Harman-Kardon user manual

Summary of the content on the page No. 1

THE BRIDGE II
DOCKING STATION FOR iPod
OWNER’S MANUAL
1
0057CSK - HK Bridge II All v10.indd 1 10/02/09 10:32:04

Summary of the content on the page No. 2

inTRODUCTiOn Congratulations! With The Bridge II, you are entering Compatibility the new world of entertainment made possible The Bridge II is compatible with all The Bridge- and by combining the incredible storage capacity and The Bridge II-ready Harman Kardon receivers, and the playback flexibility of an iPod with the sonic power Harman Kardon DMC 1000 digital media center. As of ® of your Harman Kardon system. the printing of this manual, these models include: With a single cable,

Summary of the content on the page No. 3

InSTALLATIOn step three: Place the black insert in The Bridge II, InstallIng making sure to push it all the way down. See Figure 3. With only a single cable connection, The Bridge II is easy to connect to your Harman Kardon product. nOtE: Do not place an iPod in The Bridge II unless both the black insert and a dock adapter are installed. step One: Turn off the Harman Kardon The Bridge- Otherwise, the iPod will not connect properly, and or The Bridge II-ready product, using its master powe

Summary of the content on the page No. 4

OPERATIOn Photos may be viewed on an external monitor only for UsIng iPod models that support video browsing (see note Once The Bridge II is connected, use either the front- below). Select the desired photo, then press the play panel controls or The Bridge-ready product’s remote button on the iPod, or press the OK or Enter Button on control to select tracks for playback. Press the DMP/ the remote three times. The Bridge Button on the remote, or use the Source Selector on the front panel to

Summary of the content on the page No. 5

OPERATIOn Charging the iPod Undocking the iPod You may leave your iPod in The Bridge II even when We recommend that you pause playback before you are not using it as a playback source. Whenever physically removing the iPod from The Bridge II. the iPod is docked and your receiver is turned on, IMPORtant nOtE: When using The Bridge II The Bridge II will charge the battery in the iPod. with the DMC 1000, do not remove the iPod from Some Harman Kardon receivers allow you to charge The Bridg

Summary of the content on the page No. 6

TROUBLESHOOTInG tROUBlEsHOOtIng gUIDE sYMPtOM sOlUtIOn The iPod does not play or respond to • Make sure that The Bridge II is properly connected commands from the receiver’s remote. to a compatible Harman Kardon receiver. • Make sure that DMP or The Bridge is selected as the input on the receiver. The LED under The Bridge II goes out • Check the menu setting on your receiver to make sure when the receiver is in the Standby mode. that the option to charge iPod while in Standby mode is

Summary of the content on the page No. 7

STAPLE InVOICE HERE 7 0057CSK - HK Bridge II All v10.indd 7 10/02/09 10:32:33 English

Summary of the content on the page No. 8

250 Crossways Park Drive, Woodbury, New York 11797 www.harmankardon.com © 2008 Harman International Industries, Incorporated. All rights reserved. Part No. 950-0236-001 8 0057CSK - HK Bridge II All v10.indd 8 10/02/09 10:32:00