Summary of the content on the page No. 1
WH-S8 & WH-S10
subwoofer
WH-S8
WH-S10
Summary of the content on the page No. 2
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER IMPORTANT SAFETY INFORMATION Unplug the apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been exposed to rain or moisture, does not operate normally, or has been dropped. CAUTION: These servicing instructions are for use by qualified service personnel o
Summary of the content on the page No. 3
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER INTRODUCTION The WH-S8 & WH-S10 is the latest in a long line of distinguished Wharfedale active subwoofers. These technologically advanced subwoofers will complement the finest electronics and decor. Please read these instructions carefully before installing your subwoofers. A few minutes studying this manual will ensure superb performance from your subwoofer for many years. INSTALLATION Unpacking Carefully unpack each subwoofer. Retain all the packi
Summary of the content on the page No. 4
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER Before Connecting the Subwoofer • Level the subwoofer taking care to make sure it sits squarely on all its spikes. • Switch off you amplifier and all connected source units at the mains. • Unplug the power cords to all system components if necessary. • Make sure the subwoofer is disconnected from the mains and that the ON/OFF switch is OFF. • Before re-connecting your system to the AC power supply, check that all the connections are properly made. • C
Summary of the content on the page No. 5
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER CONNECTING THE SUBWOOFER TO THE SYSTEM Control Panel of the WH-S10 Subwoofer ① Power Indicator ② Mains Power Switch Mains Power Fuse ③ ④ IEC Mains Input Socket ⑤ Volume Control ⑥ Crossover Frequency Control ⑦ Phase Switch Auto Power Switch ⑧ ⑨ LFE Input ⑩ Line Level Outputs 1 1 1 1 Line Level Inputs
Summary of the content on the page No. 6
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER AV AMPLIFIER A/V Processor Connections Your subwoofer has been designed for optimum performance with a digital processor. If your A/V processor has a line level or LFE subwoofer output you should use this connection. You will RIGHT LEFT RIGHT LEFT REAR CENTRE FRONT need to purchase a single screened RCA phono lead from your Subwoofer Out (Line Level) dealer. Connect this lead to the LFE input of the subwoofer as shown. Alternatively, you may use a
Summary of the content on the page No. 7
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER OPERATING YOUR SUBWOOFER Check that all connections to the subwoofer have been properly made and that the main volume control is at minimum. Plug the supplied power cord into the mains socket on the rear panel. Initial Settings Volume Control: Set the subwoofer volume control to the minimum before proceeding. Crossover Control: Adjust frequency to integrate WH-S8 or WH-S10 subwoofer with your system requirement. Phase Switch: The Phase switch should b
Summary of the content on the page No. 8
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER TROUBLESHOOTING Before investigating a problem, always switch off the system at mains. If your system is not working properly please work through this checklist before returning a unit to your dealer. Symptom Possible Cause No Sound System not switched on; Speaker cables shorting terminals out; Wrong source selected Sound lacks bass content Subwoofer not switched on Lack of bass reproduction Subwoofer phase incorrect; Subwoofer crossover control too lo
Summary of the content on the page No. 9
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER Subwoofer Maintenance Subwoofer should only ever be cleaned with a soft dry cloth to remove fingermarks, etc. Never touch subwoofer drive units as they can be damaged by improper handling. Never use a vacuum cleaner to clean a subwoofer grille. Brush it carefully by hand with a soft brush. When cleaning the floor under a subwoofer, switch it off, unplug it from the mains supply then lift it clear of the floor and move it to another location. Replace t
Summary of the content on the page No. 10
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER Specifications WH-S8 WH-S10 Description/Format Active Reflex subwoofer system Active Dynamic-Drive IB subwoofer system Drive Units 1 x (8")200mm cone long-throw 1 x (10")250mm cone long-throw Enclosure Type Vented box Closed box Frequency Response (±3dB) 30Hz - 200Hz 35Hz - 120Hz Bass Extension 30Hz 30Hz Amplifier Power Output 70W 215W Peak Power Output 150W 450W Line Input Sensitivity 200mV for maximum output 200mV for maximum output Crossover Range 4
Summary of the content on the page No. 11
USER INSTRUCTIONS: WH-S8 & WH-S10 SUBWOOFER
Summary of the content on the page No. 12
IAG House, Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE XU, UK Tel: + (0) 0 00 Fax: + (0) 0 http://www.wharfedale.co.uk IAG reserves the right to alter the design and specifications without notice. All rights reserved IAG Group Ltd. Wharfedale is a member of the International Audio Group. CODE: WH -MNL00 a
