Summary of the content on the page No. 1
H- CDM8070
CD/MP3-RECEIVER CD/MP3-
Instruction manual
Summary of the content on the page No. 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Tabl of contents.......................................................................................................................................................................2 Importansafeguards..................................................
Summary of the content on the page No. 3
Important safeguards · Read carefully through this manual to familiarize yourself with this high-quality sound system. · Use only in a 12-volt DC negative-ground electrical system. · Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. · When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. · DO NOT attempt to disassemble the unit. · Make sure that pins
Summary of the content on the page No. 4
Installation/Connections 4
Summary of the content on the page No. 5
Din front-mount (method 1) · After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure to the place · Insert fingers into the groove in the front of frame and remove it. · Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard. 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 25mm) 5. Screw 6. Strap 7. Plain washer 5
Summary of the content on the page No. 6
Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each sides. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 2. Screw 3. Factory radio mounting bracket. 4. Dashboard or Console 5. Hook (Remove this parts) Note: The mounting box, outer trim ring, and the Hal
Summary of the content on the page No. 7
Electrical connections 7
Summary of the content on the page No. 8
Panel controls 1. V-SEL/ MENU/ ENTER (SEL); VOLUME-UP/DOWN, MENU-UP/DOWN (+/-) BUTTONS. 2. POWER BUTTON. Press any button except the OPEN button to turn on the unit, 3. PRESET STATION [1-6] AND PLAY/PAUSE, INT, RPT, RDM BUTTONS. 4. Display 5. TUNING KNOB/UP AND DOWN KNOB 6. OPEN BUTTON. Press it to flip down the front panel and you can insert the disc into the CD compartment or press the EJ button to eject the disc from the disc compartment. 7. TA (Traffic Announcement) button. 8. AF (Alternativ
Summary of the content on the page No. 9
12. Disc playback: Track random play. 13. Disc playback: Track repeat play. 14. Disc playback: Intro play (10 seconds). 15. Disc playback: Play/ Pause. Top play (press more than 2 seconds). 16. Band switch: FM1, FM2, FM3, MW1, MW2. 17. F/PS button: automatic scan/Store. 18. PTY (Program Type) button. 9
Summary of the content on the page No. 10
Menu Function Press the POWER button to turn the unit on, the display will show a message to indicate it is ready to use. Press the BAND for the radio mode, press MODE to select between Radio mode and CD play. Press the POWER button again to turn the unit off. VOLUME CONTROL A. The volume level can be adjusted at any time by rotating the audio level VOL knob as select mode has been initially defaulted at volume mode. BASS CONTROL A. Press the SEL button to select the bass mode until BAS appears
Summary of the content on the page No. 11
Time clock setting Part of the RDS data is used to transmit the current time and date, therefore the clock of this radio never has to be adjusted, and will automatically set itself for summer and winter time changes. To view the time display, press the CLK Button at any time so that the time will display on the LCD screen. Preset EQ function This unit incorporates the high technology of digital equalizer preset. Press the SEL button for 2 Seconds, the Display wills how TA SEEK. Continuously pres
Summary of the content on the page No. 12
Preset Volume level Press the SEL button for 2 Seconds, the Display wills how TA SEEK. Continuously press the SEL button to choose the options in the MENU, until VOL LAST is displayed. In this mode the unit will be turned on with the same volume level at which the unit was shut down the last time. You can rotate the SEL Button to choose to choose VOL ADJ. Press the SEL Button to confirm, then A-VOL will be displayed. At this time rotate the Volume Control to set the volume level you preferred. T
Summary of the content on the page No. 13
Save Your Preset Stations There are Six numbered preset buttons which can store and recall stations for each band. There are 5 bands and 30 available preset stations slot. 3 FM bands, F1, F2, and F3 making a total of 18 preset stations in FM band. 2MW bands, MW1 and MW2 making a total of total 12 preset stations in MW band. RDS - EON CONTROL This unit is equipped with the latest technology of EON control, so that when you are listening to Radio or CD, if there is any travel announcement from a n
Summary of the content on the page No. 14
AF- ALTERNATIVE FREQUENCY Press the AF button so that the unit will choose the strongest FM signal for the selected station, so that you do not have to re-tune the stations when driving between different transmitter coverage areas. When AF is on, it means RDS information is received; when AF is flashing, it means RDS information is not yet received. MASK DPI- MASK ALL Press the SEL button for 2 Seconds, the Display wills how TA SEEK. Continuously press the SEL button to choose the options in the
Summary of the content on the page No. 15
Track - Forward / Fast Forward Rotate the knob to advance disc to the next track, the track numbers will be shown on the LCD display. Rotate and hold the knob to fast forward. Disc will play normal when the button is released. Tracks - Backward / Fast Backward Rotate the knob to backward disc to the previous track, the track numbers will be shown on the LCD display. Rotate and hold the knob to fast backward. Disc will play normal when the button is released. Pause : Pause The Cd Play Press this
Summary of the content on the page No. 16
MP3 Play back MP3 Electronic Shock Protection This unit is built-in with 120 seconds of electronic shock protection for Mp3 so that you can better enjoy your music. MP3 TRACK SEARCH This unit is capable of displaying ID3 tag which is used in MP3 operation. When the CD media is playing the unit will show the information of folder, file name, song name, artist name and album name for you to better enjoy the music. You can make use of the 4 search modes to play your favorite Mp3 songs. (1) ORDINARY
Summary of the content on the page No. 17
MP3 Overview Notes on MP3 · MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. · This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. · The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write. · The unit can not read an MP3 file that has a file extension other than .mp3 . · If you play a non- MP3 file that has the .mp3 extension, you ma
Summary of the content on the page No. 18
· Up to 16 characters are displayed for the name of an Album or a Track. ID3TAG version 1.x is required. · Note that the unit may not play Tracks in the order that you wrote them to the disc. Anti-Theft System This unit is equipped with a slide-down detachable panel. Removing this panel makes the radio totally inoperable. Place the detachable panel into the case. 1. Switch off the power of the unit. 2. Remove the detachable panel. 3. Gently press the button of the case and open the cover. 4. Pla
Summary of the content on the page No. 19
Handling compact discs · Dirty, scratched or warped discs may cause skip ping or noise. · Handle the disc only by the edges. To keep clean do not touch its surface. · Discs should be stored in their cases after use to avoid scratches. · Do not expose discs to direct sunlight, high humidity, high temperature or dust. · Prolonged exposure to extreme temperature can wrap the disc (such as leaving the discs in your car during summertime). · Do not stick or write anything on either side of disc. Shar
Summary of the content on the page No. 20
Components 1. Nut 5 mm 1 pc 2. Spring washer 2 pcs 3. Screw M5x25 mm 1 pc 4. Screw 1 pc 5. Plain washer 2 pcs 6. Strap 1 pc 7. Operating instructions 1 pc. 8. Key 2 pcs. 9. Mounting collar 1 pc. 10. Wire connector 1 pc. 11. Removable face plate
