Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/welcome
AD7000W/37
EN User manual
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Register online at www.philips.com/welcome today to get the very most from your purchase. Register online at www.philips.com/welcome to ensure: Congratulations on your purchase, and welcome to the “family!” This “bolt of lightning” indicates unin- Dear PHILIPS product owner: sulated material within your unit may cause an electrical shock.For the safety of everyone in your household, please do not remove product covering. The “exclamation point” calls atten- tion to features for which you should
Summary of the content on the page No. 4
P&F USA, Inc. PO Box 2248, Alpharetta, GA 30023-2248
Summary of the content on the page No. 5
Contents Contents 1 Important 6 Safety 6 Notice 7 2 Your Entertainment System 10 Introduction 10 What’s in the box 10 What else you need 10 Overview of the main unit 11 Get started to use AirPlay 11 3 Prepare 12 Connect power 12 Turn AD7000W on 12 4 Connect to your home Wi-Fi network for AirPlay 13 Scenario 1: Connect to a WPS router 13 Scenario 2: Connect to a non-WPS router 14 5 Play 20 Stream audio from your iTunes music library to AD7000W 20 Control play 21 Use advanced sound settings 21 P
Summary of the content on the page No. 6
h Do not install near any heat sources such 1 Important as radiators, heat registers, stoves, or other a pparatus (including amplifiers) that produce heat. Safety i Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with Know these safety symbols one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the pr o vided plug does
Summary of the content on the page No. 7
n Ref er all ser vicing to qualified ser vice Notice personnel. Servicing is required when the apparatus has been damaged in any Notice of compliance way, such as power-supply cord or plug is damaged, liquid has been spilled or Any changes or modifications made to this objects have fallen into the apparatus, the device that are not expressly approved by apparatus has been exposed to rain or WOOX Innovations may void the user’s moisture, does not operate normally, or authority to op
Summary of the content on the page No. 8
residential installation. This equipment generates, negative consequences on the environment and uses and can radiate radio frequency energy human health. and, if not installed and used in accordance with Please visit www.recycle.philips.com for the instructions, may cause harmful interference additional information on a recycling center in to radio communications. However, there is no your area. guarantee that interference will not occur in a particular installation. Information about t
Summary of the content on the page No. 9
“Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic accessory has been designed to connect specifically to iPod, iPhone, or iPad, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod, iPhone, or iPad may affect wireless performance. AirPlay, iPod, and iPhon
Summary of the content on the page No. 10
Tip 2 Your • Please visit www.philips.com/welcome for information about more Philips AirPlay-enabled devices. Entertainment System With AD7000W, you can also: • charge your iPod/iPhone/iPad through the USB socket with an Apple USB Congratulations on your purchase, and cable (not supplied). welcome to Philips! To fully benefit from the • play your iTunes music library on your support that Philips offers, register your product iPod/iPhone/iPad through the USB at www.philips.com/welcome.
Summary of the content on the page No. 11
e MP3-LINK List of compatible iTunes host devices • Connect an external audio player for AirPlay through the supplied MP3 link cable. In terms of AirPlay, AD7000W is compatible f DC IN with: • Connect the power adaptor. • a Wi-Fi enabled PC/Mac installed with g USB iTunes 10 (or later); and • Connect an iPod/iPhone/iPad through • the following iPod/iPhone/iPad models an Apple USB cable (not supplied). installed with iOS 4.3 (or later): • iPad 2 • iPad • iPhone 4 Get started to use AirPlay
Summary of the content on the page No. 12
3 Prepare Turn AD7000W on 1 Press on the back to turn the unit on. 2 Wait for successful boot-up of the unit. Always follow the instructions in this chapter in » The boot-up takes about 35 seconds. sequence. » During boot-up, the Wi-Fi SETUP indicator on the back of the unit blinks green quickly. Connect power » After boot-up, if no Wi-Fi connection has been set up for AD7000W, the Caution Wi-Fi SETUP indicator starts to blink green slowly. • Risk of product damage! Make sure that the
