Summary of the content on the page No. 1
AUDIO/VIDEO CONTROL RECEIVER
RX-7032VSL
REMOTE CONTROL RM-SRX7032R
CATV/DBS VCR TV AUDIO
RX-7032V AUDIO/VIDEO CONTROL RECEIVER
DVD MULTI DVD CD FM/AM
MASTER VOLUME TV/DBS VCR TAPE/CDR ANALOG/DIGITAL
INPUT
SURROUND
STANDBY
SURROUND DSP SURR/DSP ANALOG
OFF DIRECT
STANDBY/ON DSP EX/ES BASS BOOST∗FRONT•L ∗FRONT•R
1 23
MENU
CD DISC TEST ∗CENTER∗SUB WOOFER
SPEAKERS ON/OFF 4 56
SURROUND/ DSP ENTER
1 OFF MIDNIGHT SURR•L SURR•R
∗ ∗
MODE 7/P 89
BASS BOOST SOUND ∗DIGIT AL EQ∗SURR BACK
10/0 0 +10
2
Summary of the content on the page No. 2
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are pro
Summary of the content on the page No. 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Features Precautions Compatible with various audio formats including Power sources DTS 96/24 • When unplugging the receiver from the wall outlet, always pull the plug, not the AC power cord. RX-7032VSL allows you to enjoy a newly introduced audio •
Summary of the content on the page No. 5
Table of Contents Basic Settings........................................... 24 Parts Identification...................................... 3 Remote Control .......................................................................... 3 Setting the Speakers Configuration .......................................... 24 Front Panel ................................................................................. 4 Basic Setting Items ................................................................... 25
Summary of the content on the page No. 6
Parts Identification 1 buttons (14, 42 – 46) CATV/DBS , VCR , TV , AUDIO Remote Control 2 Source selection buttons (14, 15, 16, 18, 20, 21, 35, 37, 38) DVD MULTI, DVD, CD*, FM/AM*, TV/DBS, VCR, TAPE/CDR* * When you press one on these source selection buttons on the remote control, the receiver automatically turns on. REMOTE CONTROL RM-SRX7032R 3 • SURROUND button (35) • DSP button (37) • SURR (surround)/DSP OFF button (35, 37) CATV/DBS VCR TV AUDIO • EX/ES button (35) 1 4 CD DISC button (41) D
Summary of the content on the page No. 7
Front Panel 1 2 3 4 5 6 7 8 RX-7032V AUDIO/VIDEO CONTROL RECEIVER MASTER VOLUME SURROUND STANDBY DSP STANDBY/ON SPEAKERS ON/OFF SURROUND/ DSP OFF 1 BASS BOOST 2 DVD MULTI DVD VCR TV SOUND/DBS CD TAPE/CDR FM AM SUBWOOFER OUT ON/OFF ANALOG DIRECT SETTING ADJUST MULTI JOG QUICK SPEAKER SETUP EXIT PUSH – OPEN PUSH SET PHONES 9 p y ui o ;a MIDNIGHT EX / ES MODE FM/AM TUNING FM/AM PRESET FM MODE MEMORY INPUT INPUT TUNER CONTROL DIGITAL ANALOG Display Window INPUT ATT qw e r t Inside the front door F
Summary of the content on the page No. 8
Display Window 7 8 1 2 3 4 5 6 9 0- = ~ ! @# $ DUAL ANALOG DIGITAL AUTO 96/24 MULTI RDS TA NEWS INFO TUNED STEREO AUTO MUTING ONE TOUCH OPERA TION SLEEP L CR LINEAR PCM PRO LOGIC NEO:6 VIRTUAL SB MIDNIGHT MODE DIGITAL EQ SUBWFR LFE DIGITAL DSP 3D - PHONIC HEADPHONE SPEAKERS 1 2 BASS BOOST LS S RS INPUT ATT SB VOLUME % ^ & * ( ) _+ ¡ ™ Display Window @ SLEEP indicator (19) 1 DUAL indicator (33) # MIDNIGHT MODE indicator (17) 2 ANALOG indicator (17) $ DIGITAL EQ (equalization) indicator (30) 3
Summary of the content on the page No. 9
Rear Panel 123 45 6 7 AUDIO VIDEO DIGITAL IN SUBWOOFER COMPU LINK-4 SUBWOOFER CENTER RIGHT LEFT VIDEO S-VIDEO OUT (SYNCHRO) DVD IN ANTENNA DVD FRONT IN TV SOUND SURR AM DIGITAL 1 (DVD) (REAR) DBS EXT IN AM RIGHT LEFT LOOP OUT DIGITAL 2 (CD) (REC) VCR IN CAUTION : SPEAKER IMPEDANCE816 (PLAY) DIGITAL 3 (TV) FM 75 CAUTION : SPEAKER IMPEDANCE + + COAXIAL OUT 1 OR 2 : 8 16 (REC) DIGITAL 4 (CDR) 1 AND 2 : 16 32 TAPE SINGLE USE + + CDR See Instruction IN Manual For (PLAY) Connection – – –
Summary of the content on the page No. 10
Getting Started This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply. If the remote control cannot transmit signals or operate the receiver Before Installation correctly, replace the batteries. Use two LR6(AM3)/L40(15A) type dry-cell batteries. General Precautions • Be sure your hands are dry. Notes: • Turn the power off to all components. • Supplied batteries are for the initial setup. Replace the batteries for • Read the
Summary of the content on the page No. 11
RIGHT LEFT RIGHT LEFT RIGHT LEFT AM (MW) Antenna Connections Basic connecting procedure 1 Twist and remove the insulation at Turn the loop until you have the the end of each speaker signal cable best reception. (not supplied). 2 Open the speaker terminal. ANTENNA AM EXT AM AM (MW) Loop LOOP Antenna (supplied) Snap the tabs on the loop into the slots For FRONT SPEAKERS 2 terminals of the base to assemble the AM (MW) 3 Insert the speaker signal cable. loop. FM 75 COAXIAL 1 2 3 4 Close the speake
Summary of the content on the page No. 12
