Summary of the content on the page No. 1
Model 200 M-Block
Power Amplifier
®
Owner’s Manual
Summary of the content on the page No. 2
Owner’s Manual Owner’s Manual Warnings Installation Location Please Read First To assure proper operation and to avoid the potential for safety hazards, place the unit on a firm and level surface capable of supporting 20 pounds or more. When placing the amplifier on a shelf, be certain that the shelf and any mounting hardware can support the weight of the amplifier and any additional items in the equipment rack, or on the shelf. When positioning the amplifier in its final location, make certa
Summary of the content on the page No. 3
Owner’s Manual Owner’s Manual Unpacking Table of Contents Model 200 M-Block 3 Model 200 M-Block Power Amplifier Power Amplifier 3 Features 3 Unpacking Welcome to the Outlaw Family! With your purchase of a Model 200 M-Block Amplifier you have become part of a unique, worldwide community of audio- 4 Front Panel and Rear Panel philes and home theater enthusiasts. With one or more Model 200 amplifiers 5 Installation and Configuration you have the option to add power and flexibility
Summary of the content on the page No. 4
Owner’s Manual Owner’s Manual Front and Rear Panel Front Panel and Rear Panel � � � � � � � � � � � � � � � � � � � � � � � � � � � � � A � � � � � � �� � � �� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �
Summary of the content on the page No. 5
Owner’s Manual Owner’s Manual Speaker Wire Connections IMPORTANT NOTE: Do not make any change to this switch setting unless Model 200. Connect the other end to a matching jack on the device that the ac power cord is removed from the unit so that the amplifier is totally will be provide a 6 to 35 volt signal when the unit is to be turned on. disconnected from any ac power source. 3. If the source controller does not have a trigger jack, you may use the H AC Power Switch music sense option t
Summary of the content on the page No. 6
Owner’s Manual Owner’s Manual Model 200 Connection Diagram Model 200 Connection Diagram � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �
Summary of the content on the page No. 7
Owner’s Manual Owner’s Manual Operation If you are using spade lugs, connect them to the wire using the manufacturer’s Operation instructions, and then loosen the caps on the speaker terminals. Place lugs Operation of the Model 200 is simple. In normal use there are no controls to between the plastic cap and the back of the terminal, as if it were a horseshoe adjust once the installation is complete. on the game’s post. Again, remember to observe proper polarity. Tighten with After all con
Summary of the content on the page No. 8
Owner’s Manual Owner’s Manual Care and Maintenance to make certain that none of the strands from the “positive” terminal touch Care and Maintenance those from the “negative” terminal. Even a few stray wire strands can cause Cleaning the unit to go into the protection mode. When the unit becomes dirty, wipe it with a clean, soft, dry cloth. If necessary, After checking all speaker connections, turn the unit back on. If it continues first wipe the surface with a soft cloth slightly dampened w
Summary of the content on the page No. 9
Owner’s Manual Owner’s Manual A Few Words About Hum and Noise Ground Loop Diagram Set-top Box Coax Cable Cable Feed A/V Cables 60Hz AC 60Hz AC Ground Loop Ground Loop AC Line AC Line AC Ground Main House Grounding wire where it is connected at the wall outlet. Turn your system back on, and A Few Words About Hum and Noise listen if the hum has disappeared. If removing the cable TV feed has eliminated Audible hum, or a discernable low frequency noise, is one of the most com- the hum, you will
Summary of the content on the page No. 10
Owner’s Manual Owner’s Manual Specifications Warning: if you suspect that the grounding system in your home’s electrical Specifications wiring is causing the hum problem, it is important that you do not make any changes to the wiring yourself. Only a licensed electrician should make any changes to household wiring, and they must be made in full Power Output 200 watts @ 8 ohms, 20 Hz 20 kHz, <0.05% THD compliance with all local building, safety and electrical codes.
Summary of the content on the page No. 11
Owner’s Manual Owner’s Manual Outlaw Audio Limited Warranty The Outlaw Audio 30-Day Satisfaction Guarantee This product is guaranteed to satisfy all your needs for a high performance will be adequately protected. power amplifier. If for any reason, you are not completely satisfied with it, If you decide to return the amplifier, the only cost you will be responsible for please contact us at 866-OUTLAWS (688-5297) within 30 days of receipt of is the shipping charge to return it to us. When your
Summary of the content on the page No. 12
