Kenwood TM-V7A user manual

User manual for the device Kenwood TM-V7A

Device: Kenwood TM-V7A
Category: Stereo System
Manufacturer: Kenwood
Size: 2.61 MB
Added : 8/5/2013
Number of pages: 100
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Kenwood TM-V7A. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Kenwood TM-V7A.

For your convenience

If looking through the Kenwood TM-V7A user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Kenwood TM-V7A on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Kenwood TM-V7A to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Kenwood TM-V7A User manual - Online PDF
Advertisement
« Page 1 of 100 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Kenwood TM-V7A but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Kenwood TM-V7A. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1

144/440 MHz FM DUAL BANDER
TM-V7A
144/430 MHz FM DUAL BANDER
TM-V7A
144/430 MHz FM DUAL BANDER
TM-V7E
INSTRUCTION MANUAL
KENWOOD CORPORATION
© B62-0678-20 (K,E,M)
09 08 07 06 05 04 03 02

Summary of the content on the page No. 2

THANK YOU! FEATURES We are grateful you decided to purchase this KENWOOD • Enhanced Programmable Memory (PM) channels store FM transceiver. This series of mobile transceivers were virtually entire current operating environments for your developed to satisfy the requirement for a compact rig quick recall. that’s simple to operate yet contains numerous • A maximum of 280 memory channels are available, 140 sophisticated features. The dual band operation will be each for VHF and UHF. Up to 180 me

Summary of the content on the page No. 3

NOTICES TO THE USER PRECAUTIONS One or more of the following statements may be applicable: Please observe the following precautions to prevent fire, personal injury, and transceiver damage: FCC WARNING This equipment generates or uses radio frequency energy. Changes or • When operating mobile, do not attempt to configure modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The your transceiver while driving be

Summary of the content on the page No. 4

CONTENTS SUPPLIED ACCESSORIES ...................................... 1 SELECTING FREQUENCIES.................................. 17 CONVENTIONS FOLLOWED IN THIS MANUAL....... 1 Tuning Control .................................................... 17 Microphone [UP]/[DWN] Buttons ......................... 17 1 PREPERATION FOR MOBILE AND FIXED STATION OPERATION MOBILE INSTALLATION ........................................... 2 TRANSMITTING...................................................... 18 Select

Summary of the content on the page No. 5

1 Changing Call Channel Contents (Simplex) ........ 33 USING CTCSS ........................................................ 49 Changing Call Channel Contents (Split) .............. 34 Automatic Tone Frequency ID ............................. 49 2 MEMORY Æ VFO TRANSFER ................................ 34 11 DUAL TONE SQUELCH SYSTEM (DTSS) 3 CHANNEL DISPLAY FUNCTION............................. 34 STORING DTSS CODES ........................................ 50 INITIALIZING MEMORY ..................

Summary of the content on the page No. 6

PROGRAMMABLE VFO.......................................... 64 17 REPEATER FUNCTION (U.S.A/ CANADA ONLY) SWITCHING AM/FM MODE LOCKED-BAND REPEATER ................................... 81 (SOME VERSIONS ONLY) ...................................... 64 CROSS-BAND REPEATER ..................................... 81 CHANGING FREQUENCY STEP SIZE ................... 65 TX HOLD ................................................................. 81 CHANGING MULTI-FUNCTION BUTTON LABELS . 66 18 VS-3 VOICE SYNTH

Summary of the content on the page No. 7

CONVENTIONS FOLLOWED IN THIS MANUAL SUPPLIED ACCESSORIES The writing conventions described below have been Accessory Part Number Quantity followed to simplify instructions and avoid unnecessary Microphone repetition. U.S.A./ Canada/ 1 1 ATTENTION: MOST PROCEDURES REQUIRE THAT YOU PRESS AN T91-0568-XX General (some): MC-53DM APPROPRIATE KEY IN EACH STEP WITHIN APPROXIMATELY 10 Europe/ SECONDS, OR THE PREVIOUS MODE WILL BE RESTORED. 1 1 General (some): MC-45 T91-0396-XX Instruction What to d

