Summary of the content on the page No. 1
MICRO COMPONENT SYSTEM
UX-P7 — Consists of CA-UXP7 and SP-UXP7.
COMPACT
DIGITAL AUDIO
CD-R/R W PLA YBACK
STANDBY / ON
MICRO COMPONENT SYSTEM UX·P7
CLOCK
STANDBY ON
/
CD TAPE FM/AM MD/AUX
/
STANDBY/ON
AHB PRO VOLUME
SOUND TIMER
DIMMER DISPLAY SLEEP
PROG RANDOM REPEAT MD/AUX
SOUND AUTO FM/AM
MODE PRESET FM MODE
CD TAPE
CD
REV .MODE
CANCEL MULTI KEY SET
REC
REC
AHB PRO PHONES AUTO REVERSE
LEVEL
VOLUME
RM-SUXP7U REMOTE CONTROL
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
Summary of the content on the page No. 2
Warnings, Cautions and Others Caution –– STANDBY/ON button! IMPORTANT FOR LASER PRODUCTS Disconnect the mains plug to shut the power off completely (the REPRODUCTION OF LABELS STANDBY/ON lamp goes off). The STANDBY/ON button in any position does not disconnect the mains line. 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE • When the unit is on standby, the STANDBY/ON lamp lights red. • When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled. CLASS
Summary of the content on the page No. 3
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Summary of the content on the page No. 4
Contents Location of the Buttons and Controls ....................... 3 Playing Back CDs (CD/CD-R/CD-RW) .................. 12 Front Panel ................................................................. 3 Playing Back the Entire CD — Normal Play ........... 12 Remote Control .......................................................... 5 Basic CD Operations ................................................ 12 Programming the Playing Order of the Tracks Getting Started..............................
Summary of the content on the page No. 5
Continued Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel 1 q COMPACT w DIGITAL AUDIO CD-R/R W PLA YBACK e r t STANDBY / ON MICRO COMPONENT SYSTEM UX·P7 2 CLOCK y STANDBY / ON CD TAPE FM/AM MD/AUX u / 3 AHB PRO VOLUME SOUND TIMER 4 i 5 o 6 7 8 REV .MODE ; a REC REC s AUTO REVERSE PHONES 9 d p – 3 – EN01-11.UX-P7[A] 3 01.5.9, 10:36 AM
Summary of the content on the page No. 6
Display Window 2 1 3 [ ] DAILY REC SLEEP REC CLOCK PRGM RANDOM ALL BASS SOUND MONOST 4 5 6 7 89 See pages in the parentheses for details. Front Panel Display Window 1 Remote sensor 1 Tape operation indicators 2 (STANDBY/ON) button and STANDBY/ON lamp •2 3 (tape direction) and (reverse mode) (9, 14, 19) indicators 3 AHB (Active Hyper Bass) PRO + / – control (10) 2 Timer indicators 4 SOUND button (10) • (timer), DAILY, REC and SLEEP indicators 5 CD 3/8 (play/pause) button (9, 12, 17) 3 REC in
Summary of the content on the page No. 7
Remote Control Remote Control 1 REPEAT button (14) 2 DIMMER button (10) 3 DISPLAY button (9) 4 PROG (program) button (13) 5 RANDOM button (14) STANDBY/ON 6 SOUND MODE button (10) 7 AUTO PRESET button (11) r 1 8 CD 0 (disc tray open/close) button (12) DIMMER DISPLAY SLEEP 2 t Pressing this button also turns on the unit. 3 MD/AUX PROG RANDOM REPEAT 9 CD 3/8 button (9, 12, 13) 4 Pressing this button also turns on the unit. y 5 SOUND AUTO FM/AM FM MODE MODE PRESET p4 (reverse search) button (11, 12,
Summary of the content on the page No. 8
Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) FM antenna (supplied) • Remote control (1) • Batteries (2) • Speaker cords (2 sets) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM 75 W Insert the batteries — R6(SUM-3)/AA(15F)
Summary of the content on the page No. 9
Continued AM antenna Connecting Speakers 2 ] ] 3 1 ANTENNA Vinyl-covered wire (not supplied) Gray Red 1 AM EXT AM LOOP RIGHT LEFT RIGHT LEFT MAIN SPEAKERS FM 75 SUBWOOFERS COAXIAL SPEAKER SPEAKER IMPEDANCE IMPEDANCE MIN 6 MIN 6 Blue Black Speaker cords Speaker cords 2 AM loop antenna (supplied) 1 Connect the AM loop antenna to the AM Black Blue Black Blue LOOP terminals as illustrated. Red Gray Red Gray • If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as Right
Summary of the content on the page No. 10
To remove the speaker grilles To connect audio equipment with an optical digital The speaker grilles are removed as the illustrations below. input terminal You can record CD sound onto the connected digital Holes Projections equipment. Protective plug OPTICAL DIGITAL OUT Speaker grille Before connecting the other equipment, remove the protective plug from the terminal. Audio equipment with an optical digital input To optical digital input To remove the speaker grille, inserting your fingers at t
Summary of the content on the page No. 11
Continued Common Operations Turning On the Power 2 Press ¢ or 4 to adjust the hour, then press CLOCK. When you press the play button — CD 3/8, TAPE 2 3, or The minute digits start flashing on the the source selecting button — FM/AM, and MD/AUX, the display. unit automatically turns on and starts playback if the source is CLOCK ready. CLOCK To turn on the unit, press (STANDBY/ON). The STANDBY/ON lamp on the unit lights green. STANDBY/ON STANDBY/ON 3 Press ¢ or 4 to adjust STANDBY ON the minute,
