Summary of the content on the page No. 1
ST60 Wind &
Close Hauled
Wind
Instrument
Owner’s
Handbook
Document number: 81105-4
Date: 1 April 2004
Summary of the content on the page No. 2
Raymarine, ST60 and SeaTalk are trademarks of Raymarine Limited © Handbook contents copyright Raymarine Limited 2004
Summary of the content on the page No. 3
Preface i Preface Important information Safety notices WARNING: Product installation & operation This equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in personal injury, damage to your boat and/or poor product performance. WARNING: Electrical safety Make sure you have switched off the power supply before you start installing this product. WARNING: Although we have designed this product to be accurate and
Summary of the content on the page No. 4
ii ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook
Summary of the content on the page No. 5
Preface iii Contents Preface ......................................................................................................................i Important information ..................................................................................... i Safety notices .......................................................................................... i EMC conformance ................................................................................... i Handbook information .........
Summary of the content on the page No. 6
iv ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook 2.2 Troubleshooting .....................................................................................8 Preliminary procedures ...........................................................................8 Fixing faults ............................................................................................8 Technical support ....................................................................................9 World wide web .....
Summary of the content on the page No. 7
Preface v 4.3 Intermediate calibration ....................................................................... 29 Leaving Intermediate calibration ......................................................... 29 4.4 Dealer calibration ................................................................................. 29 User calibration on/off ......................................................................... 30 Response settings ................................................................
Summary of the content on the page No. 8
vi ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook
Summary of the content on the page No. 9
Preface vii Introduction Thank you for purchasing a Raymarine product. We are sure your ST60 instrument will give you many years of trouble-free operation. This handbook describes how to install and use the Raymarine ST60 Wind and ST60 Close Hauled Wind instruments. These give: True and Apparent wind direction and speed. Wind speed is displayed either in knots, meters per second or as Beaufort scale values. Velocity made good (VMG). Maximum wind speed. In addition to this, ST60 Wind ma
Summary of the content on the page No. 10
viii ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook ST60 Close Hauled Wind The ST60 Close Hauled Wind instrument provides an expanded indication from -60° to +60° about the bow and stern of the boat, on a combined analog and digital display. Data inputs SeaTalk SeaTalk enables a number of compatible instruments to operate as a single, integrated navigational system. Instruments in a SeaTalk system are linked by means of a single cable, which feeds both power and data. Instruments
Summary of the content on the page No. 11
Preface ix Mounting options If you do not want to surface mount your ST60 instrument, options are available for: Flush mounting. If you have ordered the flush mounting option a low-profile bezel and four fixing screws are also provided. Bracket mounting. Parts supplied Unpack your ST60 instrument and check that the following items are present: Either Item 1a, ST60 Wind instrument, fitted with standard bezel for surface mount- ing or Item 1b, ST60 Close Hauled Wind instrument, fitted
Summary of the content on the page No. 12
x ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook 1a 1b 4 2 3 2 3 6 8 These items are not with ST60 Close Hauled Wind 7 9 5b 5a WIND Operation ST60 Wind VMG TACK Instrument KTS TRUE APP TRUE APP Owner's Handbook 3s to reset * * HI * LO 10 11 D4442-4
Summary of the content on the page No. 13
Chapter 1: Operation 1 Chapter 1: Operation 1.1 Getting started This handbook describes how to operate, maintain and install the Raymarine ST60 Wind instrument and ST60 Close Hauled Wind instrument. These instruments show: Wind speeds and directions Velocity Made Good (VMG) information, when boat-speed information is available, Tack angle, when heading information is available. CAUTION: Calibration requirement The ST60 Wind instrument and the ST60 Close Hauled Wind instrument are cal
Summary of the content on the page No. 14
2 ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Digital display The digital display shows the following wind and speed information: True/apparent wind speed. Velocity made good (VMG). Tack heading. Maximum wind speed. Wind alarm data. You can select which information is displayed. When power is first switched on, the digital display shows the same type of information as was selected when power was last turned off. Note: The TRUE and APP indicators flash for 8 seconds aft
Summary of the content on the page No. 15
Chapter 1: Operation 3 The flow charts show the sequence of key presses and displays for the various operating tasks. All key presses called for in the flow charts are momentary, unless otherwise stated. The type of data displayed (true or apparent) is indicated by a square marker on the digital display adjacent to either the TRUE or APP legend, as appropriate. Note: If boat speed information is not available on the SeaTalk bus when TRUE is select- ed, the digital display shows a series of
Summary of the content on the page No. 16
4 ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook True/Apparent Press the true/app key to toggle between true and apparent instrument readings. VMG Press the vmg key to show VMG information on the digital display. The pointer continues to show the wind direction (true or apparent as previously selected). If boat speed information is not available on SeaTalk, the VMG cannot be computed, and the digital display shows a series of dashes. Tack Press the tack key to show tack heading inf
Summary of the content on the page No. 17
Chapter 1: Operation 5 Setting alarm conditions The alarm threshold screens are accessed with the disp key (see the Using the disp key flow chart), and enable you to switch alarms on or off and set the alarm thresholds. The alarm threshold screens are: Maximum true wind speed alarm. Low true wind speed alarm. High apparent wind angle alarm. Low apparent wind angle alarm. To set up an alarm, carry out the Switching alarms on and off , and Setting alarm threshold procedures, as necessar
Summary of the content on the page No. 18
6 ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook 1.3 Display illumination When the instrument is first powered up, the display illumination is set to its lowest (courtesy) level, to facilitate initial access to the keys. To adjust the level of display illumination: 1. Hold down the disp key for approximately one second, to enter the illumina- tion-adjust mode. 2. There are four preset illumination levels. Momentarily press the disp key to cycle through these levels until you reach t
Summary of the content on the page No. 19
Chapter 2: Maintenance & Troubleshooting 7 Chapter 2: Maintenance & Troubleshooting 2.1 Maintenance Servicing and safety Raymarine equipment should be serviced only by authorized Raymarine ser- vice technicians. They will ensure that service procedures and replacement parts used will not affect performance. There are no user serviceable parts in any Raymarine product. Some products generate high voltages, so never handle the cables/connec- tors when power is being supplied to the equipment
Summary of the content on the page No. 20
8 ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook Cabling Examine all cables for chafing or other damage to the outer shield and, where necessary, replace and re-secure. 2.2 Troubleshooting Preliminary procedures Changes in the electronic environment may adversely affect the operation of your ST60 equipment. Typical examples of such changes are: Electrical equipment has recently been installed or moved aboard your vessel. You are in the vicinity of another vessel or shore station
