Summary of the content on the page No. 1
UDRC13
ACCESSORY CAMERA
Owner’s Manual
Compatible with
UDR444 Wireless
Video Surveillance System
If any items are missing or damaged, contact our Customer Care Line
immediately. Never use damaged products!
Need help? Get answers 24/7 at our website:www.uniden.com.
CUSTOMER CARE
At Uniden®, we care about you!
If you need assistance, please do NOT return this
product to your place of purchase. Our customer
care specialists are available to serve you.
Quickly find answers to your questions by:
Summary of the content on the page No. 2
IMPORTANT SAFETY PRECAUTIONS # This manual contains important information about this product’s operation. If you are installing this product for others, you must leave this manual or a copy with the end user. When using your equipment, always follow basic safety precautions to reduce the risk of fire, electric shock and injury to persons, including the following: x The UDRC13 camera is NOT weatherproof. It is an indoor camera x To avoid any risk of electric shock from lightning, avoid
Summary of the content on the page No. 3
parental supervision. Always be sure that both the transmitter and receiver are working properly, and are within range of each other. x STRANGULATION HAZARD. Keep the adapter cords out of the reach of children. x WARNING: KEEP OUT OF THE REACH OF CHILDREN. This product is not a toy and is not intended for use by any children under the age of 13. If you are between the ages of 13 and 18, review these terms, conditions and safety warnings with your parents or guardian to make sure that y
Summary of the content on the page No. 4
WHAT’S IN THE BOx • Digital Wireless Camera (1) • AC Adapter for Camera (1) • Camera Stand with mount screws (1 set) • Owner’s Manual (1) # If any items are missing or damaged, contact our Customer Care Line immediately! PARTS OF THE CAMERA Left side Front Right side 7 6 1 10 14 8 11 2 5 9 12 13 3 4 Item What it is 1 Camera Antenna: Sends & receives signals to or from the monitor. 2 PaIr : Pairs the camera to the monitor. 3 Clip: This fastener can attach the camera to shelves or ledges. 4 S
Summary of the content on the page No. 5
Item What it is 9 Microphone: Receives sounds for the area near the camera, and transmits sound from the camera to the monitor. 10 POWEr : Turns the camera ON or OFF. 11 Charging LED: Red = Charging Green = Fully charged Off = Camera and power adapter are disconnected or power adapter is disconnected from power source. 12 Power LED: Green = Camera is turned on. Green (Blinking) = Battery is low. 13 DC 5V Power: Connects the DC 5V power adaptor to the camera. 14 Reset the camera. Use a blu
Summary of the content on the page No. 6
4. Adjust the camera as needed. Suction Mount 1. Insert the suction base into the base clip as shown: 2. Firmly press the camera with the suction base attached onto glass or metallic surfaces. 3. Adjust the camera as needed. Clip-Mount Clip the UDRC13 on ledges and shelves. 1. Press the mounting clip as shown. 2. Place the unit over the mounting surface and release. 3. Adjust the camera as needed. Connect Power 1. Insert the AC adapter power plug into the camera’s DC adaptor input jack.
Summary of the content on the page No. 7
PRODUCT SPECIFICATION GENERAL Operating frequency 2.400 ~ 2.4835GHz range TX power 15dBm (typical) Spread spectrum FHSS Modulation type GFSK Data Rate 2 Mbps Communication range 500 ft Line of Sight CAMERA Image Sensor Type - 1/6.5” CMOS Sensor Effective Pixel 640 x 480 Image Processing MJPEG Lens 3.0mm / F2.8 Exposure Auto White Balance Auto Power Requirement 5.0VDC +/–5% Power Consumption 150mA Max (IR OFF) 730mA Max (IR ON) 440mA Max (Charging) Operating 14°F ~ 104°F ( –10°C ~ 40°C ) Tempera
Summary of the content on the page No. 8
x Consult your local waste management authority or a recycling organization like Earth911.com to find an electronics recycling facility in your area. x If you are unable to locate proper recycling facilities in your area, please return this product to Uniden for recycling. f CC COMpli An CE i nf ORMATi On A p RT 15 COMpli An CE STATEMEn T This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interf
Summary of the content on the page No. 9
# CAUTION! Any changes or modifications to this equipment not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Rf Exp OSURE i nf ORMATi On The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm (7.9”) from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. i C COMpli An CE i nf ORMATi On RAdi O Eq Uip MEnT nOTi CE The ter
Summary of the content on the page No. 10
original retail owner, this Uniden Product to be free from defects in materials & craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate & be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, subassemblies, or any configura
Summary of the content on the page No. 11
THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, & you may also have other rights which vary from state to state. This warranty is void outside the United States of America & Canada. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following th
