Gemini XPM-3000 user manual

Summary of the content on the page No. 1

OPERATIONS MANUAL
BEDIENUNGSHANDBUCH
MANUAL DEL OPERADOR
MANUEL D’INSTRUCTIONS
XPM-3000
POWER AMPLIFIER
STEREO VERSTÄRKER
AMPLIFICADOR DE PODER ESTEREO
AMPLIFICATEUR DE PUISSANCE STÉRÉOV
(1)

Summary of the content on the page No. 2

1 2 3 4 5 6 7 8 9 10 230V 11 12 13 14 15 8 10 1 2 3 4 5 6 7 9 120V 11 12 13 14 15 19 22 23 16 17 18 16 17 18 20 16 17 18 21 Gemini Sound Products Corp. 120 Clover Place, Edison, NJ 08818• USA Tel (732) 738-9003 • Fax (732) 738-9006 (2)

Summary of the content on the page No. 3

120V (3)

Summary of the content on the page No. 4

230V (4)

Summary of the content on the page No. 5

Introduction Connections, Controls and Indicators Congratulations on purchasing a Gemini XPM-3000 Power Amplifier. Rear Panel This state of the art power amplifier includes the latest features and is backed by a five year limited warranty. Prior to use, we suggest that you Note: 120V and 230V units have different types of output carefully read all the instructions. connectors on the rear panel. Input Section: Features There are two parallel input connectors (one female XLR and one 1/4” jack) per

Summary of the content on the page No. 6

one connector touch the adjacent connector, the sound will be Operating Instructions distorted, and your amplifier will overheat and go into protection mode. THE AMPLIFIER’S POWER MUST BE TURNED OFF NOTE (120V only): Two subwoofer output connectors are WHEN CHANGING SETTINGS. provided to connect two subwoofers with separate cables. These outputs are wired in parallel and are connected to a mono subwoofer channel (subwoofer output is not Using the Amplifier With Subwoofer(s) and Satellite directi

Summary of the content on the page No. 7

2. Connect the loudspeakers to the channel A and channel B SPEAKER Damping Factor: OUTPUTS (8, 9). THE TOTAL SPEAKER LOAD MUST BE AT Channels A and B................................................................>300 @ 8 Ohms LEAST 4 OHMS PER CHANNEL FOR CHANNELS A AND B. If you Subwoofer Channel.............................................................>600 @ 8 Ohms try to operate at a lower impedance, the amplifier will overheat and Slew Rate.................................................

Summary of the content on the page No. 8

SYMPTOM CAUSE SOLUTION • MOVE POWER SWITCH TO ON POSITION. UNIT DOES NOT PRODUCE SOUND. POWER • POWER SWITCH NOT IN ON POSITION. • CONNECT POWER CABLE TO AC SUPPLY. LED DOES NOT LIGHT. • POWER CABLE NOT CONNECTED TO AMPLIFIER OR TO OUTLET. • CHECK CONDITION OF OUTLET. • REPLACE AMPLIFIER MAIN POWER FUSE ON REAR • AC OUTLET NOT ACTIVE. PANEL WITH CORRECT TYPE AND RATING. • MAIN AMPLIFIER FUSE DEFECTIVE. • CHECK FOR PROPER FUNCTION OF INPUT POWER LED LIGHTS, BUT NO SOUND IS • NO INPUT SOURCE SIGNA

Summary of the content on the page No. 9

In the USA: If you experience problems with this unit, call 1-732-738-9003 for Gemini Customer Service. Do not attempt to return this equipment to your dealer. Parts of the design of this product may be protected by worldwide patents. Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Gemini Sound Products Corp. shall not be liable for any loss or damage whatsoever arising from the use of information or any error contai