Lowrance electronic 000-0124-69 user manual

Summary of the content on the page No. 1

NMEA 2000 Network
Installation Instructions
This instruction sheet covers the configuration and installation of a NMEA 2000
network.
HDS Units
If you have an HDS unit, you must make a one-time purchase of a NMEA 2000
Starter kit to create a NMEA 2000 network.
NMEA 2000 Starter kit (p/n: 000-0124-69)
2-ft extension cable 120 ohm male terminator
15-ft extension cable 120 ohm female terminator
2 T connectors Power node
Inline Terminator Cable
Some Lowrance LCX and LMS units and LGC-3000 antenna

Summary of the content on the page No. 2

Network backbone Nodes 120 ohm 120 ohm terminator terminator General NMEA 2000 Installation Rules • Only devices/sensors should be connected to the bottom of a T connector; the connectors at the top of the T connector are only used for extension cables, terminators and other T connectors • Power the Network only once • A terminator must be connected to each end of the network backbone • You can attach an extension cable between a device and the bottom of a T connector, but there should

Summary of the content on the page No. 3

Ground wire Plug the power node connector into the bottom of a T connector on the network 3-amp fuse Positive wire Power Node To install a power node: 1. Connect the black (ground) wire to a ground. 2. Connect the Red (positive) wire to a switched 12-volt power source. 3. Plug the black power node connector into the bottom of a T connector on your NMEA 2000 network. Adding Devices, a Network Node or Extension Cable NMEA 2000 devices are added to a network by connecting the device to

Summary of the content on the page No. 4

Compatibility NMEA 2000 Sonar/GPS combo units purchased in 2005 had Blue Style connectors. The Blue Style connectors can be used with NMEA 2000 Style connector display units and components with the purchase of an adapter cable. NAC-FRD2FBL (P/N: 000-0127-05): connects NMEA 2000 Style connector devices to a Blue Style connector network. NAC-MRD2MBL (P/N: 000-0127-04): connects Blue Style connector devices to a NMEA 2000 Style connector network. NMEA 2000 Style connectors are compatible with

Summary of the content on the page No. 5

Large boat example Terminator at end of backbone Display Unit LMF-400 LMF-400 GPS Antenna Temp Sensor (air) Display unit LMF-400 LMF-400 LMF-200 LMF-200 Temp sensor (cabin) Power Node To power source Temp sensor (live well 1) Temp sensor (live well 2) Engine interface 1 Temp sensor (water) Engine Interface 2 Terminator at end of backbone Upper Helm Stern Lower Helm

Summary of the content on the page No. 6

Blank Page

Summary of the content on the page No. 7

Blank Page

Summary of the content on the page No. 8

How to Obtain Service… …in the USA: Contact the Factory Customer Service Department. Call toll-free: For Lowrance: 800-324-1356. For Eagle: 800-324-1354 8 a.m. to 5 p.m. Central Standard Time, M-F Lowrance Electronics and Eagle Electronics may find it necessary to change or end their shipping policies, regulations and special offers at any time. They reserve the right to do so without notice. …in Canada: Contact the Factory Customer Service Department. Call toll-free: 800-661-3983 905-629-1614