Summary of the content on the page No. 1
▲▲ Uniden Data 2000 Wireless CDPD PC Card
Contents
Section 1 - Uniden Data 2000 Introduction . . . . . . . . . . . . . . . .1-1
1.0 Getting Ready . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-1
1.3 What is the PCMCIA Standard for PC Cards? . . . . . . . . . . . . . .1-2
1.4 Product Highlights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-3
1.5 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 2
▲▲ Uniden Data 2000 Wireless CDPD PC Card 2.8.6 Adding TCP/IP Protocol Support . . . . . . . . . . . . . . . . . . . . . . . . . . .2-50 2.8.7 Connecting to the CDPD Network . . . . . . . . . . . . . . . . . . . . . . . . .2-51 2.9 Installation Procedures/Windows CE . . . . . . . . . . . . . . . . . . .2-52 2.10 Using Windows CE Remote Networking . . . . . . . . . . . . . . . . .2-53 2.10.1 Installing Remote Networking . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-53 2.10.2 Con
Summary of the content on the page No. 3
▲▲ Uniden Data 2000 Wireless CDPD PC Card Uniden Data 2000 Introduction 1 RAISE ANTENNA Caution - Before operating this device, be sure to place the antenna in the vertical position. This offers the best performance of your modem, and, at the same time, reduces the risk of possible exposure to electromagnetic radiation emanating from the antenna. The antenna must be maintained at least 4 inches (or 10 cm) from users and nearby persons to comply with FCC radio frequency exposure limits (and to
Summary of the content on the page No. 4
▲▲ Uniden Data 2000 Wireless CDPD PC Card 1.1 What is the Uniden Data 2000? The Uniden Data 2000 is a wireless CDPD (Cellular Digital Packet Data) PC Card which enables most laptops, hand held computers, and Personal Digital Assistants with Type II PC Card slots to communicate with host-based applications such as web servers, intranet servers, databases, dispatch systems, and other host computer systems. The Uniden Data 2000 uses the Internet suite of protocols running over the CDPD system. The
Summary of the content on the page No. 5
▲▲ Uniden Data 2000 Wireless CDPD PC Card In 1989, an international standards body and trade association was founded, called the PCMCIA (Personal Computer Memory Card International Association.). This organization was founded to establish standards for Integrated Circuit cards and to promote interchangeability among mobile computers where ruggedness, low power, and small size are critical. Even though PCMCIA is a rather young technology, it has been quickly adopted by every major personal compu
Summary of the content on the page No. 6
▲▲ Uniden Data 2000 Wireless CDPD PC Card 1.5 Package Contents ● Uniden Data 2000 Wireless CDPD PC Card: The physical module containing all of the electronic and other hardware elements. (Includes the battery compartment, antenna and PCMCIA interface connector.) The PC Board is protected by a clam shell structure made from a 2-piece plastic sub-frame, molded together with a stamped stainless steel cover. ● Uniden Data 2000 Setup CD-ROM and two floppy disks ● Uniden Data 2000 Installation and Ope
Summary of the content on the page No. 7
▲▲ Uniden Data 2000 Wireless CDPD PC Card 1.7 Battery Life Expectations The Uniden Data 2000 is powered by 4 AAA size alkaline batteries that, depending upon your application, should provide you with several days of use. Here is a matrix below that will give you an idea of the expected battery life in relation to the modem’s anticipated use: Data Usage: High Medium Light User: Information Business User Casual User Technology User Application: File Transfer Web Browsing Occasional e-mail Batter
Summary of the content on the page No. 8
▲▲ Uniden Data 2000 Wireless CDPD PC Card 1.8 Host Computer System Requirements Before you install the Uniden Data 2000 Setup and Installation software, please check your host computer to make sure that it meets or exceeds the following system requirements: Minimum requirements for MSWindows computer: ● PC with a 486/33DX or higher processor; Pentium 90 or higher recommended ● Microsoft Windows 95 or higher, or NT 4.0 with Service Pack 3 or higher installed ● 8 MB of RAM; 12 MB recommended ● 8
Summary of the content on the page No. 9
▲▲ Uniden Data 2000 Wireless CDPD PC Card Setting Up the Uniden Data 2000 2 This chapter explains how to set up the Uniden Data 2000 for operation with host computers running Windows 95/98, Windows NT and Windows CE. 2.1 Setup Preparation 2.1.1 Hardware Required for Uniden Data 2000 Setup ● A host terminal, (laptop or hand held computer). ● The Uniden Data 2000 Wireless CDPD PC Card. 2.1.2 Software Required for Uniden Data 2000 Setup One of the following operating systems is required: ● Window
Summary of the content on the page No. 10
