Our goal is to provide you with a quick access to the content of the user manual for Dell STORAGE AREA NETWORK 650F. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Dell STORAGE AREA NETWORK 650F.
If looking through the Dell STORAGE AREA NETWORK 650F user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Dell STORAGE AREA NETWORK 650F but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Dell STORAGE AREA NETWORK 650F. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
This chapter provides instructions for connecting Dell PowerVault 650F and 651F stor-
age systems to a Dell PowerEdge or Compaq server system running the Novell
NetWare operating system. All procedures in this document require administrator
This chapter describes a NetWare configuration that requires that Managed Node for
NetWare be installed on at least one of the NetWare servers (see Figure 2-2).
2. To connect an interface between the 5xF Fibre Channel switch and each of the NetWare servers that you want to install on the SAN (see Figure 12-1), perform the following steps: a. Connect the high-speed serial data connector (HSSDC) of the interface cable to the QLogic HBAs on each system. b. Connect the other end of the cable to the 5xF Fibre Channel switch. 3. To connect an interface between each of the storage processors (SPs) on the 65xF storage systems and the 5xF Fibre Channel switc
3. If the Select Host Adapter screen is displayed, press the up- or down-arrow key to highlight the controller you want and press
NOTE: The NetWare configuration specified in Figure 2-2 requires that a LUN is bound on an SP in order for the Data Managed Node for Netware to communicate with the SP . If there are no LUNs bound, then a Windows NT or Windows 2000 system attached directly to the SP is required to configure and initialize a LUN. Following this, the Windows NT or Windows 2000 server can be removed and management can occur through the NetWare server. T
7. Edit the sys:\dell\om\agent\agent.cfg file. In the User Specification section, add where admin_user_name is the administrator account and Netwareservername is the name of your NetWare server. For example, type . If you intend to use any Windows NT or Windows 2000 Data Managed Node applications on the client, also specify !". You must specify the device name. The NetWare device names are in the s
To uninstall the Data Managed Node for NetWare, perform the following steps: 1. From the NetWare server console, stop the agent by using the unload omagent command. 2. From a DOS prompt on the client system, type the following commands and press
To create the diskette, perform the following steps: 1. Insert the Dell PowerVault Fibre Channel Utilities CD into your computer’s CD- ROM drive. 2. Insert a blank formatted diskette into the diskette drive. 3. Navigate through the HTML pages to ATF for Netware. 4. Click Create SCSISAN High Availability Driver for Netware Diskette. Follow this link to create a diskette with the needed Dell OpenManage ATF for Netware files. 5. Follo
12. If you are asked to save the existing file scsisan.cdm select No and press
+%,% & For information about creating partitions and volumes on NetWare hard-disk drives, see your NetWare documentation. support.dell.com Novell NetWare Support for Dell PowerVault 65xF Storage Systems 12-9
12-10 SAN Installation and Troubleshooting Guide