Summary of the content on the page No. 1
U
DVD HOME THEATER SOUND SYSTEM
DVX-S60
FM MODE
STANDBY/ON
VOLUME
TUNING PRESET MEMORY
PHONES
SURROUND BASS MUSIC INPUT
DVX-S60: DVR-S60 + NX-S60S + NX-S60C + SW-S60
OWNER’S MANUAL
A1-60U-1 1 02.8.8, 3:37 PM
Summary of the content on the page No. 2
IMPORTANT SAFETY INSTRUCTIONS 11 Power Sources – This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the CAUTION type of power supply to your home, consult your product dealer or local RISK OF ELECTRIC SHOCK DO NOT OPEN power company. For products intended to operate from battery power, or other sources, refer to the operating instructions. 12 Grounding or Polarization – This product may be equipped with a CAUTION: TO REDUC
Summary of the content on the page No. 3
23 Heat – The product should be situated away from heat sources such as EXAMPLE OF ANTENNA GROUNDING radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. 24 Outdoor Antenna Grounding – If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is ANTENNA MAST LEAD IN grounded so as to provide some protection against voltage surges and WIRE built-up static charges. Article 810 of the National Electrical Code, G
Summary of the content on the page No. 4
CHECKING THE ACCESSORIES Check your package to make sure it contains the following items. DVR-S60 NX-SW60 (NX-S60S x 4, NX-S60C, SW-S60) Remote control Speaker cables [15m] [5m] X 4 X 2 Mounting brackets (for NX-S60S) Batteries (size AA, UM/SUM-3, R6, HP-7) X 4 Audio pin cable Screws (for NX-S60S) X 4 Fasteners (for NX-S60C) Video pin calbe X 2 AM loop antenna Nonskid pads (for NX-S60S) X 2 Indoor FM antenna (U.S.A., Canada, Australia, (U.K. and Europe models) China, Kor
Summary of the content on the page No. 5
CAUTION: READ THIS BEFORE OPERATING YOUR SYSTEM. 1 To assure the finest performance, please read this manual This system is not disconnected from the AC power source as long carefully. Keep it in a safe place for future reference. as it is connected to the wall outlet, even if this system itself is 2 Do not install this equipment in a confined space, such as a book turned off. This state is called the standby mode. In this state, this case or built in cabinet. system is designed to consume a ver
Summary of the content on the page No. 6
CONTENTS IMPORTANT SAFETY INSTRUCTIONS....................... II VARIOUS DISC PLAYING FUNCTIONS ..................... 18 Selecting a DVD menu [DVD] ........................................... 18 CHECKING THE ACCESSORIES ............................... IV Selecting a title menu [DVD] ............................................. 18 CAUTION ....................................................................... 1 Return button (RETURN) [Video CD] ............................... 18 Chapter (Track)
Summary of the content on the page No. 7
CONTROLS Front panel 1 2 38 4 5 6 7 9 FM MODE STANDBY/ON VOLUME TUNING PRESET MEMORY PHONES SURROUND BASS MUSIC INPUT 17 16 15 14 13 12 11 10 1. STANDBY/ON button, Standby indicator 10. c/MEMORY button 2. Disc tray 11. INPUT button 3. f/TUNING – button, e/TUNING + button 12. MUSIC button [see page 12.] 4. Open/Close button (q) 13. BASS button [see page 12.] 5. Play button ( ) 14. SURROUND button [see page 13.] 6. FM MODE button [see page 23.]/Pause button (k) 15. Remote control senso
Summary of the content on the page No. 8
REMOTE CONTROL Note: In this instruction manual, any operation of pressing a button while pressing the SHIFT button is described as follows. Example: “Press SHIFT + 2 ANGLE buttons.” Controls POWER POWER SET UP SET UP 5 SHIFT 1 SHIFT 27 6 ANGLE REPLAY ZOOM ANGLE REPLAY ZOOM 1 2 3 4 1 2 3 4 SLEEP TIMER ADJUST SLEEP TIMER ADJUST 2 5 6 7 8 5 6 7 8 CLOCK SET/CLEAR CLOCK SET/CLEAR 9 0 10 CANCEL 7 9 0 10 CANCEL FM MODE TUNING PRESET FM MODE TUNING PRESET 4 BASS TEST LEVEL TUNER BASS TEST LEVEL TUNER 8
Summary of the content on the page No. 9
Installing batteries in the remote control Using the remote control Insert the batteries in the correct direction by aligning the + and – marks on the batteries with the polarity markings (+ and –) inside the battery FM MODE compartment. Press the tab. 1 STANDBY/ON VOLUME TUNING PRESET MEMORY PHONES SURROUND BASS MUSIC INPUT 3 Approximately 6 m (20 feet) 30 30 2 1. Press the tab on the battery compartment cover in the direction of the arrow and remove the cover. 2. Insert the two batteries (AA
Summary of the content on the page No. 10
SPEAKER PLACEMENT Before making connections, place all speakers in their respective positions. The positioning of the speakers is important because it controls the whole sound quality of this system. Place the speakers depending on your listening position by following the instructions below. Note: - In this speaker package, the same speakers (NX-S60S) are used for the front and surround speakers. - Although the speaker system in this system is magnetically shielded, it may still affect the color
Summary of the content on the page No. 11
Placing the the front/surround speakers Mounting the front and surround speakers When placing the speakers on a flat surface, attach the included nonskid Mount the speakers on a shelf, rack or directly on the floor, or hang them pads to the corners on the bottom of the speakers. This prevents the on the wall. speakers from sliding around. To mount the speakers on a wall by using the holes on the speakers’ back panels 1. Fasten screws into a firm wall or wall support as shown in the figure. Diam.