Front speakers 1 Front speakers 2 Center speaker Right / Left Right / Left Surround back speakers* Right / Left CAUTION : SPEAKER IMPEDANCE816 CAUTION : SPEAKER IMPEDANCE + + 1 OR 2 : 8 16 1 AND 2 : 16 32 SINGLE USE + + See Instruction Manual For Connection – – – – RIGHT LEFT LEFT LEFT LEFT RIGHT RIGHT RIGHT 12 CENTER SURROUND BACK SPEAKERS SURROUND SPEAKERS SPEAKER FRONT SPEAKERS IMPORTANT: After connecting the speakers, set the speaker installation information pr
Summary of the content on the page No. 13
Connecting Audio/Video Components Cassette deck To listen to the sound after connection, press TAPE/CDR. When connecting individual components, refer also to the manuals supplied with them. You can connect either a cassette deck or a CD recorder to the TAPE/CDR jacks. When connecting an CD recorder to the TAPE/ Analog Connections CDR jacks, see below. If your audio components have digital audio output terminal, connecting them using the digital cords explained in “Digital Connections” (see page
Summary of the content on the page No. 14
Video component connections TV and/or DBS tuner To listen to the sound after connection, press TV SOUND/DBS (or Use the cables with RCA pin plugs (not supplied). TV/DBS on the remote control). Connect the white plug to the audio left jack, the red plug to the audio right jack, and the yellow plug to the video jack. • If your video components have S-video (Y/C-separation) terminals, connect them using an S-video cable (not supplied). By using this jack, you can get better picture quality than C
Summary of the content on the page No. 15
DVD player • When you connect a DVD player with its analog discrete • When you connect a DVD player with stereo output jacks: output (5.1-channel reproduction) jacks: To listen to the sound after connection, press DVD. To listen to the sound after connection, press DVD MULTI. VIDEO AUDIO VIDEO S-VIDEO SUBWOOFER CENTER RIGHT LEFT DVD IN DVD FRONT IN SURR VIDEO AUDIO (REAR) VIDEO S-VIDEO SUBWOOFER CENTER RIGHT LEFT R L DVD IN DVD FRONT IN SURR DVD player (REAR) R L DVD R L A B C DVD player DVD
Summary of the content on the page No. 16
Digital Connections Digital output terminal This receiver is equipped with four DIGITAL IN terminals—one You can connect any digital components which have an optical digital coaxial terminal and three digital optical terminals—and one digital input terminal. DIGITAL OUT (optical) terminal on the rear. Digital optical cable (not supplied) IMPORTANT: between digital optical terminals • When connecting a DVD player, digital TV broadcast tuner or DBS tuner using the digital terminals, you also need
Summary of the content on the page No. 17
Basic Operations The following operations are commonly used when you play any sound sources. Operations hereafter will be explained using the buttons on the front panel. You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks. Daily Operational Procedure Selecting the Source to Play RX-7032V AUDIO/VIDEO CONTROL RECEIVER RX-7032V AUDIO/VIDEO CONTROL RECEIVER 1 3 4 2 Press one of the source selection buttons. The selected source name
Summary of the content on the page No. 18
Speaker and signal indicators on the display Selecting different sources for picture and sound By checking the following indicators, you can easily confirm which speakers you are activating and which signals are coming into this While watching pictures from a video source, you can listen to receiver. sound of an audio source. • Once you have selected a video source, pictures of the selected Speaker indicators Signal indicators source are sent to the TV until you select another video source. LC R
Summary of the content on the page No. 19
Remote Selecting the Front Speakers Activating and Adjusting the NOT Remote NOT Subwoofer Sound When you have connected two pairs of the front speakers, you can select which to use. You can cancel the subwoofer sound even though you have RX-7032V AUDIO/VIDEO CONTROL RECEIVER connected a subwoofer and have set “SUB WOOFER” to “YES” (see page 29). This is useful when enjoying surround sound at night. RX-7032V AUDIO/VIDEO CONTROL RECEIVER To use the speakers connected to the FRONT SPEAKERS 1 termin
Summary of the content on the page No. 20
2. Press INPUT DIGITAL (or ANALOG/DIGITAL Setting the Dynamic Range INPUT on the remote control) to select “DGTL AUTO.” You can enjoy a powerful sound at night using the Midnight Mode. The DIGITAL AUTO indicator lights up on the display. RX-7032V AUDIO/VIDEO CONTROL RECEIVER DIGITAL AUTO L CR SPEAKERS 1 SUBWFR LFE DIGITAL LS RS VOLUME • When selecting “DIGITAL AUTO,” the following indicators indicate the digital signal format of the incoming signal. : Lights up when Linear PCM signals come LI
