Summary of the content on the page No. 8
Important Safeguards 17 Upon completion of any service or repairs to the LCD Projector, ask the service technician to perform a routine safety check to determine that the LCD Projector is in safe operating condition. 18 When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards. 19 Air filter sh
Summary of the content on the page No. 9
Important Safeguards IMPORTANT: THE MOULDED PLUG (U.K. only) FOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a remov
Summary of the content on the page No. 10
Important Safeguards WARNING: THIS APPLIANCE MUST BE EARTHED. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Green-and-Yellow: Earth Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter
Summary of the content on the page No. 11
LCD Projector Features 1 Compact & Lightweight A compact, lightweight liquid crystal projector with the mobility for mobile presentations as well. 2 Built-in Simple Stand The Built-in Simple Stand makes it possible to match the projection angle with the basic use environment of your office with one-touch ease. 3 Attachable/Removable Swivel Stand Flexible settings are possible because the projected image height and left/right tilt can be adjusted freely. 4 One-touch Auto Setup One-touch image adj
Summary of the content on the page No. 12
LCD Projector Features 7 Accommodates all International Broadcast Video Signal Formats The LCD Projector accepts NTSC/PAL/SECAM/PAL-M/ PAL-N/NTSC4.43 video signal formats. 8 Digital Zoom and Freeze Feature With remote control operation, you can display a enlarged portion of the screen up to 5 times. You can also display a freeze frame (paused) screen. 9 On-board Card Type Wireless Remote Control Keys necessary for basic operation have been simply arranged on this compact remote control which can
Summary of the content on the page No. 13
LCD Projector Features 13 Image Quality Select Feature, R/G/B Level Adjust Feature With the Image Quality mode switch (Dynamic/ Natural) you can also fine-adjust the white balance of the projected image. 14 Frontal Air Vent Design Vented air will not blow on persons located to the side or in rear of the projector and light leakage will not be a problem with the Frontal Air Vent design. Equipped with a variety of convenient functions A variety of functions such as the following have been provided
Summary of the content on the page No. 14
Contents of LCD Projector Box Please confirm that the following items are packed in the LCD Projector box. They are provided to help you use or set up your LCD Projector. (1) LCD Projector (2) Wireless Remote Control Unit (3) CR2025 Lithium Battery (Included with the remote control unit) (4) 2.44 m Power Cord (LX-P1010ZE only) (5) 2.35 m Power Cord (LX-P1010ZE only) (6) 2.99 m Power Cord (LX-P1010ZU only) (7) Computer Cable (mini D-Sub15 pin) (8) Video Cable (9) Audio Cable (10) Lens Cap (Includ
Summary of the content on the page No. 15
Product Information LCD Projector Labels on the unit are omitted. Top, right and front (In case Swivel stand is installed.) Zoom Ring Air Outlet Port Focus Ring Air Filter Remote Control Swivel Stand Sensor (Supplied) Back and bottom Remote Control unit Speaker EJECT Knob Air Inlet Port Remote Control unit AC Socket Holder Remote Security Lock Control Sensor Simple Stand Hole for Lamp Swivel Stand Cover Installation Previous 15 screen
Summary of the content on the page No. 16
Product Information LCD Projector Control panel POWER Indicator POWER Button STATUS Code STANDBY(RED) Indicator ON(GREEN) STATUS INPUT POWER Button Adjust Buttons INPUT (Also used for KEYSTONE KEYSTONE Volume -/+) ENTER Button MENU MENU ENTER Button Button Previous 16 screen
Summary of the content on the page No. 17
Product Information LCD Projector Connector panel S-VIDEO IN RS232C RGB/YPBPR IN AUDIO IN VIDEO IN S-Video SERIAL RGB/YPBPR Audio Video Input Connector Input Input Input Connector Connector Connector Connector Note The serial connector which is on the terminal board of the projector conforms to the RS-232C interface specification, so that the projector can be controlled by a personal computer which is connected to this connector. Consult your dealer or nearest JVC representative for details. P
Summary of the content on the page No. 18
