Summary of the content on the page No. 1
SRA-Series Amplifier
Operating Manual
Ashly Audio Inc.
847 Holt Road, Webster, NY 14580-9103
Toll Free (800) 828-6308, Telephone (585) 872-0010, FAX (585) 872-0739
www.ashly.com
All Trademarks referred to herein, are the property of their respective owners. R-052510
All Rights Reserved
Summary of the content on the page No. 2
Page - 2 Operator Manual – SRA Series Amplifiers Important Safety Instructions - 2 Important Safety Instructions Introduction - 3 Consignes de sécurité à lire attentivement The SRA Series - 4 This power amplifier can produce dangerous Cet amplificateur de puissance peut produire un output voltage, power and sound pressure voltage et une pression acoustique qui pourrait être Physical Description - 5 levels. In order to minimize the risk of injury, dangereuse ou pourrait meme causer de
Summary of the content on the page No. 3
Operator Manual – SRA Series Amplifiers Page - 3 Important Safety Instructions - 2 Introduction Introduction - 3 Congratulations on your purchase of an Ashly SRA-Series amplifier. The SRA-Series is About Ashly made up of powerful, high-efficiency, lightweight amplifiers incorporating the latest Safety technologies. We are confident that you will be pleased with the high performance, superb FCC Compliance sound quality, reliability, and more. The SRA Series - 4 Physical Descrip
Summary of the content on the page No. 4
Page - 4 Operator Manual – SRA Series Amplifiers Important Safety Instructions – 2 The SRA Series Introduction - 3 SRA-Series amplifiers are high-efficiency, lightweight amplifiers incorporating the latest The SRA Series - 4 amplifier technologies. Protection Physical Description - 5 The series provides a power range of 75 to 150 watts per channel at 4 ohms (20Hz-20kHz, 1% THD). The SRA series is available in 2 and 4 channel versions at two power points. All Installation - 6 mod
Summary of the content on the page No. 5
Operator Manual – SRA Series Amplifiers Page - 5 Important Safety Instructions – 2 Physical Description Introduction - 3 Each model in the SRA-Series is 1RU, and weighs 9 pounds (2 Ch) or 10 pounds (4 Ch). The SRA Series - 4 They have the same physical design, though there are obvious differences between two and Physical Description - 5 four channel versions. The model number is indicated on the left side of the front panel Front Panel Amplifier Front Panel Rear Panel Installa
Summary of the content on the page No. 6
Page - 6 Operator Manual – SRA Series Amplifiers Important Safety Instructions – 2 Installation Introduction - 3 SRA-Series amplifiers are designed for use in both fixed and mobile sound systems. Each The SRA Series - 4 amplifier is shipped (unless otherwise specified) with the following factory settings: Physical Description - 5 Front Panel Front panel: Rear panel: Rear Panel On/Off Switch = Off High Pass Filter(s) = Off Installation – 6 Gain Selector = +26 dB Attenuators = ∞
Summary of the content on the page No. 7
Operator Manual – SRA Series Amplifiers Page - 7 Important Safety Typical Applications Instructions – 2 Introduction - 3 The SRA Series - 4 Physical Description - 5 Installation – 6 Requirements Typical Applications Connectors & Polarity Operation - 8 Troubleshooting - 9 The most common use of a SRA-Series amplifier is a 2-channel source driving 2 speaker Spec Table - 10 channels. In this illustration, the 4-channel amplifier is receiving two stereo signals and is Dime
Summary of the content on the page No. 8
Page - 8 Operator Manual – SRA Series Amplifiers Important Safety Instructions – 2 Operation Introduction - 3 The amplifier’s On/Off Switch is a rocker-type switch located on the left side of the front The SRA Series - 4 panel. Turning on the amplifier initiates start-up by activating the inrush current limiter. Physical Description - 5 When using the remote On/Off function, the main On/Off switch must remain in the On Installation – 6 position. See page 11 for more information o
Summary of the content on the page No. 9
Operator Manual – SRA Series Amplifiers Page - 9 Important Safety Instructions – 2 Troubleshooting Introduction - 3 Situation Indication Action The SRA Series - 4 No Sound Signal LED not lit Check AC plug. Confirm that AC outlet works by plugging Clip LEDs not lit in another device. Physical Description - 5 Signal LED not lit Make sure the signal source is operating and try another Installation – 6 cable. Check position of Volume Pots. Operation – 8 Signal LEDs responding
Summary of the content on the page No. 10
Page - 10 Operator Manual – SRA Series Amplifiers Important Safety Instructions – 2 Spec Table Introduction - 3 SRA-2075 SRA-4075 SRA-2150 SRA-4150 The SRA Series - 4 Power Output Per Channel Stereo Mode, all channels driven Physical Description - 5 8 ohms, 20 Hz - 20 kHz, 1% THD 2 x 40W 4 x 40W 2 x 80W 4 x 80W Installation – 6 4 ohms, 20 Hz - 20 kHz, 1% THD 2 x 75 W 4 x 75 W 2 x 150 W 4 x 150 W Operation – 8 Bridged Mono Mode 8 ohms, 20 Hz - 20 kHz, 1% THD 1 x 150 W 2 x
Summary of the content on the page No. 11
Operator Manual – SRA Series Amplifiers Page - 11 Important Safety Instructions – 2 Amplifier Dimensions Introduction - 3 All SRA Series amplifiers share the same dimensional measurements: The SRA Series - 4 Physical Description - 5 Installation – 6 Operation – 8 Troubleshooting - 9 Spec Table - 10 Dimensions - 11 Warranty - 12 Remote Power Connections All Rights Reserved
Summary of the content on the page No. 12
Page - 12 Operator Manual – SRA Series Amplifiers Important Safety Limited Warranty Instructions – 2 Warranty service for this unit will be provided by ASHLY AUDIO, INC. in accordance with Introduction - 3 the following warranty statement. The SRA Series - 4 Physical Description - 5 ASHLY AUDIO, INC. warrants to the owner of this product that this product and the components thereof, will be free from defects in workmanship and materials for a period of Installation – 6 FIVE years
