Summary of the content on the page No. 1
03002
LT1597
Operator's Manual
Summary of the content on the page No. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac ci - working. den tal starting when setting up, trans- • Slow down before turning. port ing, ad just ing
Summary of the content on the page No. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to • Never operate machine in a closed area. • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. • Never tamper with safety devices. Check their proper children will remain where you last saw them. • Kee
Summary of the content on the page No. 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 1.50 Gallons and Type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 10W30 (above 32°F) SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenace” and “Stor- age” sec tions of this own er’s manual. Oil Capacity: W/Filter: 51 oz. W/O Filter: 35 oz. WARNING: This tractor is equipped with an inter
Summary of the content on the page No. 5
CONTENTS OF HARDWARE PACK Slope Sheet Slope Sheet Key Key (1) Oil Drain Tube (1) Oil Drain Tube (2) Keys (2) Keys (1) Hood Scoop (1) Hood Scoop (1) Hex Bolt Steering Extension Insert Shaft Lock Washer (1) Seat Steering Wheel Steering Boot Steering Wheel (1) Hex Bolt (1) Washer Adapter Washer ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes. BEFORE REMOVING TRACTOR FROM When right or left hand is mentioned in th
Summary of the content on the page No. 6
ASSEMBLY bolt and tighten se cure ly. • Snap steering wheel insert into center of steer ing wheel. SEAT • Remove protective materials from trac tor hood and SWITCH grill. IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO PAD ROLL OFF SKID. SLOT INSERT SEAT PAN 5/16 HEX BOLT TAPE 5/16 LOCK WASHER LARGE FLAT WASHER WIRING HARNESS FIG. 2A SLOT TAPE STEERING WHEEL PAD FLAT STEERING BOOT WASHER ADAPTER TABS TAB SLOTS SEAT PAN EXTENSION SHAFT ADJU
Summary of the content on the page No. 7
ASSEMBLY ATTACH HOOD SCOOP (See Fig. 4) NOTE: You may now roll or drive your tractor off the skid. Follow the ap pro pri ate instruction below to remove the tractor from the skid. WARNING: Before start ing, read, un der stand and fol low all in struc tions in the Op er a tion section of this man u al. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other peo ple and objects. TO ROLL TRACTOR OFF SKID (See Op- er a tion section for location
Summary of the content on the page No. 8
ASSEMBLY ✓CHECKLIST CHECK TIRE PRESSURE BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE The tires on your tractor were overinflated at the factory WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- for shipping purposes. Correct tire pressure is important FOR MANCE AND SAT IS FAC TION FROM THIS QUALITY for best cutting performance. PROD UCT. • Reduce tire pressure to PSI shown on tires. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been completed. CHECK DECK LEVELNESS ✓ No
Summary of the content on the page No. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH REVERSE ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON FUEL BATTERY REVERSE FORWARD CRUISE CONTROL PEDAL 15 15 ATTACHMENT ATTACHMENT DANGER, KEEP HANDS KEEP AREA CLEAR SLOPE HAZARDS CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFE
Summary of the content on the page No. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. D H E B C F G J A FIG. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise, lower, (F) IGNITION SWITCH - Used for starting and stopping a
Summary of the content on the page No. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. GROUND DRIVE - HOW TO USE YOUR TRAC TOR • To stop ground drive, depress clutch/brake pedal all the way down. TO SET PARKING BRAKE (See Fig. 4) • Move gear shif
Summary of the content on the page No. 12
OPERATION TO MOVE FORWARD AND BACKWARD REVERSE OPERATION SYSTEM (ROS) (See Fig. 7) Your tractor is equipped with a Reverse Operation System The direction and speed of movement is controlled by the (ROS). Any attempt by the operator to travel in the reverse gearshift lever (J). direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. W ARNING: Backing up with the attachment clutch en- gaged while mowing is strongly dis
Summary of the content on the page No. 13
OPERATION TO TRANSPORT TO OPERATE MOWER (See Fig. 10) • Raise attachment lift to highest position with at tach ment Your tractor is equipped with an operator presence sensing lift control. switch. Any attempt by the operator to leave the seat with • When pushing or towing your tractor, be sure gearshift the engine running and the attachment clutch engaged lever is in neutral (N) position. will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the
Summary of the content on the page No. 14
OPERATION MOWING TIPS CAUTION: Alcohol blended fuels (called gas- • Mower should be properly leveled for best mowing per- o hol or using ethanol or methanol) can attract for mance. See "TO LEVEL MOWER HOUSING" in the moisture which leads to sep a ra tion and for- ma tion of acids during storage. Acidic gas can Service and Adjustments section of this manual. damage the fuel system of an engine while in • The left hand side of mower should be used for trim- storage. To avoid engine probl
Summary of the content on the page No. 15
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
Summary of the content on the page No. 16
02544 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- bent, worn or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade If tractor requires more than five (5) feet to stop at highest approved by the manufacturer of your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then brak
Summary of the content on the page No. 17
MAINTENANCE • Unlock drain valve by pushing inward and turning • Clean terminals and battery cable ends with wire brush coun ter clock wise. until bright. • To open, pull out on the drain valve. • Coat terminals with grease or petroleum jelly. • After oil has drained completely, close and lock the • Reinstall battery (See “REPLACING BATTERY” in the drain valve by pushing inward and turning clockwise Service and Adjustment sec tion of this manual). until the pin is in the locked position a
Summary of the content on the page No. 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOV
Summary of the content on the page No. 19
SERVICE AND ADJUSTMENTS tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F). • Insert end of link (E) into hole in front mower bracket A and secure with washer and retainer spring (J). • Hook end of clutch cable spring (Q) into hole in idler B E FIG. 17 on rear mower bracket and secure with washer and retainer spring. J F • ATTACH FRONT LINK (E) - Work from left side of trac- H FIG. 19 arm (R). • Push clutch cable housing guide (P) into bracket, sl
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 23 and 24) IMPORTANT: Deck must be level side-to-side. VISUAL
