Code Alarm CA 411 user manual

Summary of the content on the page No. 1

Remote Vehicle Control System
CA 411
Owner's Manual
Remote Vehicle Starter
IMPORTANT NOTE: The operation of the Security and Convenience System as
described in this manual is applicable to most vehicles. However, due to the
configuration of some vehicles, some functions AND/OR SAFETY
PRECAUTIONS may not apply. Please see your installing dealer for more
information.
Page 1

Summary of the content on the page No. 2

This Remote Start Upgrade system can be wired to operate from any unused button(s) from your transmitter. Please check with your installing dealer for which transmitter button is connected to your remote start system, and if you require a single, double, or sequential press of the button(s) to operate your system. SAFETY (Red Handled ) CONTROL SWITCH: The control switch allows you to temporarily disable the remote starting function of your Remote Start system. To disable the unit, move the red

Summary of the content on the page No. 3

run timer if you complete any of the following: 1. Pressing the proper button or buttons of your transmitter while running under control of the remote start system will turn the vehicle off. 2. Depress the vehicle's brake pedal. 3. Open the hood. 4. Move the red handled control switch to the OFF position. 5. Race the engine to above 4000 RPM. OPERATING ON AUTOMATIC START TIMER MODE: The system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This featu

Summary of the content on the page No. 4

ADJUSTING THE START TIMER FROM 2 TO 4 HOURS: The SAFETY (Red Handled ) CONTROL SWITCH also allows you to select be- tween automatic 2 hour start or 4 hour start when using the automatic start timer mode. The factory preset start up time for this mode is every 4 hours. To select between 2 or 4 hour start timer: 1. Begin with the saftey control switch in the ON position. 2. Turn the ignition switch ON then OFF. 3. Within 10 seconds, move the control switch OFF,ON,OFF,ON(2 switch cycles) to sele

Summary of the content on the page No. 5

Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGI- NALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts d

Summary of the content on the page No. 6

Code Systems, Inc. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for compliance coul