Summary of the content on the page No. 1
Summary of the content on the page No. 2
** ** ** ** ** Notice ** Copyright (Copyright © 2001 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty The information in this document is subject to change without notice. HUMAX does not have any responsibility for direct, indirect, accidental, necessary and other corruptions due to your offer or use of the information contained in this manual. ** Trademarks V
Summary of the content on the page No. 3
** ** ** ** ** Notice ** Read this manual carefully and make sure you understand the provided instructions. For your safety, know what the reaction upon each action will be. ** Warnings, Cautions and Notes Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. ** Warning ** Indicates a hazardous situation which, if not avoided, could result in (serious) injury. ** Caution ** Indicates a situation which, if not avoided, could damage the e
Summary of the content on the page No. 4
** ** ** ** ** Safety and Warning ** This digital terrestrial receiver has been manufactured to satisfy international safety standards. Please read the following safety precautions carefully. ** Safety Instructions and Precautions ** 1. MAINS SUPPLY ** 90 - 250V AC 50/60Hz Operate your product only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult local power company. Disconnect the receiver from the mains before
Summary of the content on the page No. 5
** ** ** ** ** Safety and Warning ** 10.LOCATION ** Place the receiver indoors to avoid exposing it to lightening, rain or sun. Do not place it near a radiator or heat register. Make sure it has more than 10 cm clearance from any appliances susceptible to electromagnetic influences, such as TV and VCR. Do not block these openings with any object, and do not place the product on a bed, sofa, rug, or other similar surface. If you place the product on a rack or bookcase, ensure that there is adequa
Summary of the content on the page No. 6
** ** ** ** ** Contents ** 1. Before Using the Receiver GB7 ** 1.1 Package Contents GB7 1.2 Front Panel GB8 1.3 Rear Panel GB9 1.4 Remote Control GB10 2. Setup GB12 ** 2.1 Connecting Aerial GB12 2.2 Powering On GB14 3. Installation Wizard GB15 4. Basic Operation GB16 ** 4.1 Switching Channel GB16 4.2 Volume Control GB16 4.3 Text and interactive services GB16 4.4 Change the Subtitle Language GB17 4.5 Change a Audio Language GB17 ** ** 4.6 Programme Information (I- plate) GB18 4.7 Option List GB20
Summary of the content on the page No. 7
** ** ** ** ** Contents ** 7. Setting Preferences GB35 ** 7.1 Parental Control GB35 7.2 Language Setting GB37 7.3 Time Setting GB38 7.4 Schedule GB40 7.5 A/V Control GB40 7.6 UHF Tuning GB42 7.7 Miscellaneous Settings GB43 8. Installation GB44 ** 8.1 Automatic Search GB44 8.2 Manual Search GB45 8.3 Default Setting GB47 9. Software Update GB48 ** 9.1 OTA (Over the Air) GB48 9.2 S/W Update from PC GB51 ** ** 10. System Information GB52 ** 10.1 Status GB52 10.2 Signal Detection GB52 11. GAMES GB53
Summary of the content on the page No. 8
** ** ** ** ** 1.Before Using the Receiver ** This chapter describes detail instructions on the product and its accessories. 1.1 Package Contents Please check all package contents before using your receiver. ** ** ** ** Remote Control (1) User's Manual (1) Batteries (2) Scart Cable (1) ** Note: Since faults may occur if the remote control is being left without a battery for a long time, always keep the battery inserted in the remote control. ** ** GB 7 ** ** ** ** ** **
Summary of the content on the page No. 9
** ** ** ** ** 1. Before Using the Receiver ** 1.2 Front Panel ** 1. STANDBY Button ** Switches between Operation and Standby modes. 2. TV/RADIO Button ** Switches between TV and Radio. 3. CH-/CH+ ** Moves the TV/Radio channel up/down. 4. STANDBY LED ** Red light is displayed when the product is in the Standby mode. ** Green light is displayed when the product is in operation. ** 5. TV LED ** Green light is displayed when the receiver is in TV mode. 6. RADIO LED ** Amber light is displayed when
Summary of the content on the page No. 10
** ** ** ** ** ** ** 1.3 Rear Panel ** 1. ANTENNA IN ** Connects a aerial to a ANTENNA input jack on the your receiver. ** 2. TV / VCR ** Connects a RF signal from your receiver to RF (ANT) input jack on your TV or VCR. ** 3. TV SCART ** Connects a TV SCART cable. 4. VCR SCART ** ** ** Connects a VCR SCART cable. 5. AUDIO L/R ** Connects to your TV or VCR and output Audio signals. 6. VIDEO ** Connects to your TV or VCR and output Video signals. 7. RS-232C ** Connects to your PC to upgrade produc
Summary of the content on the page No. 11
