Summary of the content on the page No. 1
MXDK5_3_1_Cover.fm Page 1 Monday, February 20, 2006 11:00 AM
COMPACT COMPONENT SYSTEM
CA-MXDK5
MX-DK3
—Consists of CA-MXDK3,
SP-MXDK3F and SP-MXDK3W
MX-DK1
—Consists of CA-MXDK1 and
SP-MXDK1F
MX-DK15
—Consists of CA-MXDK15 and
SP-MXDK15F
(For CA-MXDK5) (For CA-MXDK5) (For CA-MXDK5)
(For CA-MXDK5)
INSTRUCTIONS
GVT0177-001B
[US,UN,UG,UX,A,UW]
Summary of the content on the page No. 2
MXDK5_3_1_Safety.fm Page 1 Thursday, January 26, 2006 11:36 AM Warnings, Cautions and Others Caution–– (standby/on) button! Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). When installing the apparatus, ensure that the plug is easily accessible. The (standby/on) button in any position does not disconnect the mains line. • When the System is on standby, the STANDBY lamp lights red. • When the System is turned on, the STANDBY lamp goes off.
Summary of the content on the page No. 3
MXDK5_3_1_Safety.fm Page 2 Thursday, January 26, 2006 11:36 AM Caution: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows 1. Front: No obstructions and open spacing. 2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. The minimal clearance is sh
Summary of the content on the page No. 4
MX_DK5_3_1.book Page 1 Thursday, February 23, 2006 11:05 AM Introduction Precautions Playable Disc Types INFO * * * Installation • Install the System in a location with adequate ventilation to prevent internal heat buildup in the System. COMPACT DO NOT install the System in a location near DIGITAL VIDEO heat sources, or in a place subject to direct DIGITAL AUDIO sunlight, excessive dust or vibration. DVD Logo is a trademark of DVD Format/Logo Licensing Corporation. • Insta
Summary of the content on the page No. 5
MX_DK5_3_1.book Page 2 Thursday, February 23, 2006 11:05 AM The System can play back the following digital audio Contents formats. • LPCM (Linear PCM), DIGITAL (Dolby Digital), Connections .............................................................3 DTS (Digital Theater Systems), MLP (Meridian Lossless Preparing the Remote Control ............................................ 6 Packing) Changing the Color System and Scanning Mode .............. 6 Caut
Summary of the content on the page No. 6
MX_DK5_3_1.book Page 3 Thursday, February 23, 2006 11:05 AM Connections Do not connect the AC power cord until all other Supplied Accessories connections have been made. • FM antenna (1) • AM loop antenna (1) • Composite video cord (1) • Connect VIDEO OUT directly to the video input of your • Remote control (1) TV. Connecting VIDEO OUT to a TV via a VCR may cause • Batteries (2) a monitor problem when playing back a copy-protected • AC plug adaptor (1) (not supplied for the Middle East d
Summary of the content on the page No. 7
MX_DK5_3_1.book Page 4 Thursday, February 23, 2006 11:05 AM ~ AM/FM antenna Ÿ TV/monitor To assemble the AM loop antenna Green Blue Red Component To connect AM/FM antenna video cord (not supplied) FM antenna (supplied) Composite video S-video cord cord (supplied) (not supplied) Extend it so that you can obtain the best reception. • Connect the VIDEO jack, S-VIDEO jack, or COMPONENT jacks (CA-MXDK5 only) whichever you AM loop antenna want to use. (supplied) • To select progre
Summary of the content on the page No. 8
MX_DK5_3_1.book Page 5 Thursday, February 23, 2006 11:05 AM ¤ Surround speakers (for CA-MXDK5 and For the Australian model MX-DK3) From right surround speaker (not supplied) From left surround speaker (not supplied) • The surround speakers connected can reproduce the bass sounds recorded in front left and right channels, but cannot reproduce the surround signals recorded in DVD multi- channel discs. Stereo mini plug (not supplied) # Main speakers @ Subwoofers (for CA-MXDK5 and MX-DK
Summary of the content on the page No. 9
MX_DK5_3_1.book Page 6 Thursday, February 23, 2006 11:05 AM • Dispose of batteries in the proper manner, according to ‹ Voltage Selector federal, state, and local regulations. Use a screwdriver to rotate the voltage selector so that the When using the remote control voltage mark is pointing to the same voltage as where you Point the top of the remote control toward the remote sensor are plugging in the unit. (See also the back cover page.) as directly as possible. I
Summary of the content on the page No. 10
MX_DK5_3_1.book Page 7 Thursday, February 23, 2006 11:05 AM Display Indication The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 PROGRESSIVE indicator (CA-MXDK5 only) q Source signal indicators • Lights when the progressive scanning mode is selected • D: lights when a source signal is Dolby Digital. (see page 6). • DTS: light
Summary of the content on the page No. 11
