Summary of the content on the page No. 1
iR1200 Rugged Modem
iR1200 GPS-Enabled Modem
CONFIGURATION GUIDE
Summary of the content on the page No. 2
Summary of the content on the page No. 3
TABLE OF CONTENTS TABLE OF FIGURES ....................................................................................................................................................................................................... .1 FCC COMPLIANCE ......................................................................................................................................................................................................... .2 INTRODUCTION ........................
Summary of the content on the page No. 4
TELUS Mobility™ Modem Configuration – Windows NT.............................................................................................................................. 22 Install the Modem ....................................................................................................................................................... 22 Configure the Modem Driver......................................................................................................................
Summary of the content on the page No. 5
Lock/Unlock the DCE [AT+wclk].................................................................................................................................... 36 Change the DCE’s PIN [AT+wcpn]................................................................................................................................. 36 Packet Data Sleep Timer [AT+ws175]............................................................................................................................. 37 SL
Summary of the content on the page No. 6
Summary of the content on the page No. 7
iR1200 Modem TABLE OF FIGURES Table of Figures Page Figure 1 - iR1200 GPS-Enabled Modem ................................................................................................................................5 Figure 2 - Rear Panel of iR1200 Rugged Modem...................................................................................................................6 Figure 3 - Rear Panel of iR1200 GPS-Enabled Modem ..............................................................
Summary of the content on the page No. 8
TELUS Mobility™ FCC COMPLIANCE DECLARATION OF CONFORMITY Per FCC CFR 47 2.989 Responsible party name: eLutions, Inc. Address: 5905 Breckenridge Parkway Suite F Tampa, FL 33610 Phone number: 1-800-836-9909 Hereby declares that the product: Product name: iR1200 GPS-Enabled Modem Model Number: 4200-C5-RFM Product name: iR1200 Rugged Modem Model Number: 4250-C5-RFM Conforms to the following regulation: FCC Part 15, subpart B
Summary of the content on the page No. 9
iR1200 Modem INTRODUCTION This chapter contains information about the required components for successful installation and operation of the iR1200 modem. Box Contents Page 3 Documents Available Online Page 3 Required Components for Installation Page 3 Components for Mobile Environment Page 3 Components for Fixed Environment Page 4 How to Order Required Components Page 4 Required Components for Operation Page 4 Communication Software Page 4 Data Account Activation Page 4 Customer C
Summary of the content on the page No. 10
TELUS Mobility™ • Data cable for GPS (for iR1200 GPS-Enabled Modem only) Components for Fixed Environment (sold separately) The iR1200 Rugged Modem is typically used for fixed installation environment. The following table lists the components required for this type of installation: • Approved Cellular Antenna • AC Power Adapter • Data Cable for computer (laptop/MDT) IMPORTANT: Use only approved and tested components. The use of unapproved components voids the iR1200 modem warranty.
