Summary of the content on the page No. 1
CDR-1000
OPERATING INSTRUCTIONS
SUPPLEMENT
Summary of the content on the page No. 2
TABLE OF CONTENTS 1. Quick System Setup......................... See Section 1 in the main RE-1 Instructions 2. System Description............................................................ 2 3. Detailed Component Description ................................................. 3 4. Detailed Description of Unique CDR-1000 Features 1. Headset Port........................................................... 4 2. Audio Output........................................................... 4 3. Antenna Conn
Summary of the content on the page No. 3
Section 3 Detailed Component Descriptions CDR-1000 RECEIVER CONTROLS, CONNECTORS AND INDICATORS 2d 2c menu menu 1 2 R R RE-1 CDR-1000 1 2 Featuring set set power 1 2b 4 2a 4 3 3 4 Figure 1 Front Panel CDR-1000 Receiver PATENT NO. 6,256,484 POWER 90-260 VAC 50-60 Hz CDR-1000 DUAL RECEIVER ANTENNA ANTENNA MADE IN U.S.A. OUT IN OUT IN 12 Vdc 12 Vdc 150 mA 150 mA MIC LINE LINE MIC Out Out HIGH HIGH LINE LINE AUDIO 2 Z PROGRAM 2 PROGRAM 1 AUDIO 1 Z LEVEL LEVEL 11 10 9 6 7 8 11 10 9 6 7 8 5 Figure
Summary of the content on the page No. 4
Section 4 Detailed Description of Unique CDR-1000 Features LPA500 LPA500 Headphone Operation R R UHFLOG PERIODIC ANTENNA UHFLOG PERIODIC ANTENNA THIS END TOWARD TRANSMITTER THIS END TOWARD TRANSMITTER 1. With the transmitters and receivers setup and operating (see Sections 1 and 3 in the main RE-1 Operating Instructions), plug stereo headphones into the 1/4inch jack on the front panel. PATENT NO. 6,256,484 90-260 VAC 50-60 Hz CDR-1000 DUAL RECEIVER ANTENNA ANTENNA MADE IN U.S.A. OUT IN OUT IN
Summary of the content on the page No. 5
RE-OneLink PC Software LPA500 LPA500 R R UHFLOG PERIODIC ANTENNA UHFLOG PERIODIC ANTENNA THIS END TOWARD TRANSMITTER THIS END TOWARD TRANSMITTER 1. Software to monitor and control the CDR-1000 receivers from a PC through the USB port is available at www.electrovoice.com. Minimum system require- ments are: Windows 2000 POWER OUTPUT A IN OUTPUT B INPUT A 1 2 3 4 4 3 2 1 INPUT B POWER OUT 1 2 3 4 15V AC/DC 512 Mbytes of RAM 1.3A 15VDC One USB port PATENT NO. 6,256,484 90-260 VAC 50-60 Hz CDR
Summary of the content on the page No. 6
Section 5 Trouble Shooting Guide Problem Possible Causes Solutions Receiver audio output cable is Repair, replace cable or connect disconnected or connected to the No (or low) Audio with good RF cable to the correct receiver. wrong receiver. signal and Audio indicatiors on receiver display Audio Output in Mic position or line Adjust audio output (See Audio level adjustment low Output section) antennas connected to output Connect antennas to the input Low RF Signal instead of input jack. jack. Fo
Summary of the content on the page No. 7
Section 7 Certification CERTIFICATIONS (Depending on frequency selected and country of operation) CDR-1000 Receiver, CSH-1000 Transmitter, CSB-1000 Transmitter Certified to ETSI EN 300 422-2 and ETSI EN 301 489-3, Conforms to European Union directives, eligible to bear CE marking as per the R&TTE Directive. Certified for use in Canada under RSS 123 Issue 1. The CDR-1000 is authorized under United States Federal Communications Commission, Part 15. The CSH-1000 and CSB-1000 are Type Accepted under
Summary of the content on the page No. 8
TELEX COM MU NI CA TIONS, INC. 12000 Port land Ave. South, Burnsville, MN 55337. • PN 803554 Rev. D JAN 2003 Made in U.S.A.
