Summary of the content on the page No. 1
OWNER'S MANUAL
MODELNO. 271490
14.5HP38 INCH
LAWNTRACTOR
• Assembly
• Operation
Maintenance
• Service and Adjustments
• Troubleshooting
• Repair Parts
For Parts and Service, contact our authorized distributor:
call 1-800-849-1297 For Technical Assistance: call 1-800-829-5886
181203 12.5.01 RD
PRINTED IN U.S.A.
Summary of the content on the page No. 2
Maintenance ....................................... 16 Safety Rules ......................................... 2 Product Specifications .......................... 5 Service and Adjustments .................... 20 Assembly/Pre-Operation ...................... 7 Storage ............................................... 25 Operation ............................................ 10 Troubleshooting ................................. 26 Maintenance Schedule ...................... 16 Repair Parts ..........
Summary of the content on the page No. 3
• Do not mow near drop-offs, ditches, or -Use only an approved container. embankments. The mower could - Never remove gas cap or add fuel suddenly turn over if a wheel is over the with the engine running. Allow edge of a cliff or ditch, or if an edge engine to cool before refueling. Do caves in. not smoke. -Never refuel the machine indoors. • Do not mow on wet grass. Reduced - Never store the machine or fuel traction could cause sliding. container inside where there is an • Do not try to stabili
Summary of the content on the page No. 4
• Avoid starting or stopping on a slope, if ,_ CAUTION: Tow only the attachments tires lose traction, disengage the that are recommended by and comply blades and proceed slowly straight with specifications of the manufacturer of down the slope. your tractor. Use common sense when • If machine stops while going uphill, towing. Operate only at the lowest disengage blades, shift into reverse possible speed when on a slope. Too and back down slowly. heavy of a load, while on a slope, is • Do not tur
Summary of the content on the page No. 5
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline 1.25 • Read and observe the safety rules, • Follow a regular schedule in maintain- Capacity and Unleaded and ing, caring for and using your tractor. Type: Regular • Follow the instructions under "Mainte- Oil Type SAE 30 (above 32°F) nance" and "Storage" sections of this (API-SF-SJ): SAE 5W-30 owner's manual. (below 32°F) _L,WARNING: This tractor is equipped Oil Capacity: 3 Pints with an internal combustion engine and Spark Plug: Champion
Summary of the content on the page No. 6
Steering Wheel Insert (1) Large Flat Washer (1) Hex Bolt 5/16-18 x 1-1/4 (1) Locknut 5/16-1= _1_ _ (1) Lockwasher 3/8 Steering Extension ,_ Steering Wheel Adapter Shaft Steering O Boot I Seat (1) Washer (_) 17/32 x 1-3/16 x 12 Gauge J_ (1)Knob Slope Sheet _Drain Tub_ For Future Use Keys (2) Keys 6
Summary of the content on the page No. 7
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin. 6. Assemble large flat washer, 3/8 lock TOOLS REQUIRED FOR washer, 3/8 hex bolt and tighten ASSEMBLY securely. A socket wrench set will make assembly 7.
Summary of the content on the page No. 8
TO ROLL TRACTOR OFF SKID (See Seat Operation section for location and function of controls) 1. Press lift lever plunger and raise attachment lift lever to its highest Terminal position. 2. Release parking brake by depressing clutch]brake pedal. 3. Place gearshift lever in neutral (N) position. 4. Roll tractor forward off skid. INSTALL SEAT 5. Remove banding holding deflector Adjust seat before tightening adjustment shield guard up against tractor. knob. 1. Remove adjustment knob and flat TO DRIV
Summary of the content on the page No. 9
CHECK TIRE PRESSURE ,/CHECKLIST The tires on your tractor were overin- Before you operate your new tractor, we flated at the factory for shipping pur- wish to assure that you receive the best poses. Correct tire pressure is important performance and satisfaction from this for best cutting performance. Quality Product. • Reduce tire pressure to PSI shown in Please review the following checklist: "PRODUCT SPECIFICATIONS" /All assembly instructions have been section of this manual. completed. CHECK
Summary of the content on the page No. 10
These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BA'FFERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING J ENGINE ON ENGINE OFF OIL PRESSURE LIGHTS ON OVER TEMP LIGHT ! MOWER LIFT FUEL CHOKE MOWER HEIGHT PARKING BRAKE UNLOCKED LOCKED R N H L c®) I ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT IGNITION CLUTCH DISENGAGED (SEE SAFETY RULES SECTION) FREE WHEEL DANGER, KEE
Summary of the content on the page No. 11
KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. Attachment Clutch Ignition Switch Switch Position " Lever ," ," Plunger Throttle/Choke Attachment Control Lift Lever Clutch/ Brake Pedal o Height Adjustment Indicator g Brake Lever Gearshift \ Our tractors conform to the safety standards of the Am
Summary of the content on the page No. 12
The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. • Turn ignition key to "STOP" position HOW TO USE YOUR TRACTOR and remove key. Always remove key TO SET PARKING BRAKE when leaving tractor to prevent Your tractor is equipped with an o
Summary of the content on the page No. 13
tip withthe engine not running. These • If slowing is necessary, move throttle heights are approximate and may vary control lever to slower position. depending upon soil conditions, height of • If stopping is absolutely necessary, grass and types of grass being mowed. push clutch/brake pedal quickly to • The average lawn should be cut to brake position and engage parking brake. approximately 2-1/2 inches during the cool season and to over 3 inches • Move gearshift lever to 1st gear. Be during ho
Summary of the content on the page No. 14
ADD GASOLINE TO START ENGINE • Fill fuel tank to bottom of filler neck. Do When starting the engine for the firsttime or if not overfill. Use fresh, clean, regular the engine has run out of fuel, it will take extra unleaded gasoline with a minimum of cranking time to move fuel from the tank to 87 octane. (Use of leaded gasoline the engine. will increase carbon and lead oxide 1. Sit on seat in operating position, deposits and reduce valve life). Do not depress clutch/brake pedal and set mix oil w
Summary of the content on the page No. 15
MOWING TIPS • Tire chains cannot be used when the mower housing is attached to tractor. • Mower should be properly leveled for best mowing performance. See "3"0 LEVEL MOWER HOUSING in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trimming. • Drive so that clippings are discharged onto the area that has already been • If grass is extremely tall, it should be mowed twice to reduce load and cut. Have the cut area to the right of the tractor. Th
Summary of the content on the page No. 16
MAINTENANCE SCHEDULE _ ,_,_ _ ,_'=_ _ FILL IN DATES AS YOU COMPLETE REGULAR SERVICE Check Brake Operation Check Tire Pressure Check Operator Presence and T Interlock Systems _' I/, v' R Check for Loose Fasteners A SharpeldReplace Mower Blades T Lubdc,aUon Chart 0 Check Battery Level R Clean Battery and Terminals Check Transaxle Cooling v" Check V-Belts i/ i Check Engine Oil Level I/ l/ Change Engine Oil (with oil filter) i/,,2 I/ E Change Engine Oil (without oil fitter) N Clean Air Filter G Clea
Summary of the content on the page No. 17
TRACTOR IMPORTANT: To ensure proper assembly, center hole in blade must align with star Always observe safety rules when on mandrel assembly. performing any maintenance. 4. Reassemble hex bolt, lock washer BRAKE OPERATION and flat washer in exact order as If tractor requires more than six (6) feet shown. stopping distance at high speed in 5. Tighten bolt securely (27-35 Ft. Lbs. highest gear, then brake must be ad- torque). justed. (See "TO ADJUST BRAKE" in the IMPORTANT: Blade bolt is grade 8 h
Summary of the content on the page No. 18
• Keep small vent holes open. Change the oil after every 25 hours of operation or at least once a year if the • Recharge at 6-10 amperes for 1 hour. tractor is not used for 25 hours in one NOTE: The original equipment battery on year. your tractor is maintenance free. Do not Check the crankcase oil level before attempt to open or remove caps or covers. Adding or checking level of electrolyte is starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/ not necessary.
Summary of the content on the page No. 19
Service air cleaner more often under Blower Housing Screws dusty conditions. Screws 1. Remove knob(s) and cover. TO SERVICE PRE-CLEANER 2. Slide foam pre-cleaner off cartridge. Assembly 3. Wash it in liquid detergent and water. 4. Squeeze it dry in a clean cloth. 5. Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to Engine remove excess oil. Cooling Fins NOTE: If very dirty or damaged, replace pre-cleaner. 6. Reinstall pre-cleaner over cartridge. MUFFLER 7. Reinstall cov
Summary of the content on the page No. 20
[,_ ARNING: TO AVIOD SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1. Depress clutch/brake pedal fully and set parking brake. 2. Place gearshift lever in neutral (N) position. 3. Place attachment clutch in "DISENGAGED" position, 4. Turn ignition key "OFF" and remove key. 5. Make sure the blades and all moving parts have completely stopped. 6. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR IMPORTANT: If an attachment ot
