Azden 15XT user manual

Summary of the content on the page No. 1

Specifications:
Overall System
Operating Range 200-300 feet
Operating Frequency UHF, 566.25 MHz to 589.75 MHz
Number of Channels 92 User-selectable
Modulation Mode FM
Oscillator Phase Lock Loop synthesizer
o o o o
Operating Temp. Range -10 C to +50 C (-50 F to -122 F)

105UPR Receiver 105 SYSTEM
Frequency Response 50 Hz - 12 kHz
RF Squelch level -92 dBm
User’s Guide
Adj. Channel Selectivity ≥ 67 dBm
Intermodulation ≥ 62 dBm
Noise Reduction Expander

Summary of the content on the page No. 2

5 8 Operating the system 3 Because this is a frequency agile system, the receiver and transmitter must both be on 22 the same Receive/Transmit frequency. Follow the instructions #5, 16, 24 and 27 carefully. Make sure both the receiver and the transmitter are on the same channel. 4 6 7 2 105UPR Receiver After installing new batteries, mount the receiver to your video camera with the supplied shoe-mount or hook and loop fastener. Connect the output cable to the receiver and to the microphone i

Summary of the content on the page No. 3

HANDHELD MICROPHONE/TRANSMITTER (15HT) Thank you for purchasing Azden’s 105 wireless microphone system. Depending on which system your ordered, this package will contain one or more of the following components: the 105UPR receiver, the 15BT body-pack receiver with EX-503L lavalier microphone, the (25) Remove the battery compartment cover by rotating it counterclockwise and 15XT Plug-in transmitter and/or the 15HT handheld microphone/transmitter. This equip- sliding it down. ment is designe

Summary of the content on the page No. 4

(8) Phone Output Adjustment (18) Belt-clip Using the supplied tool, turn the screw clockwise to increase and counterclock- Use this to attach the 15BT to a belt on the subject. wise to decrease the audio level presented at the earphone monitor jack. XLR PLUG-IN TRANSMITTER (15XT) (9) Shoe-mount Attach the 105UPR to the shoe-mount on the video camera by sliding it into (19) Open the battery compartment lid and insert two fresh Alkaline “AA” batteries. Make place. Turn the thumb-wheel clock