Summary of the content on the page No. 1
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Contents Declaration of Conformity ......................................................................................................................................................................3 Safety Considerations .............................................................................................................................................................................6 Information about this Hardware Guide ..............................................................
Summary of the content on the page No. 4
Summary of the content on the page No. 5
Declaration of Conformity Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, Oregon 97223-8368 USA We declare under our sole responsibility that this tablet conforms to the following directives and norms: • EMC Directive 2004/108/EC: o EN 55022 o EN 55024 o EN 61000-3-2 o EN 61000-3-3 • Low Voltage Directive 2006/95/EC • Safety: IEC 60950-1:2005 • R&TTE Directive: 1999/5/EC Trademarks Apple, Mac and Facetime are trademarks or registered trademarks of Apple, Inc. Microsoft, Wind
Summary of the content on the page No. 6
Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB- 003 du Canada. INFORMATION FOR RADIO FREQUENCY DEVICES ONLY: This device complies with part 15 of the FCC Rules / RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. INFORMATION PO
Summary of the content on the page No. 7
Energy Star As an ENERGY STAR Partner, InFocus Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency. ENERGY STAR® is a joint program of the U.S. Environmental Protection Agency and the U.S. Department of Energy aimed at saving money and protecting the environment through energy efficient products and practices. We are proud to offer our customers products with an ENERGY STAR compliant design. This product has been designed and tested to conform
Summary of the content on the page No. 8
Safety Considerations Please read and follow all safety instructions provided below and on the monitor before connecting the monitor to a power source. Failure to comply with safety instructions may result in fire, electrical shock, or personal injury and may damage or impair protection provided by the equipment. Please save all safety instructions. • This tablet is very heavy and should be moved and installed by at least two individuals. Do not attempt to move or install the tablet yourself
Summary of the content on the page No. 9
• Unplug the tablet if you are not going to use it for an extensive period of time. • Unplug the tablet if you need to clean it with the included microfiber cleaning cloth. The screen may be wiped with the cleaning cloth when the power is off. Never use alcohol, solvents or ammonia-based liquids on this product. • Wash hands after handling the cables supplied with this product. • The tablet remote control, mouse and keyboard use batteries. Make sure the batteries’ polarity (+/-) is aligned corr
Summary of the content on the page No. 10
Information about this Hardware Guide Although your INF5520 comes pre-installed with the Mondopad software, you must first assemble the INF5520. This Hardware Guide will assist you in setting up the INF5520. After your INF5520 is fully installed, please refer to the Mondopad Software Guide at www.infocus.com/INF5520docs for more infor- mation. Page 8
Summary of the content on the page No. 11
What’s Included 1920 x 1080 Mondopad™ c ollabor a tion t able t POWER HOME INPUT MENU RESIZE PIP ON/OFF INPUT SWAP POSITION AUDIO BRIGHTNESS CONTRAST OK BACK INFO Quick Setup i VOL UP Guide MUTE VOL DOWN Security tool Documen t a tion Cleaning cloth Thumb screws Remote control (set of four) (ba tt eries not included) Camera Power cords USB cable, 3M Stylus** VGA cable, 4M (varies per country) (Type A to B) These items are Sound bar shipped in a sepa- rate box Moun ting br ack e ts Thumb s
Summary of the content on the page No. 12
Setup Attaching the Sound Bar NOTE: If you are not attaching the sound bar, proceed to the next section, “Installing the Feet” on page 12. 1) Carefully place your tablet face-down on a clean, cushioned surface with the top edge hanging off of the cushioned surface by 4-5” (10-13cm). Do NOT place the INF5520 on its back. 2) Attach the two small rectangular brackets to the sound bar with the provided screws as shown below. 3) Remove four screws from the back of Mondopad as shown below. Power Sw
Summary of the content on the page No. 13
Summary of the content on the page No. 14
Installing the Feet 1) If you have not already done so, carefully place your tablet face-down on a clean, cushioned surface with the top edge hanging off of the cushioned surface by 4-5” (10-13cm). Do NOT place the INF5520 on its back. 2) Remove the tablet feet slot covers with a Philips screwdriver. Discard or save for future use. 3) Slide the feet into the slots provided (the longer side of the feet point toward the front of the tablet), then secure the legs to the tablet with the provided
Summary of the content on the page No. 15
Attaching the HD Video Conferencing Camera 1) Remove the plastic film from the camera lens. 2) Align the camera bracket with the screw holes on the top edge of the backside of the tablet and then secure the camera to the tablet with the two provided thumb screws. 3) Plug the USB cable into an available USB slot on the back of the tablet. 4) Manually tilt and pan the camera (+/- 40°) as desired. INF5520 Hardware Guide Page 13
Summary of the content on the page No. 16
Connecting to Other Devices A full range of digital and analog video inputs and audio source devices can be connected to the connection panels on the back and side of Mondopad™, if desired. Available jacks include: HDMI® (2), VGA, Component (RCA), S-Video, Composite, RS232, Audio in RCA (1 – R/L), Audio in 3.5mm (1), Audio Out (1 – R/L), RJ45 (2), USB-B (1) and USB-A (6). Bezel Connector Side Connector Panel Panel Bott om Connect or P anel Page 14
Summary of the content on the page No. 17
Bezel Connector Panel P o w er butt on Keypad USB-A jacks USB-B jack Side Connector Panel RJ45 Audio Out (L/R) RS232 Power LED USB-A Antennas (for Sound Bar) PC Reset Audio In (L/R) butt on Audio In (3.5mm) Bott om Connect or P anel S-video Component AC Power In Power switch HDMI® AC Power Out Composite (YPbPr) VGA Connecting AC Power 1) Connect one end of the AC power cord to the AC In jack on the back of the tablet. 2) Connect the other end of the AC power cord to an AC outlet. 3) Pr
Summary of the content on the page No. 18
Turning the INF5520 On/Off 1) Verify that the power cord is connected to a power outlet and that the power switch on the Bottom Connector Panel is ON. 2) Press the Power button located on either: a. the remote b. the right side of the tablet c. or the back of the tablet on the PC box. The front LED turns green. 3) Press the Power button again to put Mondopad into Standby. The front LED turns red. You can also put your tablet to sleep us- ing the keyboard. The front LED turns orange. NOTES: If t
Summary of the content on the page No. 19
Setting up the Wireless Mouse and Keyboard NOTE: The wireless mouse and keyboard is not included as a standard accessory for some countries. For initial setup and/or con- figuration, it may be easier to use a mouse and keyboard. Any standard wired or wireless mouse or keyboard, connected through the Mondopad USB ports, is supported by Mondopad. Wireless Mouse 1) Turn the mouse over and remove the battery cover. 2) Remove the USB dongle from its holder in the battery compartment of the mouse. 3
Summary of the content on the page No. 20
Using the Remote The remote uses two (2) AAA batteries (not included). Install the batteries by removing the cover from the remote’s back, aligning the + and – ends of the batteries, sliding them in place and replacing the cover. To operate, point the remote at the tablet sensor at the bottom right-hand corner of the tablet. The range of optimum operation is about 26’ (8m) and within a horizontal and vertical angle of 30 degrees. 30˚ 30˚ POWER HOME INPUT MENU RESIZE PIP ON/OFF INPUT SWAP POS
