Summary of the content on the page No. 1
4-slot Managed Modular Switch
MGSW-004
User’s Manual
Summary of the content on the page No. 2
Trademarks Copyright © PLANET Technology Corp. 2003. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. Disclaimer PLANET Technology does not warrant that the hardware will work properly in all environments and applications, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a par
Summary of the content on the page No. 3
TABLE OF CONTENTS CHAPTER 1 INTRODUCTION..................................................................................................1 1.1 CHECKLIST ........................................................................................................................ 1 1.2 ABOUT THE SWITCH ........................................................................................................... 1 1.3 PRODUCT FEATURE.....................................................................
Summary of the content on the page No. 4
4.9 PORT SECURITY .............................................................................................................. 19 4.10 PRIORITY – 802.1P........................................................................................................ 20 4.11 PRIORITY 2 – TOS (TYPE OF SERVICE)........................................................................... 20 4.12 IGMP............................................................................................................
Summary of the content on the page No. 5
Chapter 1 Introduction 1.1 Checklist Thank you for purchasing Planet’s MGSW-004 Managed Modular Switches. Before continuing, please check the contents of your package for following parts: Ø MGSW-004 Managed Modular Switches Ø Power Cord Ø RS-232 cable Ø CD-ROM Ø Rock mounting brackets Ø Four Robber foot Ø Quick installation Guide Ø Rock-mounting bracket Note: if any of these pieces are missing or damage please contact your dialer immediately. 1.2 About the Switch Planet’s
Summary of the content on the page No. 6
1.3 Product Feature Ø Conforms to IEEE 802.3, 802.3u, 802.3z, 802.3ab and 802.3x standards Ø 4 expansion slots to configure flexible network Ø One built-in intelligent module with RS-232 console port ( front side ) Ø Supports Half-duplex mode for backpressure, and full-duplex for flow-control Ø Store-and-Forward switching architecture for abnormal packet filtering Ø Up to 9.6Gbps Back-plane forwarding rate Ø Mac address: 4K for 8 port 10/100 TX and Gigabit module, 12K for 2/4/8 port
Summary of the content on the page No. 7
Chapter 2 HARDWARE INSTALLATION This section is describes the hardware features and installation of 4-slot Managed Modular Switch. Before using MGSW-004, read the user’s manual carefully. MGSW-004 has provide different modules Ø 8-Port 10/100 auto-sensing Intelligent Switch Module Ø 4-Port 100 Base-FX Intelligent Fiber Module Ø Gigabit 1000Base-T Intelligent Switch Module Ø Gigabit 1000Base-SX/LX Intelligent Fiber Module 2.1 Font Panel The font panel of the 4-slot Managed Modular
Summary of the content on the page No. 8
Console ports The RS-232 console port is an interface that directly connects to the PC. When the connection between the PC and switch is ready, run the Hyper Terminal and configure its communication parameters. The operating mode of the console port is: Ø Baud rate: 9600 Ø Data bits: 8 Ø Parity: none Ø Stop bits: 1 Ø Flow control: none After finished the setting, click OK. 2.2 Rear Panel The Rear Panel of the switch is indicates an AC inlet power socket and on and off switch, which
Summary of the content on the page No. 9
Desktop installation For desktop installation, make sure the desk is flat and clean. Plug all the network cables and the power cord then the system is ready. Note: Do not obstruct any vents at the sides of the case and keep water off. Rock-mount installation MGSW-004 can be mounted in a standard 19-inch rack. The following steps is teaching user how to Rack Mounting the Switch in the 19-inch rack: 1. Disconnect all cables from the switch. 2. Place the unit the right way up on
Summary of the content on the page No. 10
Chapter 3 Console and Telnet Management 3.1 connect To PC by RS-232 cable The RS-232 console port is an interface that directly connects to the PC. When the connection between the PC and switch is ready, run the Hyper Terminal and configure its communication parameters. The operating mode of the console port is: Ø Baud rate: 9600 Ø Data bits: 8 Ø Parity: none Ø Stop bits: 1 Ø Flow control: none After finished the setting, click OK. 3.2 Telnet To access the switch through
