No. 13
❑ The transmit level from this device is set at a fixed level and because of this there may be circumstances where the performance is less than optimal. Before reporting such occurrences as faults, please check the line with a standard Telepermitted telephone, and only report a fault if the phone perfor- mance is impaired. ❑ It is recommended that this equipment be disconnected from the Telecom line during electrical storms. ❑ When relocating the equipment, always disconnect the Telecom line
Summary of the content on the page No. 14
Following information is only for EU-member states: The symbol indicates that this product may not be treated as household waste. Please ensure this product is properly disposed as inappropriate waste handling of this product may cause potential hazards to the environment and human health. For more detailed information about recycling of this prod- uct, please contact your local city office, your household waste disposal service or the shop where you purchased the product. This symbol may
Summary of the content on the page No. 15
ment, transmission and disposition may be subject to claims for damages and penalties. ❑ Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. ❑ Do not use the telephone to report a gas leak in the vicinity of the leak. ❑ Use only the power cord indicated in this manual. ❑ Replace only with the same or equivalent type battery recommended by the manufacturer. ❑ Dispose of used batteries according to the man
Summary of the content on the page No. 16
CD-RW/DVD-ROM drive safety instructions CAUTIONS: 1. The drive employs a laser system. To ensure proper use of this product, please read this instruction manual carefully and retain for future reference. Should the unit ever require maintenance, contact an authorized service location. 2. Use of controls, adjustments or the performance of pro- cedures other than those specified may result in hazard- ous radiation exposure. 3. To prevent direct exposure to the laser beam, do not try to open t
Summary of the content on the page No. 17
Toshiba Samsung TS-L462C Location of the required label PRODUCT IS CERTIFIED BY THE MANUFACTURER TO COMPLY WITH DHHS RULES 21 CFR SUBCHAPTER J APPLICABLE AT THE DATE OF MANUFACTURE. MANUFACTURED: TOSHIBA SAMSUNG STORAGE TECHNOLOGY CORPORATION 580, HORIKAWA-CHO, SAIWAI-KU, KAWASAKI-SHI, KANAGAWA, 212- 0013, JAPAN HLDS GCC-4244A Location of the required label COMPLIES WITH FDA RADIATION PERFORMACE STANDARS, 21C CFR SUBCHAPTER J, MANUFACTURED: HITACHI-LG Data Storage 20, YOIDO-DONG, YOUNG
Summary of the content on the page No. 18
DVD Super Multi (+-R Double Layer) drive safety instructions CAUTIONS: 1. The drive employs a laser system. To ensure proper use of this product, please read this instruction manual carefully and retain for future reference. Should the unit ever require maintenance, contact an authorized service location. 2. Use of controls, adjustments or the performance of pro- cedures other than those specified may result in hazard- ous radiation exposure. 3. To prevent direct exposure to the laser beam,
Summary of the content on the page No. 19
TEAC DV-W28EB Location of the required label CERTIFICATION TISH PRODUCT COMPLIES WITH DHHS RULES 21 CFR CHAPTER 1, SUBCHAPTER J APPLICABLE DATE OF MANUFAC- TURE MANUFACTURED: TEAC CORPORATION 3-7-3 NAKA-CHO, MUSASHINO-SHI, TOKYO, JAPAN HDLS GMA-4082N Location of the required label COMPLIES WITHFDA RADIATION PERFORMANCE STANDARDS, 21 CFR SUBCHAPTER J. MANUFACTURED: Manufactured by Panasonic Communications Co., LTD 1-62, 4-Chome, Minoshima, Hakata-ku, Fukuoka, JAPAN xix
Summary of the content on the page No. 20
Pioneer DVR-K16 Location of the required label COMPLIES WITHFDA RADIATION PERFORMANCE STANDARDS, 21 CFR SUBCHAPTER J. MANUFACTURED: Manufactured by PIONEER CORPORATION 4-1. Meguro 1-chome, Meguro-ku TOKYO 153-8654, JAPAN NEC ND-7550N Location of the required label COMPLIES WITHFDA RADIATION PERFORMANCE STANDARDS, 21 CFR SUBCHAPTER J. MANUFACTURED: Manufactured by NEC Solutions 1-10, Nissnin-cho, Fuchu, Tokyo, 183- 8501, Japan xx