Summary of the content on the page No. 13
1 Make sure that your Wi-Fi router is 4 Connect to powered on and working properly. 2 Make sure that AD7000W has been your home Wi- powered on and booted up successfully (see ‘Turn AD7000W on’ on page 12). Fi network for 3 Identify the type of your Wi-Fi router (see AirPlay the user manual of your Wi-Fi router for details). Scenario 1: Connect to a WPS router Note • Before you press any button on AD7000W, make sure that AD7000W has been booted up successfully (see ‘Turn AD7000W on’ on
Summary of the content on the page No. 14
Follow the sequence below for connection of AD7000W to a non-WPS Wi-Fi router. 1 Collect settings of your home Wi-Fi router and write down on paper for use during AD7000W Wi-Fi setup (see ‘Collect settings of your home Wi-Fi router’ on page 14). 2 Switch AD7000W to Assisted Wi-Fi Setup mode (see ‘Switch AD7000W to Assisted Wi-Fi Setup mode’ on page 15). » A new Wi-Fi network created by AD7000W will appear, with the network name (SSID) of Philips Fidelio AirPlay. 3 Connect your Wi-Fi
Summary of the content on the page No. 15
» A new Wi-Fi network created by 2 Launch the Internet browser (for example, AD7000W will appear, with the Apple Safari or Microsoft Internet network name (SSID) of Philips Fidelio Explorer) on your Wi-Fi enabled device. AirPlay. 3 Open the configuration page of your » It may take up to 45 seconds for home Wi-Fi router. successful creation of this new Wi-Fi 4 Find the Wi-Fi settings tab and write down network. the following information on paper: A Network name (SSID) Note B Wi-Fi securi
Summary of the content on the page No. 16
3 Wait until successful Wi-Fi connection on your iPod touch/iPhone/iPad. » is displayed at the upper left corner of your iPod touch/iPhone/iPad. Tip • If Philips Fidelio AirPlay is not in the list, try to scan the available Wi-Fi networks again. Use your Wi-Fi enabled PC/Mac Note • See the user manual of your PC/Mac for how to connect your PC/Mac to a Wi-Fi network. • During Wi-Fi network connection, do not connect any network cable to your PC/Mac. 1 Open the Wi-Fi setup tool or control
Summary of the content on the page No. 17
192.168.1.1 4 Wait until successful Wi-Fi connection on your PC/Mac. If you use Safari on your Wi-Fi enabled PC/ Mac, you can also select ‘Philips_Fidelio XXX’ from the Bonjour pull-down list to enter the AD7000W configuration w eb page dir ectl y . 1 Click -> Preferences. » The Bookmarks menu is displayed. Tip • If Philips Fidelio AirPlay is not in the list, try to scan the available Wi-Fi networks again. Open the built-in web page of AD7000W 1 Launch Apple Safari browser or a
Summary of the content on the page No. 18
2 Tick Include Bonjour for Bookmarks bar. 192.168.1.1 3 Select ‘Philips_Fidelio XXX’ from the Bonjour pull-down list shown at the bookmarks bar. » The AD7000W configuration web page is displayed. • Follow the on-screen instructions to change and confirm the internal Wi-Fi settings of AD7000W. » After a while, the indicator on the back of AD7000W stops blinking and stays green, and the unit beeps. » AD7000W is connected to your existing home Wi-Fi network successfully. Note Chan
Summary of the content on the page No. 19
Restore your Wi-Fi enabled device back to your existing home Wi-Fi setting Note • Make sure that the settings at steps 2 to 3 below match your home Wi-Fi network settings you wrote on paper. 1 Select Settings -> Wi-Fi on your iPod touch/iPhone/iPad. • Or open the list of available Wi-Fi networks on your PC/Mac. 3 Enter the network key if required. 4 Wait until successful Wi-Fi connection to your home Wi-Fi network. 2 Select your network name (SSID) from the list of available wireles
Summary of the content on the page No. 20
5 Play Stream audio from your iTunes music library to AD7000W Note • Make sure that your iTunes host device is connected to the same Wi-Fi network as AD7000W. Your iTunes device can be an iPod touch/iPhone/iPad installed with iOS 4.3 (or later) or a Wi-Fi enabled PC/Mac installed with iTunes 10 (or later). 4 Select a media file and start play. Stream from your iPod touch/iPhone/ » After a while, you will hear music from iPad AD7000W. 1 Launch the iPod application on your iPod touch/iP
