Summary of the content on the page No. 1
ENGLISH
MODEL
HT-SB600
SOUND BAR SYSTEM
OPERATION MANUAL
Thank you for purchasing this SHARP product. To obtain the best performance from this product, please
read this manual carefully. It will guide you in operating your SHARP product.
HT-SB600 Sound Bar system consisting of HT-SB600 (main unit), CP-SB600 (sound bar) and CP-SW600
(subwoofer).
Note:
This product is recommended for flat panel TV (LCD and plasma).
Accessories
Please confirm that only the following accessories are included.
AM Loo
Summary of the content on the page No. 2
Special Notes Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820 of the National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the cable CAUTION: TO REDUCE THE RISK OF ELECTRIC ground shall be connected to the grounding system of SHOCK, DO NOT REMOVE COVER (OR BACK). the building, as close to the point of cable entry as NO USER-SERVICEABLE PARTS INSIDE. REFER practical. SERVICING
Summary of the content on the page No. 3
Important Safety Instructions (continued) 19)Replacement Parts - When replacement parts are 8) Do not install near any heat sources such as radiators, required, be sure the service technician has used heat registers, stoves, or other apparatus (including replacement parts specified by the manufacturer or amplifiers) that produce heat. have the same characteristics as the original part. 9) Do not defeat the safety purpose of the polarized or Unauthorized substitutions may result in fire, electric
Summary of the content on the page No. 4
For U.S. customer only CONSUMER LIMITED WARRANTY SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when ship in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. Th
Summary of the content on the page No. 5
Precautions General Volume control ● Please ensure that the equipment is positioned in a The sound level at a given volume setting depends on speaker efficiency, location and various other factors. It is well-ventilated area and ensure that there is at least advisable to avoid exposure to high volume levels, which 4" (10 cm) of free space along the sides, top and back occurs while turning the unit on with the volume control of the equipment. setting up high, or while continually listening at hi
Summary of the content on the page No. 6
Controls and indicators Front Panel 1 23 Reference page 1. Remote Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . 15 2. Information Display . . . . . . . . . . . . . . . . . . . . . . . 16 3. Timer Indicator. . . . . . . . . . . . . . . . . . . . . . . . . . . 20 4. On/Stand-by Button. . . . . . . . . . . . . . . . . 16, 18, 22 5. Input Button . . . . . . . . . . . . . . . . . . . . . . . 12, 15, 17 6. Equalizer Button . . . . . . . . . . . . . . . . . . . . . . 16, 22 7. Volume Up/Do
Summary of the content on the page No. 7
Controls and indicators (continued) Rear Panel Reference page 1. Digital Input Jack. . . . . . . . . . . . . . . . . . . . . . 13, 14 2. Line Input Jack . . . . . . . . . . . . . . . . . . . . . . . 13, 14 3. FM 75 Ohms Antenna Jack. . . . . . . . . . . . . . 11, 12 9 4. AM Antenna Ground Terminal . . . . . . . . . . . . . . 11 1 5. AM Loop Antenna Terminal . . . . . . . . . . . . . . . . 11 6. Front Speaker Terminal. . . . . . . . . . . . . . . . . . . . 11 10 7. Center Speaker Terminal . . . .
Summary of the content on the page No. 8
Controls and indicators (continued) Sound Bar FRONT VIEW 1 3 2 4 2 2 REAR VIEW 56 7 Reference page 1. Left Front Speaker 5. Right Front Speaker terminal . . . . . . . . . . . . . . . .11 2. Bass Reflex Duct 6. Center Speaker terminal . . . . . . . . . . . . . . . . . . . .11 3. Right Front speaker 7. Left Front Speaker terminal . . . . . . . . . . . . . . . . .11 4. Center Speaker Subwoofer FRONT VIEW REAR VIEW 2 1 1 3 2 SUBWOOFER SYSTEM 3 4 5 Reference page 6 1. Bass Reflect Duct 7 2. Woofer 3
Summary of the content on the page No. 9
Controls and indicators (continued) Remote Control 1 Reference page 2 HDMI ARC 1. Remote Control Transmitter . . . . . . . . . . . . . . . . 15 16 TV 12 3 3 2. On/Stand-by Button. . . . . . . . . . . . . . . . . . . . 16, 18 3. TV ARC Button. . . . . . . . . . . . . . . . . . . . . . . . 12, 17 DIGITAL LINE 4. DIGITAL 1-2 Button . . . . . . . . . . . . . . . . . . . . 15, 17 4 17 1212 5. CLOCK Button . . . . . . . . . . . . . . . . . . . . . . . . 16, 19 CLOCK TIMER 6. TUNING Up/Down Button . .
