Summary of the content on the page No. 1
ASP-MG24
QUICK START MANUAL
ASP-MG24
2 input By 4 Output
Signal Processor / Masking Generator
SOFTWARE LOADING FOR USB & QUICK START GUIDE
INTRODUCTION
The Atlas Sound ASP-MG24 is a 2 input by 4 output digital loudspeaker management system and masking
generator designed for fixed sound installation markets. The ASP-MG24 features the latest in available
technology utilizing a 32-bit (40-bit extended) floating point processors and high performance 24-bit Analog
Converters. Both balanced inpu
Summary of the content on the page No. 2
ASP-MG24 QUICK START MANUAL LOADING THE SOFTWARE There are two files on the disk that need to be loaded prior to connecting the ASP-MG24. • ASP-MG24 v0100 • ASP USB driver (CP210x USB to UART to Controller) FOLLOW THE STEPS BELOW. 1. Open the ASP USB driver file and follow the Silicon CP210x prompt wizard. 2. Open the ASP-MG24 folder and click on the Setup file. Follow the wizard prompts until finished. Specifications are subject to change without notice www.AtlasSound.com 1601 JACK MCKAY BO
Summary of the content on the page No. 3
ASP-MG24 QUICK START MANUAL 3. After both programs are installed you need to find out which comport in your computer is assign to use with the ASP-MG24 generator. Turn on the ASP-MG24, the Blue power LED should be on. Next, connect a USB cable from the ASP-MG24 to your computer. Note: A prompt on your computer should pop up and say “New USB Device Found”. Click on it and tell it to locate the USB driver automatically. After the computer matches the computer to the USB driver it must find which
Summary of the content on the page No. 4
ASP-MG24 QUICK START MANUAL 5. After you have located the COM port you can open the ASP-MG24 software. Go to Start, Program files, Atlas and then ASP-MG24. Click on the .exe file which also has the Atlas Logo. I suggest at this time you create a shortcut to your desktop. This can be done by right clicking on the .exe file and select “Create Short Cut. Then drag it onto your desk top. 6. When the ASP-MG24 software is open it should look like the following. 7. The software will ask you if you want
Summary of the content on the page No. 5
ASP-MG24 QUICK START MANUAL 9. Opening a device window. Go to “Start” at the top left. Click onto “Log On”. At this time do not enter a Password. Just click “OK”. 10. Click on “Device 1” and the following screen will appear. In the lower right corner of the Device 1 control box is a Green box indicating the operation status. This will tell you if you are operating Off Line, Link Ok or in process. The ASP-MG24 is also known as a "Device". Note: Multiple ASP-MG24 can be controlled via this GU
Summary of the content on the page No. 6
ASP-MG24 QUICK START MANUAL 12. Now that you went through these setup steps you will not have to again as long as you save the settings when you close out of the ASP-MG24 program. 13. FOUR MAIN SOFTWARE CONTROL SECTIONS. • Mic/Line Input Section – This allows you to adjust gain on any input, set the maximum input levels via the compressor/limiter, assign Hi & Low Cut filters and 8 parametric filter settings • Masking Generator Section – The Masking section allows you select between White &
Summary of the content on the page No. 7
ASP-MG24 QUICK START MANUAL 14. Common Input Sub Windows – Some of these windows are similar type to Masking and output sections. Note: All windows can be moved to meet your viewing preference. Input Gain Window Input Compressor/Limiter Windows Filter Viewing Window Hi & Low Cut Filter Window Parametric Filter Window 15. Masking Section – There are four independent generators that are on random clock associators. Each generator input can be can have gain, Hi & Low cut filters, parametric and 1/
Summary of the content on the page No. 8
ASP-MG24 QUICK START MANUAL Filter Viewing Window 1/3 Octave Window Hi & Low Cut Window 16. Output Section – This section consists of a mixer & signal router, filter section, delay, gain and a limiter section. Note: The mixer section has routing lines to indicate which inputs are assigned to that output. All incoming levels can be adjusted independently to all the required mix level at the output. 17. File Recall and Store – Works like other Windows file structure programs. Program Files Device
