Juniper Networks J4300 user manual

Summary of the content on the page No. 1

J4300 and J6300 Services Router PIM
Installation Instructions
4 November 2004
Part No: 530-011519-01
Revision 1
This document describes how to remove and replace a Physical Interface Module
(PIM) on Juniper Networks J4300 and J6300 Services Routers. For hardware
installation and basic troubleshooting procedures for J-series Services Routers, see
the J-series Services Router User Guide.
Contents
ToolsandPartsRequired........................................................... 2
ReplacingaPIM......

Summary of the content on the page No. 2

J4300 and J6300 Services Router PIM Installation Instructions Tools and Parts Required To replace a component, you need the following tools and parts: Electrostatic bag or antistatic mat Electrostatic discharge (ESD) grounding wrist strap Phillips (+) screwdriver, number 2 Replacing a PIM Physical Interface Modules (PIMs) in J4300 and J6300 Services Routers are field replaceable. The router must be powered off before the PIMs are removed or installed. This section contains the following topics:

Summary of the content on the page No. 3

7. Loosen the captive screws on each side of the PIM faceplate. 8. Grasp the handles on each side of the PIM faceplate and slide the PIM out of the router. Place it in the electrostatic bag or on the antistatic mat. 9. If you are not reinstalling a PIM into the emptied slot, install a blank PIM panel over the slot to maintain proper airflow. Figure 1: Removing a PIM Captive screws Installing a PIM To install a PIM (see Figure 2): 1. Attach an electrostatic discharge (ESD) grounding strap to your

Summary of the content on the page No. 4

J4300 and J6300 Services Router PIM Installation Instructions 4. Tighten the captive screws on each side of the PIM faceplate. 5. Insert the appropriate cables into the cable connectors on the PIM. 6. If necessary, arrange the cables to prevent them from dislodging or developing stress points: Secure the cable so that it is not supporting its own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop. Use fasteners to maintain the shape of cable loops. 7. Pres

Summary of the content on the page No. 5

Table 1: Juniper Networks Technical Documentation Book Description JUNOS for J-series, M-series, and T-series Routing Platforms Configuration Guides Feature Guide Provides a detailed explanation and configuration examples for several of the most complex features in the JUNOS software. System Basics Provides an overview of the JUNOS software and describes how to install and upgrade the software. This manual also describes how to configure system management functions and how to configure the chass

Summary of the content on the page No. 6

J4300 and J6300 Services Router PIM Installation Instructions Book Description JUNOS Comprehensive Index and Glossary Comprehensive Index and Glossary Provides a complete index of all JUNOS Internet software books and the JUNOScript API Guide. Also provides a comprehensive glossary. Hardware Documentation Hardware Guide Describes how to install, maintain, and troubleshoot routers and router components. Each platform has its own hardware guide. PIC Guide Describes the router Physical Interface Ca

Summary of the content on the page No. 7

Revision History 4 November 2004—Revision 1. Copyright © 2004, Juniper Networks, Inc. All rights reserved. Juniper Networks, the Juniper Networks logo, NetScreen, NetScreen Technologies, the NetScreen logo, NetScreen-Global Pro, ScreenOS, and GigaScreen are registered trademarks of Juniper Networks, Inc. in the United States and other countries. The following are trademarks of Juniper Networks, Inc.: ERX, ESP, E-series, Instant Virtual Extranet, Internet Processor, J2300, J4300, J6300, J-Protect