Summary of the content on the page No. 1
VGA, Audio & RS232 Extender SET over Single
CAT5 with RGB Delay Control & IR Pass Through
Model #: VGA-C5ARS-SET
© 2010 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product desc
Summary of the content on the page No. 2
Table of Contents Section 1: Getting Started ...................................................................................................................... 3 1.1 Important Safeguards ............................................................................................................ 3 1.2 Safety Instructions ................................................................................................................. 3 1.3 Regulatory Notices Federal Communications Commi
Summary of the content on the page No. 3
Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Save this manual for future reference. What the warranty does not cover Any product, on which the serial number has been defaced, modified or removed. Damage, deterioration or malfunction resulting from: Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized product modification, or failure to follow instructions suppl
Summary of the content on the page No. 4
1.3 Regulatory Notices Federal Communications Commission (FCC) This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any changes or modifications made to this equipment may void the user’s authority to operate this equipment. 1.4 Introduction With only one cost effective CAT-5e cable, the Avenview VGA-C5ARS-SET lets you extend VGA (WUXG
Summary of the content on the page No. 5
www.avenview.com 5
Summary of the content on the page No. 6
1.5 Package Contents Before you start the installation of the converter, please check the package contents. - VGA-C5ARS-S x 1 - VGA-C5ARS-R x 1 - Power Adapter (+5VDC, 2A) x 2 - User’s Manual x 1 1.6 Before Installation Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction. Don’t place the product in too high temperature (over 50°C), too low temperature (under 0°C) or high humidity. Use the DC powe
Summary of the content on the page No. 7
1.7 Panel Description FRONT PANEL (Transmitter, VGA-C5ARS-S) 1. IR TRANSMITTER: Connect to IR 2. RS-232: Connect to a RS-232 signal Transmitter for IR Pass-Through from source or receiver VGA-C5-ARS-R to VGA-C5ARS-S 3. STEREO IN: Connect to analog audio 4. S/PDIF IN: Connect to digital audio source source 5. AUDIO SELECT: Select between 6. VGA IN: Connect to a VGA input source S/PDIF and STEREO 7. IR INPUT: Connect to IR Receiver for IR Pass-Through from VGA-C5-ARS-S to VGA-C5ARS
Summary of the content on the page No. 8
FRONT PANEL (Receiver, VGA-C5ARS-R) 1. IR TRANSMITTER: Connect to IR 2. RS-232: Connect to a RS-232 Device Receiver 3. STEREO OUT: Connect to analog 4. S/PDIF OUT: Connect to digital audio audio output output 5. VGA OUT: VGA output to VGA 6. IR INPUT: Connect to IR Receiver Display REAR PANEL (Receiver, VGA-C5ARS-R) 1. 5V 2A DC Power Connector 2. RJ45 IN 3. EQ: Rotary Control for equalization of R, 4. GAIN: Rotary control for Gain Control of G, B respectively R, G, B resp
Summary of the content on the page No. 9
1.8 Installation To setup Avenview VGA-C5ARS-SET follow these steps for connecting to a device: 1. Connect VGA source to VGA-C5ARS-S 2. Connect VGA display to VGA-C5ARS-R 3. Connect CAT5/CAT6 cable between Transmitter (VGA-C5ARS-S) and Receiver (VGA-C5ARS-R) 4. Ensure that cables are tightly connected 5. Plug in 5V DC power cord to the power jack of the Receiver VGA-C5ARS-R. 6. Plug in 5V DC power cord to the power jack of the Transmitter VGA-C5ARS-S. 1. If a blurred video is seen or
Summary of the content on the page No. 10
Section 2: Specifications Item Description Units VGA-C5ARS-S VGA-C5ARS-R Unit Description VGA Transmitter with Audio VGA Receiver with RGB Delay Control Video Bandwidth 350MHz Video Support VESA Supported Resolutions Up to WUXGA (1920 x1200) Resolution and Distance WUXGA 1920x 1200 at 300 meters (1000 feet) Audio Support Stereo Continuous Analog Control Equalization 1.2 Volts (peak-to-peak) Input Video Signal - Yes RGB Delay Control - Human body model — ±15kV (air-gap discharge)
Summary of the content on the page No. 11
Notice 1. All transmission distances are measured using Belden 1583A CAT-5e 125MHz LAN cable and STRODESIGN Video Signal Generator VG-859C. The transmission distance is defined as the distance between the video source and the VGA display. 2. The transmission length is largely affected by the type of LAN cables, the type of video sources, and the type of display. The testing result shows solid LAN cables (usually in bulk cable 300m or 1000ft form) can transmit a lot longer signals than stra
Summary of the content on the page No. 12
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequential damages
