Yamaha DM2000 V2 user manual

Summary of the content on the page No. 1

Cubase SX3 / DM2000 V2 Setup and Operation Page 1
Cubase SX3 / DM2000 V2 Setup and Operation
This document describes setup and operation for remote control of Cubase SX from the
DM2000 digital mixing console. These instructions apply to DM2000 V2.0 or higher
and Cubase SX V3.0.0 or higher.
Driver Installation
1) Connect your PC or Macintosh computer
The DM2000 should be connected to your computer by connecting the TO HOST
USB port on the DM2000 t

Summary of the content on the page No. 2

Cubase SX3 / DM2000 V2 Setup and Operation Page 2 Configuring Cubase SX V3.0.0 or higher 1) Click on the ‘Devices’ menu and select ‘Device Setup’. 2) Click on the ‘+’ icon (Add Device), then click on ‘Yamaha DM2000 V2’. This will cause Yamaha DM2000 V2 to appear in the Devices column on the left side of this window. 3) In the right side of the ‘Device Setup’ window, assign DM2000 V2 to the correct MIDI Input and Output ports. For example, if you

Summary of the content on the page No. 3

Cubase SX3 / DM2000 V2 Setup and Operation Page 3 level shown in the fluorescent display section. In this mode, each send can be switched On/Off by pressing the encoder. Selected Channel Functions Pressing any of the DISPLAY switches in the SELECTED CHANNEL section of DM2000 will cause the VST Audio Channel Settings window to open in Cubase SX. COPY & PASTE The CHANNEL COPY and PASTE switches on DM2000 perform the same functions as COPY and PASTE

Summary of the content on the page No. 4

Cubase SX3 / DM2000 V2 Setup and Operation Page 4 FX Sends, Routing and Insert Editing FX SENDS In the EFFECTS / PLUG-INS section of the DM2000, press the INTERNAL EFFECTS key to access FX Send information on the LCD screen. The encoders below the screen can edit various functions: • Encoder 1 edits the send level. • Encoder 2 edits the send On/Off status (by turning the encoder). • Encoder 3 edits between Pre and Post Fader (by turning the encod

Summary of the content on the page No. 5

Cubase SX3 / DM2000 V2 Setup and Operation Page 5 Transport & Automation Ensure that DAW CONTROL is selected in the LOCATE MEMORY screen of the LOCATOR display menu on DM2000. TRANSPORT CONTROLS The following Transport functions can be controlled from DM2000: • REC • PLAY • STOP • FF • REW • SCRUB • SHUTTLE • LOOP • QUICK PUNCH • ONLINE LOCATE FUNCTIONS The following DM2000 locate functions also control the corresponding Cubase SX functions: • RTZ

Summary of the content on the page No. 6

Cubase SX3 / DM2000 V2 Setup and Operation Page 6 User Defined Keys When DM2000 is used to remotely control Cubase SX, the following User Defined Keys have permanently assigned functions: UDEF 1: Brings the Project window to the front UDEF 2: Scrolls channels down in banks of 8 UDEF 3: Scrolls channels up in banks of 8 UDEF 9: Open or closes the VST Mixer window UDEF 10: Scrolls channels down one channel at a time UDEF 11: Scrolls channels up one