▲▲ Uniden Data 2000 Wireless CDPD PC Card should be ready for use. If you have a problem or question, please review the manual or contact Technical Support at 1 (888) 6UNIDEN. Check the following: ● Has the Uniden Data 2000 host application loaded properly on the host computer? ● Have you established a CDPD data account with your cellular CDPD provider? ● Is there a Dial Up Networking Icon on your host computer for the Uniden Data 2000 . ● Have you configured the modem using UDConfig? ● Is your
Summary of the content on the page No. 11
▲▲ Uniden Data 2000 Wireless CDPD PC Card 2.2 Uniden Data 2000 Host Application Installation The Uniden Data 2000 host applications, UDConfig and UDInsight are distributed on a CD-ROM and floppy disks: the Uniden Data 2000 Setup and Installation CD-ROM and floppy disks. These applications must be downloaded to the host terminal, in order to set up the host applications to use with the Uniden Data 2000. To install and set up the UDConfig and UDConfig host applications, take the following steps: 1
Summary of the content on the page No. 12
▲▲ Uniden Data 2000 Wireless CDPD PC Card 6. Click Next. Note: Host application software needs to be installed once, (when you initially set up the Uniden Data 2000 for use with a particular host computer); however, you must repeat the installation process for each new host computer used with the Uniden Data 2000. 7. Click Next. 2-4
Summary of the content on the page No. 13
▲▲ Uniden Data 2000 Wireless CDPD PC Card 8. Enter the DNS of your provider. (See Section 2.1.3, Requesting Service Activation, for details.) 9. Click Finish to Restart Computer. Please go to the following section, depending on your host computer operating system. Section 2-3 If you are using Windows 95 Section 2-5 If you are using Windows 98 Section 2-7 If you are using Windows NT Section 2-9 If you are using Windows CE If the Host Applications (UD Config and Insight) have loaded successfully,
Summary of the content on the page No. 14
▲▲ Uniden Data 2000 Wireless CDPD PC Card 2.3 Installation Procedures/Windows 95 Follow the steps below to setup Dial-up Networking to connect your Uniden Data 2000 to the Internet. To install the Uniden Data 2000, take the following steps: 1. Insert the Uniden Data 2000 into the PC Card slot of the host terminal you are using. 2. Move the On/Off Power Switch to the ‘on’ position. The following dialog box displays on screen: 3. Click Next. 4. Insert Uniden Data 2000 Setup and Installation flop
Summary of the content on the page No. 15
▲▲ Uniden Data 2000 Wireless CDPD PC Card 5. The following dialog box displays on the screen: 6. Click Finish. The Location Information dialog appears. To check to see which COM port was selected during the setup process, take the following steps: 7. Click the Start button on your Windows 95 desktop, then select Settings, Control Panel. Uniden Data 2000 Installation and Operation Manual 2-7
Summary of the content on the page No. 16
▲▲ Uniden Data 2000 Wireless CDPD PC Card The following dialog box displays on the screen: 8. Double-click the Modems icon. The following dialog box displays on the screen: 2-8
Summary of the content on the page No. 17
▲▲ Uniden Data 2000 Wireless CDPD PC Card 9. Select Uniden Data 2000 PC Card from the modems listed in the dialog box. 10. Click Properties. The following dialog box displays on the screen. 11. The COM port that was selected during the setup process is displayed on the General tab. 12. Click OK. Uniden Data 2000 Installation and Operation Manual 2-9
Summary of the content on the page No. 18
▲▲ Uniden Data 2000 Wireless CDPD PC Card 2.3.1 Verifying the Connection The host computer should display a Uniden Data 2000 icon in the sys- tem tray when the PC Card has made a proper connection. If you do not see this icon on the screen, take the following steps to determine if your host computer has been set to display system tray icons. 1. Click the Start button on your Windows 95 desktop, then select Settings. Control Panel. 2. Double-click the PC Card (PCMCIA) icon. 2-10
Summary of the content on the page No. 19
▲▲ Uniden Data 2000 Wireless CDPD PC Card The following dialog box displays on the screen: 3. Select the Show control on task bar check box, then click OK. If you have verified that the host computer has been set to display system tray icons, and you do not see the Uniden Data 2000 icon in the system tray, then the Uniden Data 2000 has not made a proper connection. If the Host Applications (UD Config and Insight) have loaded successfully, go to Section 2.11 to configure the modem for use wi
Summary of the content on the page No. 20
▲▲ Uniden Data 2000 Wireless CDPD PC Card 2.4 Using Windows 95 Dial-Up Networking To use your Uniden Data 2000 modem with Windows 95 Dial-up Networking, take the following steps: 2.4.1 Checking Dial-Up Networking Installation To determine if dial-up networking is already installed, double-click on the My Computer icon. If you don't see an icon for Dial-Up Networking, you will need to add this feature: 2.4.2 Installing Dial-Up Networking. If Dial-Up Networking is not installed, follow these step