Summary of the content on the page No. 11
3.3 Main Menu The main menu displays all the sub-menus that are available. Striking Enter, at a highlighted option, will confirm the choice of the specified sub-menu. There are thirteen menu items to choose from: Ø Device Settings Ø Port settings Ø Address Table Ø Spanning Tree Protocol Ø Broadcast Storm Filter Ø IGMP Ø VLAN Mode (2 modes) Ø VLAN for CPU (2 VLANs) Ø Secure IP for Telnet and HTTP Ø Save Current Settings Ø Factory Default Settings & Reboot System Ø Reboot System
Summary of the content on the page No. 12
Ø System Name: display and change the system name of this Switch Ø System Location: display and set the location of this Switch Ø System Contact: display and set the administrator of this Switch Ø IP Address: display and set the IP address of MGSW-004 Ø Subnet Mask: display and set the Subnet Mask of MGSW-004 Ø Default Gateway: display and set the gateway of MGSW-004 Ø Change User/Password: allow to set the User name and password Ø Console Login Enabled: provide enable or disable Consol
Summary of the content on the page No. 13
3.3.3 Address Table This menu contains four items for MAC address record on each working port Ø All Ø Module Ø Module Port Ø Quit 3.3.4 Spanning Tree Protocol This menu contains three items to enable or disable STP: Ø Enable Ø Disable Ø Quit 9
Summary of the content on the page No. 14
3.3.5 Broadcast Storm Filter This menu contains three items to enable or disable Broadcast Storm Filter: Ø Enable Ø Disable Ø Quit 3.3.6 IGMP This menu contains three items to enable or disable IGMP: Ø Enable Ø Disable Ø Quit 3.3.7 VLAN Mode (2 modes) This menu contains two items for 2 VLAN mode selections: Ø VLAN is valid for all packets Disable Ø VLAN is valid for broadcast and multicast packets, not for unicast packets. Ø Quit 10
Summary of the content on the page No. 15
3.3.8 VLAN for CPU (2 VLANs) This menu contains two items for 2 VLANs for CPU: Ø Current first VLAN for CPU: VLAN ID 1Current second Ø VLAN for CPU: None Ø Quit 3.3.9 Secure IP for Telnet and HTTP This menu contains seven items for Secure IP setting: Ø Secure IP for Telnet: Disabled (default value) Ø Secure IP for HTTP: Disabled (default value) Ø Secure IP 1: Ø Secure IP 2: Ø Secure IP 3: Ø Secure IP 4: Ø Quit 3.3.9.1 Secure IP for Telnet Disable allow any PC login i
Summary of the content on the page No. 16
MGSW-004 3.3.9.3 Secure IP 1,2,3,4 Allow setting 4 Secure IP addresses of 4 PCs 3.3.10 Save Current Settings This menu provide save current settings of this Switch. 3.3.11 Factory Default Settings & Reboot System This menu provide restore to the default settings of this Switch 3.3.12 Reboot System This menu provides reboot the Switch 12
Summary of the content on the page No. 17
3.3.13 Quit This menu provide logout the switch 13
Summary of the content on the page No. 18
Chapter 4 WEB MANAGEMENT MGSW-004 support web management therefore in this section will introduce the configuration and functions of the web-based management. Before to use web management, please setup the IP Address with the console port (RS-232) and use this IP address to configure MGSW-004 through the web interface or modify your PC’s IP domain to the same with MGSW-004 then use the default IP address to remote configure MGSW-004 through the Web interface. 4.1 login into switch Ø Use
Summary of the content on the page No. 19
4.2 Home The homepage is display the configuration of the MGSW-004 An administratively-assigned name of the managed System Name unit System Location The physical location of this managed unit System Contact The contact person for this managed unit. System Up Time The time last since the managed unit IP Address The IP address of the managed unit Subnet Mask The subnet mask of the managed unit Default Gateway The default Gateway of the managed unit MAC Address The MAC address of the m
Summary of the content on the page No. 20
4.5 Statistics (Port Counters) and Statistics 2 (RMON Statistics) The Statistic page displays the detailed information about each port. You can compare and evaluate throughput or other port parameters. All screen data is updated automatically .You can clear 8 counters or packet seize counters of some ports by select the corresponding "Clear" check boxes then press "Clear" button. To clear all counters of all ports, press the "Select All" button then "Clear" button. 16