Product Information Remote Control unit Transmitter POWER INPUT INPUT POWER Button Button SHUTTER AUTO SETUP SHUTTER AUTO SETUP Button Button MENU , , , MENU Buttons Button VOLUME ENTER ENTER VOLUME Button -/+ Buttons FREEZE D.ZOOM FREEZE D.ZOOM Button Button Battery Holder Previous 18 screen
Summary of the content on the page No. 19
Before using the Remote Control Unit Remote Control comes with battery inside. Please remove white protective film before use. Replacing the battery Insert the new lithium battery making sure the polarities (+) and (-) are correct. WARNING: Replace battery with CR2025 only. Use of another battery may present a risk of fire or explosion. Caution: Battery may explode if mistreated. Dispose of used battery promptly. Keep away from children. Do not recharge, disassemble or dispose of in fire. 1 Wh
Summary of the content on the page No. 20
Before using the Remote Control Unit Operating range If the remote control unit is held so that it is facing directly in front of the front or rear remote control signal receptors, the operating range is within approximately 7 m (23 ft) from the surfaces of the receptors. Furthermore, the remote control unit can be operated from an angle of ±30 º to the left or right and ±15 º above or below the receptors. (In this case, the operating range is shortened.) 30° 30° 30° 30° approximately appr
Summary of the content on the page No. 1
LCD PROJECTOR
Operating Instructions
Model No.
LX-P1010ZU/
LX-P1010ZE
Please read these instructions completely before operating
this LCD Projector.
By clicking on the red highlighted words in this document, you
can go directly to a support page.
Top page
Summary of the content on the page No. 2
Dear JVC Customer: This instruction manual provides all the necessary operating information that you might require. We hope it will help you to get the most performance out of your new product, that you will be pleased with your JVC LCD Projector. For your own protection and prolonged operation of your LCD Projector, please be sure to read the “Important Safeguards” carefully, before use. Things You Should Know Caution: This equipment has been tested and found to comply with the limits for a Cla
Summary of the content on the page No. 3
Things You Should Know Declaration of Conformity (USA only) Model Number: LX-P1010ZU/LX-P1010ZE Trade Name: Responsible party: PSEL Dept. JVC America Corp. Address: 1700 Valley Road Wayne,N.J 07407 Telephone number: (973) 315-5000 This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired oper
Summary of the content on the page No. 4
Important Safeguards CAUTION: Please read all of these instructions before you operate your LCD Projector. Save these instructions for future reference. Machine Noise Information Ordinance 3. GSGV, January 18, 1991: The sound pressure level at the operator position is equal or less than 44 dB (A) according to ISO 7779. (However, this is when the ambient temperature is less than 30 °C.) Electrical energy can perform many useful functions. This LCD Projector has been engineered and manufactured t
Summary of the content on the page No. 5
Important Safeguards 4 Do not use the LCD Projector near water; for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc. Never spill liquid into the LCD Projector. 5 Do not place the LCD Projector on an unstable cart, stand, or table. The LCD Projector may fall, which may cause serious injury to a child or an adult, and/or serious damage to the unit. Use only with a cart or stand recommended by its manufacturer, as being suitable for use wit
Summary of the content on the page No. 6
Important Safeguards 8 The LCD Projector should be operated only from the type of power source indicated on the back of the LCD Projector or in the specifications. If you are not sure of the type of power supplied to your home, consult your LCD Projector dealer or local power company. 9 Do not allow anything to rest on the power cord. Do not place the LCD Projector where the cord will be walked on. 10 Follow all warnings and instructions marked on the LCD Projector. 11 As a safety feature, the L
Summary of the content on the page No. 7
Important Safeguards 14 Never push objects of any kind into the LCD Projector through cabinet slots as they may touch dangerous voltage points or short out parts, which could result in a fire or electric shock. 15 Do not attempt to service the LCD Projector yourself. Opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 16 Unplug the LCD Projector equipment from the wall outlet and refer servicing to qualified service
