Summary of the content on the page No. 1
4/8-Port H.323/SIP VoIP Gateway
VIP-480/VIP-880 Series
User’s manual
Summary of the content on the page No. 2
Copyright Copyright (C) 2006 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable for
Summary of the content on the page No. 3
Revision User’s Manual for PLANET 4/8-Port H.323/SIP VoIP Gateway: Model: VIP-480/VIP-480FS/VIP-480FO/VIP-880/VIP-882/VIP-880FO Rev: 10 (September, 2006) Part No. EM-VIP480_880V1 3
Summary of the content on the page No. 4
TABLE OF CONTENTS Chapter 1 Introduction ......................................................................... 6 Overview............................................................................................................................6 Package Content ...............................................................................................................8 Physical Details ...............................................................................................
Summary of the content on the page No. 5
Access Control..........................................................................................................49 Set To Default Configuration....................................................................................49 Backup/Restore Configuration to a File ...................................................................50 System Information Display Function......................................................................50 SNTP Setting Function....................
Summary of the content on the page No. 6
1 Chapter 1 Introduction Overview With years of Internet telephony and router manufacturing experience, PLANET proudly introduces the newest member of the PLANET VoIP gateway family: the VIP-480/VIP-880 series. The PLANET VoIP Gateway is fully both SIP and H.323 standard compliant residential gateway that provides a total solution for integrating voice-data network and the Public Switched Telephone Network (PSTN), not only provides quality voice communications, but also offers sec
Summary of the content on the page No. 7
There are models for VIP-480/VIP-880 and there are: 4-port model, VIP-48nxx: VIP-480 equips two FXO and two FXS interfaces to have the great flexibility of PBX connection (FXO), and telephone or FAX machine connection (FXS). VIP-480FS equips four FXS interfaces telephone set or FAX machine connections (FXS). VIP-480FO equips four FXO interfaces to have the great flexibility of PBX connection (FXO). 8-port mode, VIP-88nxx: VIP-880 equips four FXO and four FXS interfaces to have the gre
Summary of the content on the page No. 8
VoIP Functions · H.323 / SIP dual mode communication · SIP 2.0 (RFC3261), H.323v4 compliant · Peer-to-Peer / H.323 GK / SIP proxy calls · Voice codec support: G.711(A-law / -law), G.729 AB, G.723 (6.3 Kbps / 5.3Kbps) · Voice processing: Voice Active Detection, DTMF detection, G.165/G.168 compliant echo canceller, silence detection, FAX (T.38 / T.30) Mode Option. · Built in adaptive buffer that helps to smooth out the variations in delay (jitter) for voice traffic. · Voice channels stat
Summary of the content on the page No. 9
Front Panel of VIP-480FO Rear Panel of VIP-480 Rear Panel of VIP-480FS Rear Panel of VIP-480FO Front Panel of VIP-880 Front Panel of VIP-882 Front Panel of VIP-880FO 9
Summary of the content on the page No. 10
Rear Panel of VIP-880 Rear Panel of VIP-882 Rear Panel of VIP-880FO Front Panel LED Indicators & Rear Panels Front Panel LED State Descriptions PWR On GW is power ON Off GW is power Off CPU The system is running Flashing WAN Port ON GW network connection established Flashing Data traffic on cable network Off Waiting for network connection LAN Port ON LAN is connected successfully Flashing Data is transmitting Off Ethernet not connected to PC FXS ON Te
Summary of the content on the page No. 11
NOTE: System initialization will turn some LEDs ON for a few seconds. Rear Panel Descriptions WAN The WAN port supports auto negotiating Fast Ethernet 10/100Base-T networks. This port allows your voice gateway to be connected to an Internet Access device, e.g. router, cable modem, ADSL modem, through a CAT.5 twisted pair Ethernet cable. LAN The LAN port supports 4 10/100Base-T switch hub networks. These 4 (VIP-880 series) ports allow your PC or Switch/Hub to be connected to the voice gat
Summary of the content on the page No. 12
