Summary of the content on the page No. 1
Operator’s Manual
4-Cycle Gasoline Trimmers
CC4125 / CC4175
SAVE THESE INSTRUCTIONS
For service call 1-877-282-8684 in the United States, or
1-800-668-1238 in Canada to obtain a list of authorized service
dealers near you. For more details about your unit, visit our
website at www.cubcadet.com.
DO NOT RETURN THE UNIT TO THE RETAILER. PROOF OF
PURCHASE WILL BE REQUIRED FOR WARRANTY
SERVICE.
THIS PRODUCT IS COVERED BY ONE OR MORE U.S.
PATENTS. OTHER PATENTS PENDING.
Service on this unit both wi
Summary of the content on the page No. 2
RULES FOR SAFE OPERATION • IMPORTANT SAFETY INSTRUCTIONS • READ ALL INSTRUCTIONS BEFORE OPERATING • Wear heavy long pants, boots, gloves and a long sleeve shirt. Do not wear loose clothing, jewelry, short pants, WARNING: When using the unit, you must follow sandals or go barefoot. Secure hair above shoulder level. the safety rules. Please read these instructions before • The cutting attachment shield must always be in place while operating the unit in order to ensure the safety of the operating
Summary of the content on the page No. 3
RULES FOR SAFE OPERATION SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING SYMBOL MEANING • ON/OFF STOP CONTROL • SAFETY ALERT SYMBOL ON / START / RUN Indicates danger, warning or caution. May be used in conjunction with other symbols or pictographs. • ON/OFF STOP CONTROL • WAR
Summary of the content on the page No. 4
ASSEMBLY INSTRUCTIONS INSTALL CUTTING ATTACHMENT SHIELD WARNING: To prevent serious personal injury, never operate the trimmer without the cutting attachment shield in place. Use the following instructions if the cutting attachment shield on your unit is not installed. Use only the instructions that apply to the type of shaft and shield that your unit is equipped with. CC4125 1. Place the cutting attachment shield onto the shaft housing. Be sure the guard mounting bracket slides into the slot on
Summary of the content on the page No. 5
OIL AND FUEL INFORMATION RECOMMENDED OIL TYPE RECOMMENDED FUEL TYPE Using the proper type and weight of oil in the crankcase is extremely Old fuel is the primary reason for improper unit performance. important. Check the oil before each use and change the oil regularly. Be sure to use fresh, clean, unleaded gasoline. Failure to use the correct oil, or using dirty oil, can cause premature NOTE: This is a four cycle engine. In order to avoid damage engine wear and failure. Use a high-quality SAE
Summary of the content on the page No. 6
STARTING / STOPPING INSTRUCTIONS Stop/Off (O) WARNING: Operate this unit only in a well- ventilated outdoor area. Carbon monoxide exhaust fumes can be lethal Start/On ( I ) in a confined area. WARNING: Avoid accidental starting. Make sure you are in the starting position when pulling the starter rope (Fig. 13). To avoid serious injury, the operator and unit must be in a stable position while starting. Make sure that any Add-On item is installed correctly and secure before starting the unit. Thr
Summary of the content on the page No. 7
OPERATING INSTRUCTIONS ™ OPERATING THE RAPID-LINK SYSTEM 90˚ Edging Hole The Rapid-Link™ system enables the use of this optional Add- (Trimmer Only) On: Blower/Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .CCBT* * Do NOT use this attachment with an electric powered unit. Removing the Cutting Attachment or Add-On WARNING: Before you begin using any Knob attachment, read and understand the manual that came with the attachment. Follow all safety information contained with
Summary of the content on the page No. 8
OPERATING INSTRUCTIONS TIPS FOR BEST TRIMMING RESULTS DECORATIVE TRIMMING • For best trimming results, operate unit at full throttle. Decorative trimming is accomplished by removing all vegetation around trees, posts, fences and more. • Keep the cutting attachment parallel to the ground. Rotate the whole unit so that the cutting attachment is at a 30° • Do not force the cutting attachment. Allow the tip of the line angle to the ground (Fig. 19). to do the cutting, especially along walls. Cutting
Summary of the content on the page No. 9
MAINTENANCE AND REPAIR INSTRUCTIONS O-Ring Oil Fill Plug/Dipstick Fig. 22 Oil Fill Hole Fig. 25 5. Push the trimmer line until it lies flat against the cutting CHANGING THE OIL head (Fig. 23). Make sure the For a new engine, change the oil after the first 10 hours of operation. two lengths of cutting line are Change the oil while the engine is still warm. The oil will flow freely of equal length. If they are and carry away more impurities. not, adjust until they are. 1. Unplug spark plug boot
Summary of the content on the page No. 10
MAINTENANCE AND REPAIR INSTRUCTIONS AIR FILTER MAINTENANCE 5. Squeeze the filter to spread and remove excess oil (Fig. 31). Cleaning the Air Filter WARNING: To avoid serious personal injury, always turn the unit off and allow it to cool before you clean or service it. Clean and re-oil the air filter every 10 hours of operation. It is an important item to maintain. Failure to maintain your air filter properly can result in poor performance or can cause permanent damage to your engine. 1. Open the
