Summary of the content on the page No. 1
Contents
1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 36
2. INSTALLATION OF THE APPLIANCE________________________ 38
3. ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 40
4. FINAL OPERATIONS_____________________________________ 42
5. DESCRIPTION OF CONTROLS ____________________________ 44
6. USE OF THE COOKING HOB ______________________________ 51
7. USE OF THE OVEN______________________________________ 52
8. AVAILABLE ACCESSORIES _______________________________ 54
9.
Summary of the content on the page No. 2
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTI
Summary of the content on the page No. 3
Introduction DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT INSTALL THIS APPLIANCE ON A RAISED PLATFORM. THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND BRAND NAME IS POSITIONED VISIBLY IN THE STORAGE COMPARTMENT. THE PLATE MUST NOT BE REMOVED. DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE COOKING HOB GRIDS. NEVER USE THE COOKING HOB AS A WORK SURFACE. DO NOT USE CONTA
Summary of the content on the page No. 4
Instructions for the installer 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990. It may be installed against walls one of which is higher than the worktop surface, at least 50 mm from the side of the a
Summary of the content on the page No. 5
Instructions for the installer The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance. 2.2 2.3 Ventilation requirements The room containing the appliance should have an air supply in accordance with B.S. 5440 part 2 1989. 1. All rooms require an opening window or equivalent, and some rooms will require a permanent vent as well. 3 2 2. For room v
Summary of the content on the page No. 6
Instructions for the installer 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The cooker hob is set for natural gas G20 (2H) at a pressure of 20 mbar. In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flame adjusted on the gas taps. To change the nozzles, proceed as described below. 3.1 Replacement of nozzles on the hob This
Summary of the content on the page No. 7
Instructions for the installer 3.2 Burner and nozzle characteristics table Rated Burner heating LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1.05 50 30 400 76 75 Semi-rapid 1.8 65 33 500 131 129 Rapid 3 85 45 800 218 215 Triple crown 4.0 100 65 1600 290 286 Fish pan 1.9 68 45 800 138 136 Rated heating Burner capacity NATURAL GAS – G20 20 mbar (kW) Nozzle
Summary of the content on the page No. 8
Instructions for the installer 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. After adjustment to a different kind of gas from the one for which the cooker has been tested, replace the plate inside the storage compartment with one corresponding to the new kind of gas. This plate can be obtained from your nearest Authorised Assistance Centre. 4.1 Adjustment of minimum for natural gas Light the burner an
Summary of the content on the page No. 9
Instructions for the installer 4.3 Positioning and levelling of the appliance Having carried out the electricity and gas hook-up, level the appliance using the four adjustable legs. 4.4 Mounting the rear top upstand • Position the upstand above the top, taking care to align holes A with holes B. • Secure the upstand to the top by tightening screws C. 43
Summary of the content on the page No. 10
Instructions for the user 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel. DESCRIPTION OF SYMBOLS REAR RIGHT-HAND OVEN THERMOSTAT COOKING ZONE FRONT RIGHT-HAND OVEN FUNCTIONS COOKING ZONE FRONT LEFT-HAND FISH COOKING ZONE COOKING ZONE REAR LEFT-HAND FRONT CENTRAL COOKING ZONE COOKING ZONE THERMOSTAT KNOB Selection of cooking temperature is carried out by turning t
Summary of the content on the page No. 11
Instructions for the user NO FUNCTION SET LOWER HEATING ELEMENT + VENTILATION UPPER AND LOWER LOWER HEATING HEATING ELEMENT ELEMENT + VENTILATED HEATING ELEM. UPPER AND LOWER VENTILATED HEATING ELEMENT + HEATING ELEMENT + VENTILATION VENTILATION GRILL ELEMENT DEFROSTING GRILL ELEMENT + VENTILATION COOKING HOB BURNER COMMAND KNOB To light the flame, press and turn the knob anticlockwise to the large flame symbol. Adjust
Summary of the content on the page No. 12
Instructions for the user 5.2 Analog Programmer 5.2.1 Regolazione dell'ora To set the correct time, pull out the knob A and turn it clockwise. Before setting programmer, select desired cooking mode and temperature. 5.2.2 Timed cooking Select the function and temperature required before setting the cooking duration. Now pull the knob A out and turn it clockwise to locate the minute minder hand C aligned with the hour hand. Now turn the knob A clockwise to set the coo
Summary of the content on the page No. 13
Instructions for the user 5.3 Electronic Analogue Clock (on some models only) LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC SWITCH-OFF TIMING BUTTON TIME SETTING AND RESET VALUE DECREASE BUTTON VALUE INCREASE BUTTON 5.3.1 Setting the time When the oven is used for the first time, or after a power blackout, the display flashes on and off at regular intervals. Press the key for 1/2 seconds to stop the display flashing and start sett
Summary of the content on the page No. 14
Instructions for the user 5.3.2 Minute-minder This function does not stop cooking but just triggers the beeps. - When the key is pressed the display illuminates, appearing as shown in figure 1; - Press the or keys within 6/7 seconds to set the minute-minder. Whenever a key is pressed, 1 outside segment, representing 1 1 cooking minute will light up (figure 2 shows 10 cooking minutes). - The countdown will start 6/7 seconds after the last key is pressed; at the end of it,
Summary of the content on the page No. 15
Instructions for the user 5.3.3 Programming nd Cooking duration time: the 2 button can be used to set the cooking time. Before setting it, turn the thermostat to the cooking temperature of choice and the function selector knob to any setting. To set the cooking time, proceed as follows: - Press the key for 1/2 seconds; the pointer will move to position 12 (Fig. 1). - Use the and keys to set the cooking time; whenever the key is pressed, 1 minute will be added to the c
Summary of the content on the page No. 16
Instructions for the user Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows. - Set the cooking duration time as described in the previous point. - Within 6/7 seconds after the last time the or keys are pressed, press the key to set the cooking start time. The display will show the current time with the inside segments indicating th
Summary of the content on the page No. 17
Instructions for the user 6. USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. Grid B should be used with Chinese woks. Each knob corresponds to the burner indicated. The appliance is equipped with an electric lighting devi
Summary of the content on the page No. 18
Instructions for the user 6.2 Practical advice for using the cooking hob burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “6.3 Diameter of containers"). When water reaches the boiling point, lower the flame so that it doesn’t overflow. To avoid burns or damage to the hob, all recipients or griddle plates must be placed within the perimeter of
Summary of the content on the page No. 19
5 cm Instructions for the user To prevent any steam in the oven creating problems, open the door in two stages: half open (5 cm approx.) for 4-5 seconds and then fully open. To access food, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food. During cooking, do not cover the bottom of the oven with aluminium or tin foil, and do not place pans or trays on it; this may damage the enamel coating.
Summary of the content on the page No. 20
Instructions for the user 8. AVAILABLE ACCESSORIES The oven features 4 support positions for plates and racks of different height. Oven grill: for cooking food on plates, small cakes, roasts or food requiring light grilling. Plate grill: for placing above plate for cooking foods that might drip. Oven plate: useful for catching fat from foods on the grill above. Pastry plate: for baking cakes, pizza and oven desserts. Roasting spit: useful for cooking
