Summary of the content on the page No. 1
IMPORTANT MANUAL Do Not Throw Away
02478
OPERATOR'S MANUAL
WARNING:
MODEL:
Read this Manu al and follow all Warnings and
Safety Instructions. Fail ure to do so can re sult
in serious in ju ry.
PK1942YT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
194698 10.13.04 RD
Printed in U.S.A.
Summary of the content on the page No. 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS . FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac ci - working. den tal starting when setting up, trans- Slow down before turning. por ting, ad
Summary of the content on the page No. 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to Never operate machine in a closed are. Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. Never tamper with safety devices. Check their proper children will remain where you last saw the
Summary of the content on the page No. 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manufa ctured to giv e you the best possible dependability and performance. Gasoline Capacity 2.0 Gallons and Type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SG-SL): SAE 10W30 (above 32°F) edy, please contact your nearest authorized service center/
Summary of the content on the page No. 5
CONTENTS OF HARDWARE PACK Steering Wheel Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Boot Steering Wheel (1) Knob Insert Steering Wheel Adapter Key (1) Large Flat (1) Hex nut 1/2-20 Washer (2) Keys (1) Oil Drain Tube Slope Sheet (1) Hex Bolt 1/4-28 x 1-1/4 Gauge Wheels (4) Retainer Springs (double loop) (4) Washers (4) Locknut 3/8-16 3/8 x 3/4 x 14 Ga. (4) Wheels (4) Adjusting Bar (4) Shoulder Bolt (4) Clevis Pins 5
Summary of the content on the page No. 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY STEERING WHEEL A socket wrench set will make assembly easier. Stan dard INSERT wrench sizes are listed. LOCK NUT (1) 9/16" wrench Utility knife (1) 3/4" wr
Summary of the content on the page No. 7
ASSEMBLY Remove banding holding defl ector shield up against SEAT tractor. SHOULDER BOLT TO DRIVE TRACTOR OFF SKID (See Op- er a tion sec tion for lo ca tion and func tion of con trols) SEAT PAN WARNING: Before starting, read, un der stand and follow all in struc tions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. Be sure all the above assembly steps have been co
Summary of the content on the page No. 8
ASSEMBLY CHECK TIRE PRESSURE ✓CHECKLIST The tires on your tractor were overinfl ated at the factory BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE for shipping purposes. Correct tire pressure is important WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- for best cutting performance. FOR MANCE AND SAT IS FACTION FR OM THIS QUALITY Reduce tire pressure to PSI shown in “PRODUCT PROD UCT. SPEC I FI CA TIONS” section of this manual. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instruct
Summary of the content on the page No. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH P ENGINE ON ENGINE START PARKING BRAKE ENGINE OFF REVERSE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) FUEL OIL PRESSURE BATTERY REVERSE FORWARD OVER TEMP MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPE HAZARDS CLUTCH ENGAGED DANGER, KEEP HANDS KEEP AREA CLEAR CLUTCH DIS
Summary of the content on the page No. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. IGNITION ROS "ON" SWITCH POSITION THROTTLE/CHOKE CONTROL ATTACHMENT LIFT LEVER CLUTCH PLUNGER LEVER CLUTCH/BRAKE PEDAL ATTACHMENT LIFT LEVER HEIGHT ADJUSTMENT LIGHT SWITCH INDICATOR PARKING BRAKE GEAR SHIFT LEVER 02852 FIG. 5
Summary of the content on the page No. 11
OPERATION The operation of an y tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown ing”
Summary of the content on the page No. 12
02806 OPERATION Move gear shift lever to reverse (R) po si tion and slowly TO ADJUST GAUGE WHEELS (See Fig. 7) release clutch/brake pedal to start movement. Gauge wheels are properly adjusted when they are slightly When use of the ROS is no longer needed, turn the off the ground when mower is at the desired cutting height ignition key clockwise to engine "ON" position. in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terra
Summary of the content on the page No. 13
OPERATION TO OPERATE ON HILLS ADD GASOLINE Fill fuel tank to bottom of fi ller neck. Do not overfi ll. WARNING: Do not drive up or down Use fresh, clean, regular un lead ed gasoline with a hills with slopes great er than 15° and minimum of 87 octane. (Use of leaded gasoline will do not drive across any slope. increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel Choose the slowest speed before starting up or down in q
Summary of the content on the page No. 14
OPERATION COLD WEATHER STARTING ( 50° F and below) When engine starts, allow engine to run with the throttle control in the choke ( ) position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tem- per a ture. The attachments can also be used during the engine warm-up period. NOTE: If at a high altitude (above 3000 feet) or in cold tem per a tures (below
Summary of the content on the page No. 15
maint_sch-tractore.ROS.e MAINTENANCE MAINTENANCESCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and ROS Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Filt
Summary of the content on the page No. 16
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per forming an y main- bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade If tractor requires more than fi ve (5) feet to stop at highest approved by the manufacturer of your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then brake must
Summary of the content on the page No. 17
MAINTENANCE Slide blade on to an unthreaded portion of the steel bolt SAEVISCOSITYGRADES or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal 10W30 position. If either end of the blade moves downward, 5W-30 sharpen the heavy end until the blade is balanced. -20 0 30 32 40 60 80 100 F C -30 -20 -10 0 10 20 30 40 CENTER HOLE TEMPERATURERANGEANTICIPATEDBEFORENEXTOILCHANGE oil_visc_chart4_e FIG. 12 BLADE 5/8" BOLT OR PIN Change
Summary of the content on the page No. 18
MAINTENANCE CLEAN AIR SCREEN IN-LINE FUEL FILTER (See Fig. 14) Air screen must be kept free of dirt and chaff to prevent The fuel fi lter should be replaced once each season. If fuel engine dam age from overheating. Clean with a wire brush fi lter becomes clogged, ob struct ing fuel fl ow to car bure tor, or com pressed air to re move dirt and stubborn dried gum re place ment is re quired. fi bers. With engine cool, remove fi lter and plug fuel line sec- tions . AIR FILTER Place new
Summary of the content on the page No. 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS When distance “D” is 1/8" to 1/2" lower at front than TO LEVEL MOWER HOUSING rear, tighten nuts “F” against trunnion on both front Adjust the mower while tractor is parked on level ground links. or driveway. Make sure tires are properly infl ated (See To raise front of mower, loosen nut “F” from trunnion on “PROD UCT SPECIFICATIONS” section of this manual). If both front links. Tighten nut “E” on both front links an tires are over or underinfl ated, you
