Encore electronic ENHGS-800 user manual

Summary of the content on the page No. 1

ENHGS-800
GIGABIT 8-PORT
ETHERNET SWITCH

User Guide
0

Summary of the content on the page No. 2

FCC Certifications This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radi

Summary of the content on the page No. 3

The device is a powerful, high-performance Gigabit Ethernet switch, with all ports capable of 10, 100 or 1000Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications. Moreover, the 10/100/1000Mbps auto-sensing

Summary of the content on the page No. 4

Please refer to the following table for LED definition 5-Port 8-Port LED Status Operation Power Steady Green Power is on Off Power is off 1000M Steady Green Connected as 1000Mbps Blinking Green The port is transmitting/receiving data. 100M Steady Green Connected as 100Mbps Blinking Green The port is transmitting/receiving data. 10M Steady Green Connected as 10Mbps Blinking Green The port is transmitting/receiving data. 3

Summary of the content on the page No. 5

Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to

Summary of the content on the page No. 6

Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control Interface 5/ 8* 10/100/1000Mbps RJ-45 Gigabit Ethernet Ports Uplink Auto MDI/MDI-X （Auto crossover ） Network 10/100/1000Mbps & Full/Half duplex mode auto Speed detection (1000Mbps for Full duplex only) MAC Addr. 8K MAC entries Table Buffer 144K byte ( 8-Port Model ) Memory 112K byte ( 5-Port Model ) Jumbo 9K bytes Frame Power External Power adapte