Summary of the content on the page No. 12
Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned You can reinforce the bass sound to maintain rich, full bass at on. The volume level can be adjusted between “VOLUME 0” low volume. This function only affects the playback sound, and “VOLUME40.” but does not affect your recording. AHB PRO When using the remote control, When using the remote control, press AHB LEVEL VOLUME press VOLUME + to increase the PRO LEVEL + to increase the bass so
Summary of the content on the page No. 13
Listening to FM and AM Broadcasts Tuning in a Station 3 Repeat steps 1 and 2 to store stations for the other band. 1 Press FM/AM. FM/AM The unit automatically turns on and tunes in the previously tuned station (either FM or When you cannot automatically store stations you want AM.) Stations with weak signals cannot be detected with this automatic • Each time you press the button, the band presetting. To store such a station, use the manual presetting. alternates between FM and AM. To preset stat
Summary of the content on the page No. 14
Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: 3 Press CD 3/8. CD •CD The disc tray automatically closes and the first • CD-R track of the CD starts playing. • CD-RW Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the Track number Elapsed playing time unit. • The CD automatically stops when the last track of the CD has finished playing. General Notes To stop playing, press 7. In general, you will have the best performanc
Summary of the content on the page No. 15
Continued To check the program contents Programming the Playing Order of the Tracks PROG You can check the program contents by — Program Play pressing PROG on the remote control. The programed tracks are shown in the You can arrange the order in which tracks play before you programed order. start playing. You can program up to 20 tracks. To modify the program 1 Load a CD. Before or after playing, you can erase the last • If the current playing source is not the CD player, press CANCEL programed
Summary of the content on the page No. 16
Playing at Random — Random Play Prohibiting Disc Ejection — Tray Lock The tracks will play in no particular order when you use this You can lock the disc tray and prohibit to eject the CD. mode. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: RANDOM To use Random play mode, press RANDOM To prohibit disc ejection, press before or during playing. (STANDBY/ON) while holding 7. (If the The RANDOM indicator lights up on the display. disc tray is open
Summary of the content on the page No. 17
Playing Back Tapes You can play back type I, type II, and type IV tapes without To stop playing, press 7. changing any settings. To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running. The tape direction indicator (3 or 2) starts flashing quickly Playing Back a Tape on the display. To remove the cassette, press 0 for cassette deck. 1 Press 0 for cassette deck. To play both sides — Reverse Mode You can set the deck to play just one side of a tape, both sides once, or
Summary of the content on the page No. 18
Recording IMPORTANT: Recording on a Tape • It may be unlawful to record or play back copyrighted material without the consent of the copyright owner. On the unit ONLY: • The recording level is automatically set correctly, so it is 1 Put a recordable cassette in with the exposed not affected by the VOLUME, AHB (Active Hyper Bass) part of the tape down. PRO, and SOUND MODE settings. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.
Summary of the content on the page No. 19
CD Direct Recording One Track Recording Everything on the CD goes onto the tape in the order it is on This recording method is convenient when you record tracks the CD, or according to the order you have made for Program while playing a CD. You can only record your favorite songs play. on the tape. On the unit ONLY: On the unit ONLY: 1 Put a recordable cassette in with the exposed 1 Put a recordable cassette in with the exposed part of the tape down. part of the tape down. 2 Place a disc correct
Summary of the content on the page No. 20
Using the Timers There are three timers available — Daily Timer, Recording 2 Set the on-time you want Timer, and Sleep Timer. the unit to turn on at. Before using the timers, you need to set the clock built in the 1) Press ¢ or 4 to set the unit (see page 9). When you press TIMER on the unit for hour, then press TIMER. more than 3 seconds, the display alternates between 2) Press ¢ or 4 to set the minute, then TIMER “ADJUST” and “CLOCK” for about 5 seconds. press TIMER. The unit enters off-time s