Summary of the content on the page No. 8

FM DUAL BANDER TM-V7 KENWOOD PREPARATION FOR MOBILE AND FIXED STATION OPERATION 1 n Installation Steps MOBILE INSTALLATION 2 1 Install the mounting bracket in the vehicle using the Install the transceiver in a safe, convenient position inside 3 supplied flat washers and self-tapping screws. your vehicle that minimizes danger to your passengers and 4 There are 4 washers and 4 screws supplied. yourself while the vehicle is in motion. For example, consider installing the transceiver under the d

Summary of the content on the page No. 9

2 After the cable is in place, wind heat-resistant tape DC POWER CABLE CONNECTION around the fuse holder to protect it from moisture. 1 Tie down the full run of cable. n Mobile Operation 2 3 To prevent the risk of short circuits, disconnect other The vehicle battery must have a nominal rating of 12 V. 3 wiring from the negative (–) battery terminal before Never connect the transceiver to a 24 V battery. Be connecting the transceiver. sure to use a 12 V vehicle battery that has sufficient 4 cur

Summary of the content on the page No. 10

2 Connect the transceiver’s DC power connector to n Fixed Station Operation the connector on the DC power cable. 1 In order to use this transceiver for fixed station • Press the connectors firmly together until the locking 2 operation, you will need a separate 13.8 V DC power tab clicks. supply that must be purchased separately. The 3 recommended current capacity of your power supply is 12 A. 4 1 Connect the DC power cable to the regulated DC Press 5 firmly. power supply and check that polariti

Summary of the content on the page No. 11

n Replacing Fuses ANTENNA CONNECTION 1 If the fuse blows, determine the cause then correct the Before operating, you must first install an efficient, problem. After the problem is resolved, then replace the well-tuned antenna. The success of your installation will 2 fuse. If newly installed fuses continue to blow, depend largely on the type of antenna and its correct 3 disconnect the power cable and contact your dealer or installation. The transceiver can give excellent results if the the ne

Summary of the content on the page No. 12

KENWOOD FM DUAL BANDER TM-V7 ACCESSORY CONNECTIONS PACKET EQUIPMENT CONNECTIONS 1 If you intend to use this transceiver for Packet operation, n External Speakers 2 you will need the following equipment. • Personal computer with communications software If you plan to use external speakers, choose speakers 3 with an impedance of 8 W . The external speaker jacks • Terminal Node Controller (TNC) 4 accept a 3.5 mm (1/8") diameter mono (2-conductor) • TNC power supply plug. Recommended speakers in

Summary of the content on the page No. 13

YOUR FIRST QSO 1 2 If you tend to discard instruction manuals along with the packaging q Switch ON the DC power supply, 3 material .....please don’t. The 6 steps given here will get you on the then press the PWR switch. air in your first QSO right away. So, you can enjoy the exhilaration 4 that comes with opening a brand new transceiver. 5 After trying the rig for a while, settle back in your most comfortable operating chair with this manual and your favorite drink for an hour or 6 w Turn the

Summary of the content on the page No. 14

GETTING ACQUAINTED 1 Programmable Memory (PM) mode BASIC TRANSCEIVER MODES 2 Press [PM] to select. In this mode you can select the This section introduces you to the basic modes you can 3 transceiver environment, by pressing [1] to [4], that you select, and differences between the TX band and the 4 stored in PM channels {page 36}. Control band. 5 VFO mode CALL CALL PWR PWR 6 Press [VFO] to select. In this mode you can change the 7 operating frequency using the Tuning control or Mic VOL SQ

Summary of the content on the page No. 15

TX-Band BUTTON FUNCTION DISPLAY 1 Press the left [BAND SEL] (VHF) or the right [BAND SEL] The lower portion of the display has labels that indicate the (UHF) to select. "PTT" on the display shows which band current function of each of the 4 front panel buttons. The 2 (VHF or UHF) is currently selected as the transmit (TX) italic font is used to show these 4 buttons in the description 3 band. You can use the TX band to transmit signals or to of each operation step. After pressing [F] or [F] (

