Snapper 1685336 user manual

Summary of the content on the page No. 1

INSTALLATION
INSTRUCTIONS
GENERAL
The Spring Assist Kit is used to retrofit the hitch used to SPRING ASSIST KIT
install the 42” and 46” Snow Plow/Dozer Blade on
MFG. NO. 1685336
several different models (series) of tractors. For easier
understanding of this instruction sheet, first identify the
size of blade (42” or 46”) and group of tractor on which INSTALLATION
you are working. Follow these specifications throughout
1. Park tractor on a flat, level surface. Shut off engine,
the ten steps.
remo

Summary of the content on the page No. 2

c. Place one washer onto capscrew. Place first link of chain (42” blade on Group 3 tractor) or second link of chain (42”/46” blade on Group 4 tractor) on capscrew.~ Install final two washers on lXp%XWV. d. Insert capscrew (A, figure 5) through tractor frame. Tighten snug only at this time. (Spring,(B) will be installed in step 7.) From inside the frame,’ Figure 3. Diagrams of Hitch Templates install locknut. 6. Assemble the chain (D, figure 1) to the tractor as follows: 42” Blade on Group 1 and

Summary of the content on the page No. 3

1 Member From Top Down Figure 7D. 42” Blade - Group 4 Figure 7A. 42” Blade - Group 1 Figure 76. 42” Blade - Group 2 Figure 7E. 46” Blade - Group 3 Figure 7F. 46” glade - Group 4 Figure 7C. 42” Blade - Group 3 Figures 7A thru 7F. Spring Installation 8. Lower push bar and install dozer blade with kingpin (A, figure 2), spring clip, and pivot pin(B). Reattach rod guide (D) and secure with cotter pin (C). 9. Tighten capscrew (A, figure 4 or 5) and nut which hold chain to tractor frame. 10. Perform L

Summary of the content on the page No. 4

3/S” Dia. Upper Cross Member Bottom Cross Member (42” blade on Group 2) 142” Blade on Group 1, 3 & 4) Actual Templates of Figure 3. INSERT - 1701016