Summary of the content on the page No. 10
Speaker preparation To mount the speaker on the wall 4 Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces) Caution: ● Be very careful to prevent the speaker [ 4.41 lbs. (2.0 kg)] Wall mount angle from falling when mounting on the wall. Wall mount ● Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The speaker angle Wall Wall may fall.) If unsure, consult a qualified service mount (screws x 4) surface tec
Summary of the content on the page No. 11
SUBWOOFER SYSTEM Placing the system Installation image: Placing the stand Place the stand as shown. TV SUBWOOFER SYSTEM Stand SUBWOOFER SYSTEM Subwoofer VCR DVD player Main unit Place the system as shown. Remove the protective film covering the main unit and subwoofer before turn on the system. Notes: ● As the sound from the system is omni-directional, you can place the speaker anywhere you like. However, it is recommended to place it as close to the TV as possible. ● The front panel of the spe
Summary of the content on the page No. 12
System connections Make sure to unplug the AC power cord before making any connections. Main unit Subwoofer FM antenna Red Green White AM loop antenna Sound Bar AC outlet AC 120 - 60 Hz SPEAKERS – + FRONT INPUT CENTER SUB WOOFER Purple Caution Speaker and Subwoofer connection ● Never mistake the FRONT, CENTER and the Connect the wire without insulation tube to the minus (-) SUBWOOFER terminals. The main unit or the terminal, and the wire with colored insulation tube to the speakers may be damag
Summary of the content on the page No. 13
System connections (continued) TV Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM DVD, Blu-ray 75 OHMS jack and position the FM FM disc player or antenna wire in the direction where the antenna similar strongest signal can be received. To HDMI (ARC) input Supplied AM loop antenna: terminal Connect the AM loop antenna to the AM and GND (Ground) terminals. Position the To HDMI output AM loop antenna for optimum reception. terminal Place the AM loop on a shelf, et
Summary of the content on the page No. 14
Audio signal Audio connections to TVs, DVD players, VCRs, etc. Other connection (without HDMI) The illustration below shows the flows of audio and video signals. Audio signal Video signal TV DVD/Blu-ray Disc Player VCR/Game console Digital tuner, etc. Notes: ● Refer to the operation manual of the equipment to be connected. ● Fully insert the plugs to avoid fuzzy pictures or noises. Connecting a TV, etc. Connect to the TV using an optical digital audio cable or an audio cable. TV To audio outp
Summary of the content on the page No. 15
Audio signal Audio signal Audio connections to TVs, DVD players, VCRs, etc. (continued) Connecting a DVD player, etc. Connect to the DVD player with an optical digital audio cable or an audio cable. To audio output Blu-Ray/DVD Player/Digital tuner terminals To optical digital audio output To the TV (video) terminal Optical digital audio cable (commercially available) To coaxial digital audio output terminal Coaxial digital Main unit audio cable (commercially available) To DIGITAL IN
Summary of the content on the page No. 16
Audio connections to TVs, DVD Remote Control (continued) players, VCRs, etc. (continued) Notes concerning use: ● Replace the batteries if the operating distance is To select DIGITAL IN 1 (optical input) or DIGITAL IN 2 reduced or if the operation becomes erratic. (coaxial input) function: On main unit: Press INPUT button repeatedly until ● Periodically clean the transmitter on the remote control “DIGITAL 1” or “DIGITAL 2” appears on the and the sensor on the unit with a soft cloth. display. ● E
Summary of the content on the page No. 17
General control Volume control HDMI ARC Main unit operation: TV 12 3 Press the VOLUME + button to DIGITAL LINE 1212 increase the volume and the CLOCK TIMER ..... 00 01 02 99 100 VOLUME – button for DIMMER TUNING TUNER(BAND) decreasing. EQUALIZER X-BASS BASS/TREBLE MUTE Remote control operation: Press the VOL + button to increase the volume and the SUBWOOFER LEVEL CENTER LEVEL PRESET VOL – button to decrease the volume. VOL VOL Muting The volume is muted temporarily VOL VOL when pressing the
Summary of the content on the page No. 18
General control (continued) Bass control Audio Return Channel (ARC) (Audio Return Channel submenu) 1. Press the BASS/TREBLE The audio return channel (ARC) function enables an HDMI button to select “BASS”. ARC-capable TV to send the audio stream to the HDMI 2. Within 5 seconds, press the OUT jack of the receiver. To use this function, you must VOLUME (+ or –) button to select the TV ARC input and your TV must supports the adjust the bass. ARC function. Treble control Dolby Virtual Speaker
Summary of the content on the page No. 19
Listening to the radio Listening to the radio (continued) Memorizing a station HDMI ARC You can store 40 FM stations in memory and recall them TV 12 3 at the push of a button. (Preset tuning) DIGITAL LINE 1212 CLOCK TIMER 1 Perform steps 1 - 3 in “Tuning” on page 18. DIMMER TUNING TUNER(BAND) EQUALIZER X-BASS BASS/TREBLE MUTE 2 Press the ENTER button to enter the preset tuning saving mode. TUNING 3 Within 5 seconds, press the PRESET ( or ) buttons to select the preset channel number. Store
Summary of the content on the page No. 20
Setting the clock (Remote Control only) Timer operation (Remote Control only) By setting the unit to the correct time, you can use it not Setting the timer only as a clock but also for timer. SUBWOOFER LEVEL CENTER LEVEL In this example, the clock is set for the 12-hour (AM 12:00) display. PRESET 1 Press the CLOCK button. If clock is not set VOL VOL “ADJUST” will blink. Within 5 seconds, press the ENTER button. PRESET TV You can use the unit as an alarm clock by setting the timer. Before se