Summary of the content on the page No. 16

e e e e e MR button FRONT PANEL 1 Selects the Memory Recall mode {page 31}. In this mode Note: This section describes only the main functions of the front panel you can change memory channels, using the Tuning 2 controls and buttons. For the functions not described here, you will find control or Mic [UP]/[DWN]. Also starts or stops Memory explanations in the appropriate sections of this manual. 3 Scan {page 44}. 4 r r r r r Tuning control CALL CALL PWR PWR 5 Selects: • Operating frequencies

Summary of the content on the page No. 17

!0 !0 !0 !0 !0 SQL controls 1 Adjusts the squelch threshold level {page 16}. This allows you to mute speaker output while no stations are being 2 CALL CALL PWR PWR received. Turn the left control (VHF) or the right control 3 (UHF) depending on which band you want to operate. !1 !1 !1 !1 !1 VOL controls/ BAND SEL buttons 4 When turned, these controls adjust the level of receive 5 audio from the speaker {page 16}. Turn the left control 6 (VHF) or the right control (UHF) depending on which band

Summary of the content on the page No. 18

REAR PANEL 1 CALL CALL PWR PWR 2 3 4 5 6 7 !3 !3 !3 !3 !3 MNU button 8 q q q q q Antenna connector Selects the Menu mode {page 19}. Connect an external antenna {page 5}. When making test 9 !4 !4 !4 !4 !4 PM button transmissions, connect a dummy load in place of the 10 antenna. The antenna system or load should have an Selects the Programmable Memory mode {page 36}. impedance of 50 W . The TM-V7E accepts a male N-type 11 !5 !5 !5 !5 !5 PWR switch connector and other versions accept a male PL-2

Summary of the content on the page No. 19

t t t t t CALL key MICROPHONE y y y y y VFO key 1 MC-53DM MC-45 u u u u u MR key 2 1 2 2 1 Identical to the front panel CALL, VFO, and MR buttons. DWN UP 3 These keys can be re-programmed, if desired {page 72}. 3 7 7 8 3 8 i i i i i PF key 4 MIC 5 5 CALL VFO MR PF Depending on which function you select by accessing 5 LOCK "PF1" in Menu No. 16 {page 21}, the function of this key 6 6 ELECTRET CONDENSER MIC 6 MADE IN JAPAN 4 4 differs. Refer to "CONFIGURING PROGRAM FUNCTION KEYS" {page 72}. 7 o

Summary of the content on the page No. 20

INDICATORS Indicator What You Selected What You Press to Cancel 1 On the display you will see various indicators that show Plus offset direction [F], [SHIFT], [F], 2 what you have selected. Sometimes you may not recall [SHIFT] ( TM-V7E: one what those indicators mean or how you can cancel the more [F], [SHIFT] ) 3 current setting. In such a case, you will find this table very [F], [SHIFT] (TM-V7E: Minus offset direction useful. 4 one more [F], [SHIFT] ) 5 Minus offset direction [F], [SHIFT]


Alternative user manuals
# User manual Category Download
1 Kenwood TM-V7A User manual Car Stereo System 4
2 Kenwood TM-V7A User manual Marine Radio 2
3 Kenwood AVS-1002B User manual Stereo System 34
4 Kenwood 855 AV User manual Stereo System 15
5 Kenwood CD-206 User manual Stereo System 15
6 Kenwood Cassette Tape Deck X-SE7 User manual Stereo System 62
7 Kenwood ADVANCED INTEGRATION A/V CONTROLLER KOS-V500 User manual Stereo System 9
8 Kenwood B60-5632-00 00 MA (E, X) AP 0602 User manual Stereo System 3
9 Kenwood CD-404 User manual Stereo System 8
10 Kenwood C-707I User manual Stereo System 16
11 Kenwood CD-224M User manual Stereo System 4
12 Kenwood CD Player DP-SE7 User manual Stereo System 24
13 Kenwood CD-403 User manual Stereo System 31
14 Kenwood CD-406 User manual Stereo System 10
15 Kenwood AX-7 User manual Stereo System 22
16 Sony 3-287-077-14(2) User manual Stereo System 128
17 Sony 3-300-703-11(2) User manual Stereo System 16
18 Sony 3-452-364-11(1) User manual Stereo System 6
19 Sony 3-294-663-11(2) User manual Stereo System 7
20 Sony 3-CD DOUBL MHC-RG290 User manual Stereo System 179