Summary of the content on the page No. 11
iR1200 Modem OVERVIEW This chapter contains general production information about the iR1200 modem. General Overview Page 5 Modem Operating Modes Page 5 Modem Configurations Page 5 Modem Specifications Page 6 General Overview The iR1200 Modem is an iDEN data modem that consists of a modem card and an optional GPS (iR1200 GPS-Enabled Modem) receiver, contained in a rugged enclosure, to provide wireless data communications. The iR1200 modem is easy to mount, whether in a mobile or fix
Summary of the content on the page No. 12
TELUS Mobility™ iR1200 Rugged Modem The following diagram displays the components that exist on the rear panel of the iR1200 Rugged Modem. Ign Igniit tiion Sen on Sens se / e / B By ypa pas ss s Conne Connec ctor tor Modem Modem 12VDC Po 12VDC Pow wer er Ser Seriia all Data Data Conne Connec ctor tor Conn Conne ec ctor tor Modem Antenna Modem Antenna Conne Connec ctor tor Figure 2 - Rear Panel of iR1200 Rugged Modem iR1200 GPS-Enabled Modem The following diagram shows the compone
Summary of the content on the page No. 13
iR1200 Modem DB-9 for modem, DB-9 for GPS (optional) Data Connector Molex 39-01-2020 with 39-00-0186 pins Power and Ignition Connectors -25 degrees C to +60 degrees C Operating Temperature Storage Temperature -40 degrees C to +85 degrees C Humidity 0-95% non-condensing Vibration per TIA/EIA 603 par 3.3.4 Shock per MIL-STD-810E, method 516.4, procedure I Dust per MIL-STD-810E, method 510.3, procedure I Dust/Water Resistance Water per MIL-STD-810E, method 506.3, procedure II Yes M
Summary of the content on the page No. 14
TELUS Mobility™ MODEM CONFIGURATION In this chapter, you will learn how to set up your windows components, install the iDEN Packet Data Applet, and configure the iR1200 modem to operate with the iDEN network. Windows Configurations Page 8 Windows 95/98/ME Page 8 Page 9 Windows NT/2000 Page 10 Windows XP Installing iDEN Packet Data Applet Page 11 Minimum Requirements Page 11 Page 11 Before You Begin Page 11 Download iDEN Packet Data Applet Manual Modem Configuration
Summary of the content on the page No. 15
iR1200 Modem proceed with the remaining instructions. 7. The Select Network Component Type window opens. Highlight Protocol and then click Add. 8. The Select Network Protocol window opens. Under Manufacturer, select Microsoft. Under Network Protocol, select TCP/IP. Click OK. 9. The TCP/IP Dial-Up Adapter appears in the list. 10. If the Dial-Up Adapter appears in the Network Adapters list, it is installed. You may proceed with installation. 11. If the Dial-Up Adapter does not appear in t
Summary of the content on the page No. 16
TELUS Mobility™ The following steps describe how to check that TCP/IP is in fact installed, and if necessary add the TCP/IP protocol. NOTE: This may require that you contact your IT Representative or System Administrator. 1. From your desktop, select StartàSettingsàNetwork and Dialup ConnectionsàLocal Area Connection. The Local Area Connection window opens. 2. Click the Properties button on the Local Area Connection window. 3. Is the Internet Protocol listed under the Components listin
Summary of the content on the page No. 17
iR1200 Modem â Installing iDEN Packet Data Applet Minimum Requirements To run the installation program, you will need the following: • An IBM compatible PC with: o 586 (or higher) processor o Microsoft Windows 95, 98, NT or 2000, XP o Minimum 8 MB of addressable RAM o 3 MB free hard-disk space • Recommended: Mouse or compatible pointing device • Communication software • Standard Internet browser (such as Internet Explorer or Netscape) • An active account with TELUS (for conne
Summary of the content on the page No. 18
TELUS Mobility™ . 1. The File Download window appears. Click on the Save button to continue. The download program will copy the files that are needed to install the software to the appropriate location on your computer. IMPORTANT: When you have finished downloading the program, you MUST connect the data cable to your modem and computer before proceeding further. 2. Find the program in the appropriate folder and double-click the Setup.exe to launch the program to initiate the installa
Summary of the content on the page No. 19
iR1200 Modem 5. Click Next on the iDEN Packet Data Applet Setup screen. 6. The Customer Information window opens. Enter your name and company then click Next. 7. The Choose Destination Location window opens. Click Next to accept the default destination folder, C:\Program Files. 8. The Select Program Folder window opens. Click Next to accept the default program folder, iDEN Packet Data Applet. 9. After the files are copied, the Question window opens. Click Yes to add a shortcut
Summary of the content on the page No. 20
TELUS Mobility™ NOTE: Check to make sure that your modem is turned on and connected to your computer before continuing with the installation. 12. Select the following value on the Communication Settings window: • Click the Auto Detect to have the software automatically check for the COM Port or select the appropriate COM Port (typically COM1) • Multiple Baudrate should be unchecked • Baud Rate: 19200 (bps) The program will check the communication settings and attempt to connect to th