Summary of the content on the page No. 12
BASIC CONNECTIONS After all connections have been made, connect the power cable to Selecting TV system (for General model only) an AC outlet. Before connecting, set the TV SYSTEM switch (rear of the unit) to the position of your local TV system (PAL or NTSC). Note: - Do not connect the power cable to an AC outlet until all connections have been made. - The system is not completely disconnected from the AC outlet when the STANDBY/ON button is set to the standby mode. Speaker connections Be sure
Summary of the content on the page No. 13
Antenna connections AM loop antenna Outdoor FM antenna AM loop antenna Set up the loop antenna. (not supplied) 2 1 Indoor FM antenna Unwind the antenna wires, then connect them to the AM ANT terminals. Place the loop antenna in a position which yields the best AM reception, or attach it to a wall or other surface. DVR-S60 (U.S.A. model) 1 DVR-S60 TUNER VIDEO 1 IN OUT 75Ω VIDEO FM ANT GND IN OUT 3 L AM ANT 75Ω AUDIO 2 R FM ANT Screws (not supplied) GND AM Note: ANT To minimize noise, the speakers
Summary of the content on the page No. 14
LINE1(AUX1) LINE1(AUX1) ADDITIONAL CONNECTION EXAMPLES For connections, use the included or commercially available connection cables suitable for respective connections. DVR-S60 (U.S.A. model) TV Connecting to a TV with an S video cable MONITOR OUT VIDEO OUT SELECT S-VIDEO VIDEO (DVD ONLY) (DVD ONLY) Please follow the steps below before turning on the power. S-VIDEO SPEAKERS COMPONENT S-VIDEO 8Ω IN 1 1. If your TV has an S video input jack, connect the unit as shown in the 2 VIDEO OUT SCAN SELEC
Summary of the content on the page No. 15
Progressive-scan TV connections (for U.S.A., Canada and Korean models only) Your TV must be capable of handling progressive scanning and have component video input capability. Component video cable 1 Green DVR-S60 (U.S.A. model) TUNER VIDEO 1 VIDEO 2 COMPONENT MONITOR OUT VIDEO OUT SELECT IN OUT IN VIDEO OUT S-VIDEO VIDEO Blue (DVD ONLY) (DVD ONLY) 75Ω Y VIDEO FM ANT SPEAKERS COMPONENT S-VIDEO GND 8Ω PB IN OUT IN 2 VIDEO OUT AM L L SCAN SELECT ANT PR SELECTABLE INTERLACE Red AUDIO 480p/480i 480i
Summary of the content on the page No. 16
BASIC OPERATION ADJUSTING THE CLOCK (Using the remote control) Turning the power on and off Example: To set “PM 6:30” Press the STANDBY/ON button. The STANDBY indicator goes out. (After 1. Press the STANDBY/ON button to turn the power on. connecting the power cable, when you press the STANDBY/ON button for 2. Press the SHIFT + 0 CLOCK buttons. “AM 12:00” flashes. the first time, the volume-reset feature automatically sets the initial volume 3. Press the SHIFT + 8 ADJUST buttons. level.) To turn
Summary of the content on the page No. 17
SURR OFF: Normal stereo sound SELECTING THE SURROUND MODE Using only the Front left, Front right and Subwoofer speakers (Fig. C) Front Front Center left right speaker Press the SURROUND button to select the surround mode. Each time the speaker speaker button is pressed, the surround mode changes as follows: Subwoofer DOLBY PL v DOLBY 3 v DOLBY D v DTSv THEATER v HALL v SURR OFF v DOLBY PL . . . Note: Some discs may restrict the selection. DOLBY PL: Dolby Pro Logic mode When playing a program sou
Summary of the content on the page No. 18
PLAYABLE DISCS The following types of discs can be played on this unit. Recorded Disc type and logo mark Disc size Maximum playing time content Approx. 4 hours (Single sided disc) 12 cm Audio Approx. 8 hours (Double sided disc) + DVD Video Video Approx. 80 minutes (Single sided disc) 8 cm Approx. 160 minutes (Double sided disc) 12 cm 74 minutes Audio Video CD + Video 8 cm 20 minutes (Version 2.0) 12 cm 74 minutes Music CD Audio 8 cm 20 minutes DVD discs are divided into titles
Summary of the content on the page No. 19
If a menu appears on the TV screen... DISC PLAY Press the 4, a, 5 or b button (or the number buttons), then press the ENTER button to select ENTER the desired menu. Playback of the selected menu Important note: will start. - This “DISC PLAY” explains the basic instruction of the DVD Note: Remote control player section using the remote control unit. For more details, please refer to the jacket or - Some DVD or Video CD discs have different functions that may not case of the disc. be explained in
Summary of the content on the page No. 20
SETTINGS ON THE SET UP MENU Once the following settings have been completed, the unit can always be operated under the same conditions. The settings will be retained in the memory until they are changed, even if the power is turned off. Common procedures of settings 1. Press the SET UP button in the stop mode. “SET UP MENU” appears on the TV screen. Language Display Speaker Parental 2. Press the 4, a, 5 or b button, then press the ENTER button to select the menu. Please refer to the on-screen in