MX_DK5_3_1.book Page 8 Thursday, February 23, 2006 11:05 AM Daily Operations—Playback ¥ Turn on the power. In this manual, the operations using the remote control The STANDBY lamp on the main unit goes off. are mainly explained; however, you can use the buttons • Without pressing AUDIO, the System also turns and controls on the main unit if they have the same (or on by pressing one of the source select buttons in the similar) name and marks. next step. ø Select the sourc
Summary of the content on the page No. 12
MX_DK5_3_1.book Page 9 Thursday, February 23, 2006 11:05 AM Remote ONLY If the FM station has poor reception To drop the volume in a moment To restore the volume, press again, or The MONO indicator lights on the display. adjust the volume level. Reception will improve though stereo effect is lost—monaural reception mode. To restore the stereo effect, press the button again (the MONO indicator goes off). Listening to the Radio INFO Remote ONLY Main Unit
Summary of the content on the page No. 13
MX_DK5_3_1.book Page 10 Thursday, February 23, 2006 11:05 AM While playing a disc except CDs: This System can store the Playing Back a Disc INFO stop point, and when you start playback again by pressing DVD/CD 3 (even while on standby), it starts from the Before operating a disc, be familiar how a disc is recorded. position where you have stopped—Resume Play. (RESUME • DVD Video/DVD-VR consist of “Titles” which include appears on the displa
Summary of the content on the page No. 14
MX_DK5_3_1.book Page 11 Thursday, February 23, 2006 11:05 AM Remote ONLY To select an item directly To move to the next or To return to the previous You can select a title/chapter/track directly and start previous page of the menu: playback. current menu: For DVD Video, you can select a title before starting playback, while you can select a chapter after starting playback. Examples: To select number 5, press 5. To select number 10, press 10. (While holding
Summary of the content on the page No. 15
MX_DK5_3_1.book Page 12 Thursday, February 23, 2006 11:05 AM Daily Operations—Sound & Other Adjustments Reinforcing the Bass Sound Remote Control To change the bass level For CA-MXDK5 and MX-DK3 VFP ACTIVBASS 0 1 2 DIMMER CLOCK/ DISPLAY • You can also use ACTIVE BASS EXTENSION +/– on the , , , ENTER/SET main unit. For MX-DK1 and MX-DK15 A.BASS ON SOUND MODE 3D PHONIC A.BASS OFF SOUND TURBO DVD LEVEL* SHIFT • You can also use ACTIVE BASS EXTENSION on the + –* AHB LEVEL ,
Summary of the content on the page No. 16
MX_DK5_3_1.book Page 13 Thursday, February 23, 2006 11:05 AM Creating 3-dimensional Sound Field Creating Your Own Sound Modes Remote —3D Phonic —User Mode ONLY INFO INFO While playing a disc except DVD Audio... You can create your own Sound Modes to make sounds suit your taste. The changed settings can be stored as the USER 1, 3D ACTION 3D DRAMA USER 2 and USER 3 Modes. 3D OFF 3D THEATER 1 Select one of the preset Sound Modes. • If you want
Summary of the content on the page No. 17
MX_DK5_3_1.book Page 14 Thursday, February 23, 2006 11:05 AM 3 Adjust the parameter. Remote Changing the Picture Tone ONLY While showing a playback picture on the TV, you can select the preset picture tone, or adjust it and store your own settings. To select a preset picture tone 1 While playing, display VFP setting screen. NORMAL GAMMA 0 4 Repeat steps 2 to 3 to adjust other parameters. BRIGHTNESS 0 CONTRAST 0 To remove the setting screen,
Summary of the content on the page No. 18
MX_DK5_3_1.book Page 15 Thursday, February 23, 2006 11:05 AM Unique DVD/VCD Operations Remote ONLY Selecting the Sound Track INFO Remote Control For DVD Video/DivX (CA-MXDK5 only): While playing back a chapter containing audio languages, you can select the language to listen to. SUB TITLE For DVD Audio (CA-MXDK5 only): While playing back a AUDIO/MPX ANGLE track containing audio channels, you can select the audio ZOOM channel to listen to. PAGE (CA-MXDK5 For DVD-VR or SVC
Summary of the content on the page No. 19
MX_DK5_3_1.book Page 16 Thursday, February 23, 2006 11:05 AM Remote While playing a DVD-VR... ONLY Selecting the Subtitle Language ON For DVD Video: While playing back a chapter containing ON subtitles in different languages, you can select the subtitle language to display on the TV screen. For SVCD: While playing, you can select the subtitles even OFF if no subtitles are recorded on the disc. (While holding...) For DVD-VR: While playing, you can turn the subtitle on or
Summary of the content on the page No. 20
MX_DK5_3_1.book Page 17 Thursday, February 23, 2006 11:05 AM Remote ONLY Remote Slow-motion playback ONLY Playing Back a Bonus Group • This does not function for MPEG-1/MPEG-2/ASF*/ (CA-MXDK5 only) DivX* discs. *Only for CA-MXDK5. INFO 1 While playing... For DVD Audio only: Some DVD Audio discs have a special group called “bonus group” whose contents are not Still picture playback starts. open to the public. • To play back a bonus group, you have to e
