Invacare Non-Removable Device 1820 user manual

Summary of the content on the page No. 1

Non-Removable Device
Assembly, Installation and Operating Instructions
Model No. 1820
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe installation of the non-removable device, these instructions
MUST be followed:

WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings,

Summary of the content on the page No. 2

3. Follow one of the following instructions: • Footrest - Position the clamp tab over the lower hinge pin of the footrest (Detail “A”). • Elevating Legrest - Position the clamp tab over the upper hinge pin of the elevating legrest (Detail “B”). 4. Squeeze the clamp together with pliers to secure around front frame tube. NOTE: The clamp MUST be positioned on the front frame tube to allow the swingaway front rigging to operate properly. 5. Install the lug bolt through the clamp from the inside

Summary of the content on the page No. 3

DETAIL “A” - FOOTREST Inside of Lug Bolt Wheelchair Front Frame Frame Tube Locknut Clamp Upper Clamp Tab Hinge Plate Lower Hinge Pin Swingaway Front Rigging Lower Hinge Plate DETAIL “B” - ELEVATING LEGREST Front Frame Inside of Tube Wheelchair Lug Bolt Frame Locknut Clamp Clamp Tab Swingaway Front Rigging Upper Hinge Pin Upper Hinge Plate FIGURE 1 Installing Non-Removable Device Part No 1076733 3 Non-Removable Device

Summary of the content on the page No. 4

Invacare Corporation www.invacare.com USA Canada One Invacare Way 570 Matheson Blvd. E Unit 8 Invacare, the Medallion Design, and Elyria, Ohio USA Mississauga Ontario Yes, you can. are registered 44036-2125 L4Z 4G4 Canada trademarks of Invacare Corporation. 800-333-6900 800-668-5324 ©2006 Invacare Corporation Part No 1076733 Rev C - 2/8/06 MADE IN MEXICO