** ** ** ** ** 1. Before Using the Receiver ** 1.4 Remote Control ** ** ** 1. DTV 7. COLOR BUTTONS (R/G/Y/B) 13. TV/RADIO 18. V-/V+ 2. TV 8. CH-/CH+(PAGE-/PAGE+) 14. STANDBY 19. MUTE 3. NUMERICAL BUTTONS 9. MENU 15. GUIDE 20. I (INFORMATION) 4. LIST 10. TEXT 16. EXIT 21. SUBTITLE 5. BACK 11. SOUNDTRACK 17. OK 22. AUX 6. ARROW BUTTONS 12. OPT+ (OPTION) ** ** GB 10 ** ** ** ** ** **
Summary of the content on the page No. 12
** ** ** ** ** ** ** 1. DTV 12.OPT+ (OPTION) ** ** Controls the Receiver. Displays the channel attributes during ** watching a programme. ** 2. TV ** 13.TV/RADIO Controls the TV. ** ** Switches between TV and Radio 3. NUMERICAL BUTTONS modes. ** ** Enters a TV/Radio channel number or 14.STANDBY menu option number. ** ** Switches between Operation and 4. LIST Standby modes. ** ** Displays the channel list. 15.GUIDE ** ** 5. BACK Displays the Programme Guide. ** ** Returns to the previous menu and
Summary of the content on the page No. 13
** ** ** ** ** 2. Setup ** This chapter describes how to set up the receiver. Select the most appropriate procedure depending on your case. Note: If you encounter any problem when setting up the receiver, please contact your local product distributor. Where possible, use an outdoor roof aerial intended for receiving UHF channels between 21 and 69. It is not advisable to use indoor or window mounted aerials, as digital channels will be difficult or even impossible to receive. 2.1 Connecting Aeria
Summary of the content on the page No. 14
** ** ** ** ** ** ** 2. Connecting Hi-Fi system 1 Connect the outputs on this receiver to corresponding inputs on your Hi-Fi system.( left audio out to left audio in, right audio out to right audio in) 3. Connecting Hi-Fi system 2 ** ** If you wish to connect the optical S/PDIF terminal and Dolby digital decoder to listen digital audio, connect as following. ** ** GB 13 ** ** ** ** ** **
Summary of the content on the page No. 15
** ** ** ** ** 2. Setup ** 2.2 Powering On 1. Connect the power cord of the receiver to a wall outlet. 2. Power on by pressing the STANDBY button at Remote Controller. The Standby LED indicator is turned on Green. ** ** ** ** GB 14 ** ** ** ** ** **
Summary of the content on the page No. 16
** ** ** ** ** 3. Installation Wizard ** When powering on your receiver for the first time after purchasing, the Installation Wizard is automatically started. It immediately performs Channel Search.(You can run the Installation Wizard in Default Setting.) Please wait for finishing the Channel Search. If you want to stop the Channel Search, select the OK button. If the Channel Search is stopped or finished, the result of Channel Search is automatically saved. When completing Channel Search, you c
Summary of the content on the page No. 17
** ** ** ** ** 4. Basic Operation ** This chapter describes functions such as switching channel, volume control, and basic features for watching programmes. 4.1 Switching Channel You can switch the current channel using one of the following methods. 1. Press the CH-/CH+ button. 2. Enter your desired channel numeric using the NUMERICAL (0-9) buttons to move to the channel directly. 3. Press the TV/RADIO button to switch between TV channel and Radio channel. Note: You can switch channel using Prog
Summary of the content on the page No. 18
** ** ** ** ** 4. Basic Operation ** 4.4 Change the Subtitle Language If the current programme provides Subtitle information, you can select the language for the Subtitle. 1. Press the SUBTITLE button to display the subtitle language list. 2. Select your desired subtitle language using the button, and press the OK button. Then the subtitle will be displayed in the selected language at the bottom of the screen. 3. Select OFF from the subtitle language list not to display subtitle from the screen.
Summary of the content on the page No. 19
** ** ** ** ** 4. Basic Operation ** 4.6 Programme Information (I- plate) Programme information is always displayed for a specific period of time whenever you switch channels. You can view the programme information by pressing the i button while watching a programme. Press the EXIT button to hide the I-plate. 1. General Information General Information is displayed as follows on the screen. ** ** ** 1. Channel number and channel name 2. Programme name 3. Icons Displayed only if this programme is
Summary of the content on the page No. 20
** ** ** ** ** ** ** 4. Current time 5. Detail programme information: displayed if detailed programme information is provided. 6. Channel looping mode and Channel List Name : if you select Within the current channel list by selecting MENU - Edit channels - Channel Change Mode , the Icon of Channel looping mode is displayed. And channel list, which you selected, is displayed. 7. Programme broadcasting time and progress bar: displays programme playing time and progress bar. 8. Next programme Infor
