Summary of the content on the page No. 1
Dell™ PowerEdge™
R910 Systems
Getting Started
With Your System
Guide de mise en route
Primeiros passos com o sistema
Procedimientos iniciales con el sistema
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Dell™ PowerEdge™ R910 Systems Getting Started With Your System Regulatory Model E06S Series
Summary of the content on the page No. 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2009 Dell Inc. All rights reserved. Reproduction of these materials in any manner
Summary of the content on the page No. 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Installing the Rails and System in a Rack Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system. Getting Started With Your System 3
Summary of the content on the page No. 6
Optional – Connecting the Keyboard, Mouse, and Monitor Connect the keyboard, mouse, and monitor (optional). The connectors on the front and back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector. Connecting the Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. 4 Getting Started With Your System
Summary of the content on the page No. 7
Securing the Power Cable(s) Bend the system power cable into a loop as shown in the illustration and secure the cable to the bracket using the provided strap. Plug the other end of the power cable into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Turning On the System Press the power button on the system and the monitor. The power indicators should light. Getting Started With Your System 5
Summary of the content on the page No. 8
Installing the Optional Bezel Install the bezel (optional). Complete the Operating System Setup If you purchased a preinstalled operating system, see the operating system documentation that ships with your system. To install an operating system for the first time, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased with the system. Supported Operating Systems ® ® � Micro
Summary of the content on the page No. 9
� Microsoft Windows Server 2003 R2 (x64) Standard and Enterprise Editions � Microsoft Windows Essential Business Server (x64) Standard and Premium Editions ® ® �Red Hat Enterprise Linux 5.5 Server Standard and Advanced Platform (x86_32) � Red Hat Enterprise Linux 5.5 Server Standard and Advanced Platform (x86_64) ® �SUSE Linux Enterprise Server 11 (x86_64) � SUSE Linux Enterprise Server 10 (x86_64) with SP3 ® �Solaris 10 10/9 (x86_64) ® �Citrix XenServer™ 6.0 (when available) ® �VMware ESX V
Summary of the content on the page No. 10
Obtaining Technical Assistance If you do not understand a procedure in this guide or if the system does not perform as expected, see your Hardware Owner’s Manual. Dell™ offers comprehensive hardware training and certification. See www.dell.com/training for more information. This service may not be offered in all locations. Technical Specifications Processor ® ® Processor type Two or four Intel Xeon 7500 series processors (up to eight-core processors) Expansion Bus Bus type PCI Express Gene
Summary of the content on the page No. 11
Drives Hard drives Up to sixteen 2.5-inch, internal hot-swappable SAS or SSD hard drives NOTE: Only one SATA drive is supported on the x4 backplane. SAS and SATA hard disks on the same backplane cannot be combined into a single virtual disk. x16 backplanes do not support SATA drives. Optical drive Optional internal SATA DVD or DVD+RW Optional external USB DVD-ROM Flash drive Optional internal USB Optional internal dual SD module Connectors Back NIC Four RJ-45 using a 1 GbE I/O riser Or Two R
Summary of the content on the page No. 12
Power System heat dissipation 8407 BTU/hr maximum (at 230 V 100% load) (with two or four 1100 W PSUs) 5732 BTU/hr maximum (with two or four 750 W PSUs) AC Power Supply (per power supply) Wattage 1100 W (High Output PSU) 750 W (Energy Smart PSU) Voltage 100–240 V, 50–60 Hz, auto-ranging Maximum inrush current Under typical line conditions and over the entire system ambient operating range, the inrush current may reach 55 A per power supply for 10 ms or less Batteries System battery CR 2032
Summary of the content on the page No. 13
Environmental NOTE: For additional information about environmental measurements for specific system configurations, see www.dell.com/environmental_datasheets. Temperature Operating 10° to 35°C (50° to 95°F) with a maximum temperature gradation of 10°C per hour NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1ºF/550 ft. Storage –40° to 65°C (–40° to 149°F) with a maximum temperature gradation of 20°C per hour Relative humidity Operating 20% to 80% (noncondens
Summary of the content on the page No. 14
12 Getting Started With Your System
Summary of the content on the page No. 15
Systèmes Dell™ PowerEdge™ R910 Guide de mise en route Modèle réglementaire série E06S
Summary of the content on the page No. 16
Remarques, précautions et avertissements REMARQUE : Une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : Une PRÉCAUTION vous avertit d'un risque de dommage matériel ou de perte de données en cas de non-respect des instructions données. AVERTISSEMENT : Un AVERTISSEMENT vous avertit d'un risque d'endom- magement du matériel, de blessure corporelle ou de mort. ____________________ Les informations contenues dans ce document so
Summary of the content on the page No. 17
Installation et configuration AVERTISSEMENT : Avant de commencer la procédure suivante, lisez les consignes de sécurité fournies avec le système. Déballage du système Sortez le système de son emballage et identifiez chaque élément. Installation des rails et du système dans un rack Assemblez les rails et installez le système dans le rack en suivant les consignes de sécurité et les instructions d'installation du rack fournies avec votre système. Guide de mise en route 15
Summary of the content on the page No. 18
Facultatif – Connexion du clavier, de la souris et du moniteur Connectez le clavier, la souris et le moniteur (si nécessaire). Les icônes des connecteurs situées à l'avant et à l'arrière du système indiquent où insérer chaque câble. N'oubliez pas de serrer les vis situées sur le connecteur du câble du moniteur, s'il en est équipé. Branchement du ou des câbles d'alimentation. Branchez le ou les câbles d'alimentation au système et, si vous utilisez un moniteur, connectez son câble d'alimentatio
Summary of the content on the page No. 19
Fixation du ou des câbles d'alimentation Faites une boucle comme indiqué dans l'illustration, puis fixez-le à l'aide de la sangle fournie. Branchez ensuite l'autre extrémité du câble d'alimentation sur une prise secteur mise à la terre ou sur une source d'alimentation autonome (onduleur ou unité de distribution de l'alimentation). Mise sous tension du système Appuyez sur le bouton d'alimentation du système et sur celui du moniteur. Les voyants d'alimentation s'allument. Guide de mise en rout
Summary of the content on the page No. 20
Installation du cadre en option Installez le cadre (si nécessaire). Fin de l'installation du système d'exploitation Si vous avez acheté un système d'exploitation préinstallé, consultez tout d'abord la documentation associée, fournie avec l'ordinateur. Pour une première installation du système d'exploitation, consultez la documentation concernant l'installation et la configuration du système d'exploitation. Veillez à installer le système d'exploitation avant tout élément matériel ou logiciel