Chapter 2 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-480/VIP-880 series · Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. · TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem (for WAN port usage) Administration Interface PLANET VIP-480/VIP-880 provides GUI (Web based, Graphical User Int
Summary of the content on the page No. 13
Please locate your PC in the same network segment (192.168.0.x) of VIP-480/880. If you’re not familiar with Note TCP/IP, please refer to related chapter on user’s manual CD or consult your network administrator for proper network configurations. LAN/WAN Interface quick configurations Nature of PLANET VIP-480/VIP-880 is an IP Sharing (NAT) device, it comes with two default IP addresses, and default LAN side IP address is “192.168.0.1”, default WAN side IP address is “172
Summary of the content on the page No. 14
Parameter Description LAN IP address of VIP-480/VIP-880 IP address Default: 192.168.0.1 LAN IP address of VIP-480/VIP-880 Subnet Mask Default: 255.255.255.0 It is suggested to keep the DHCP server related parameters Hint in default state to keep machine in best performance. After confirming the modification you’ve done, Please click on the Apply button to macke the changes effective, and click “Save Configuration” to save configuration. WAN IP address configurat
Summary of the content on the page No. 15
3 Chapter 3 Network Service Configurations Configuring and monitoring your VoIP Gateway from web browser The VIP-480/VIP-880 integrates a web-based graphical user interface that can cover most configurations and machine status monitoring. Via standard, web browser, you can configure and check machine status from anywhere around the world. Overview on the web interface of VoIP Gateway With web graphical user interface, you may have: More comprehensive setting feels than traditiona
Summary of the content on the page No. 16
VIP-480/VIP-880 main page Wizard Setup for Quick Start Wizard Setup After finishing the authentication, the Main menu will display 3 parts of configuration, please click “Wizard Setup” to enter quick start: 1. WAN Port Type Setup (Setup First) For most users, Internet access is the primary application. The Gateway support the WAN interface for Internet access and remote access. The following sections will explain more details of WAN Port Internet access and br
Summary of the content on the page No. 17
ADSL Dial-Up User (PPPoE Enable) Some ISPs provide DSL-based service and use PPPoE to establish communication link with end-users. If you are connected to the Internet through a DSL line, check with your ISP to see if they use PPPoE. If they do, you need to select this item. Three methods are available for Internet Access User Name Enter User Name provided by your ISP Password Enter Password provided by your ISP Retype Password Enter Password to confirm again DHCP Client
Summary of the content on the page No. 18
2. Configuring NAT or Bridge setting: Bridge Mode: When working on Bride Mode, the VoIP gateway will use only the LAN setting IP, The VoIP gateway will use the same LAN IP setting as WAN IP. That means, when Bride mode enable, the WAN connection setting will be ignored. NAT mode: LAN IP Network Configuration Private IP address for connecting to a local private network IP Address (Default: 192.168.0.1) Netmask for the local private network Subnet Mask (Default: 255.255.255.0)
Summary of the content on the page No. 19
STEP2 : configure the numbering with phone/line ports. The representation number is the phone number of the Phone Number telephone that is connected to Phone port Line ports are connected to the extension ports of the PBX system or the PSTN line. They have a common Line Hunting Group Number. When this number is dialed, the Gateway system will find a free FXO line connected to Line Number PBX. This hunting will skip all busy lines and absent lines and find only the idle line to the PBX
Summary of the content on the page No. 20
In the “Outgoing Dial Plan” settings: “Leading Number” is the leading digits of the dialing number. “Min Length” and “Max Length” is the min/max allowed length you can dial. “Strip Length” is the number of digits that will be stripped from beginning of the dialed number. “Prefix Number” is the digits that will be added to the beginning of the dialed number. “Destination” is the IP address of the destination Gateway that owns this phone number. STEP 5: Finishing the Wizard Setup
