Snapper 7-5122 user manual

Summary of the content on the page No. 1

SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST
For SNAPPER “W” SERIES REAR ENGINE RIDERS

INTRODUCTION: The SNAPPER “W” Series Rear Engine Riders are shipped fully assembled and require
minimal set-up. Complete each of the following steps carefully. Review and complete each item as instructed
on the Pre-Operation checklist. The Snapper Product Registration card must be filled out and sent to Customer
Service department at Snapper when completed.

BATTERY ACTIVATION and INSTALLATION 2. BAT

Summary of the content on the page No. 2

DISCHARGE DEFLECTOR ELECTRICAL CIRCUIT The discharge deflector is shipped in the “UP” position. The electrical connection at the engine is shipped Remove rubber band, lower discharge deflector and disconnected to protect the electrical system when the secure to deck with carriage bolt(s), flat washer(s) and battery is installed and MUST BE THE LAST STEP in wing nut(s) furnished in the deck. See Figure 3. preparation. A. Connect electrical circuit at rear of the engine. See Figure 4.

Summary of the content on the page No. 3

SERVICE NOTES ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ _____

Summary of the content on the page No. 4

PRE-OPERATION CHECKLIST Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items also be checked prior to placing the machine into service. It is very important that setup is verified and all o