Summary of the content on the page No. 11
MAINTENANCE AND REPAIR INSTRUCTIONS CARBURETOR ADJUSTMENT Checking the fuel, cleaning the air filter, and adjusting the idle speed should solve most engine problems. If not and all of the The idle speed of the engine is adjustable. An idle adjustment following are true: screw is reached though a hole in the top of the engine cover (Fig. 34). • the engine will not idle NOTE: Careless adjustments can seriously damage your unit. • the engine hesitates or stalls on acceleration An authorized service
Summary of the content on the page No. 12
MAINTENANCE AND REPAIR INSTRUCTIONS 3. Disconnect the spark plug wire. Exhaust Adjusting Nut 4. Clean dirt from around the spark plug. Remove the spark Exhaust plug from the cylinder head by turning a 5/8 in. socket Rocker Arm counterclockwise. 5. Remove the engine cover (Fig. 35 & 36). 6. Clean dirt from around the rocker arm cover. Remove the screw holding the rocker arm cover with a large flat blade screwdriver or Torx T-25 bit (Fig. 37). Remove the rocker 0.003–0.006 in. arm cover and gaske
Summary of the content on the page No. 13
MAINTENANCE AND REPAIR INSTRUCTIONS REPLACING THE SPARK PLUG CLEANING Use a replacement part number 791-180852B spark plug. The WARNING: To avoid serious personal injury, correct air gap is 0.025 in. (0.635 mm.). Remove the plug after always turn your unit off and allow it to cool before every 25 hours of operation and check its condition. you clean or service it. 1. Stop the engine and allow it to cool. Grasp the plug wire firmly and pull the cap from the spark plug. Use a small brush to clean
Summary of the content on the page No. 14
TROUBLESHOOTING ENGINE WILL NOT START CAUSE ACTION Empty fuel tank Fill fuel tank with fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 10 times Old fuel Drain gas tank and add fresh fuel Fouled spark plug Replace or clean the spark plug Plugged spark arrestor Clean or replace spark arrestor When it is above 40°F outside & the Cold Weather Start Lever Flip the Cold Weather Start Lever to RUN / OPEN is in the CLOSED / START position When it is below 40°F outside & the Co
Summary of the content on the page No. 15
SPECIFICATIONS ENGINE* Engine Type................................................................................................................................................................. Air-Cooled, 4-Cycle Displacement................................................................................................................................................................ 1.6 cu. in. (26.2 cc) Clutch Type .............................................................................
Summary of the content on the page No. 16
MANUFACTURER’S LIMITED WARRANTY FOR: No implied warranty, including any implied warranty of The limited warranty set forth below is given by Cub Cadet LLC merchantability or fitness for a particular purpose, applies with respect to new merchandise purchased and used in the after the applicable period of express written warranty above United States, its possessions and territories. as to the parts as identified. No other express warranty or Cub Cadet LLC warrants this product against defects in m
Summary of the content on the page No. 17
Manuel de l'utilisateur Désherbeuse à gaz à 4-temps CC4125 / CC4175 CONSERVER CES INSTRUCTIONS Obtenez la liste des concessionnaires agréés appelez le 1-877- 282-8684 aux États-Unis ou le 1-800-668-1238 au Canada. Pour de plus amples informations à propos de votre appareil, visitez www.cubcadet.com. NE RETOURNEZ PAS L'APPAREIL AU DÉTAILLANT CHEZ QUI VOUS L'AVEZ ACHETÉ. TOUT SERVICE SOUS GARANTIE NÉCESSITE UNE PREUVE D'ACHAT. CE PRODUIT EST COUVERT PAR UN OU PLUSIEURS BREVETS AMÉRICAINS, ET D’AU
Summary of the content on the page No. 18
CONSIGNES DE SÉCURITÉ • IMPORTANTES CONSIGNES DE SÉCURITÉ • LIRE TOUTES LES INSTRUCTIONS AVANT UTILISATION • Le protecteur d'accessoire de coupe doit toujours être en place lors de l'utilisation de l'appareil. Ne faites pas marcher • Veuillez lire les instructions avec soin. Familiarisez-vous avec l'appareil sans que les deux fils soient bien déployés, en les commandes et l'utilisation correcte de cet appareil. supposant qu'un fil approprié a été installé. Assurez-vous • N'utilisez pas l'apparei
Summary of the content on the page No. 19
CONSIGNES DE SÉCURITÉ SYMBOLES DE SÉCURITÉ ET INTERNATIONAUX Ce manuel de l'utilisateur décrit les symboles et pictogrammes de sécurité et internationaux pouvant apparaître sur ce produit. Consultez le manuel de l'utilisateur pour les informations concernant la sécurité, le montage, le fonctionnement, l'entretien et les réparations. SYMBOLE SIGNIFICATION SYMBOLE SIGNIFICATION • SYMBOLE ALERTE DE SÉCURITÉ • COMMANDE MARCHE/ARRÊT Indique un danger, un avertissement ou une ALLUMAGE / DÉMARRAGE / M
Summary of the content on the page No. 20
INSTRUCTIONS DE MONTAGE INSTALLATION DU PROTECTEUR D'ACCESSOIRE DE COUPE Suivez les instructions suivantes si le protecteur d'accessoire de coupe n'est pas installé sur l'appareil. AVERTISSEMENT : n'utilisez jamais la désherbeuse sans protecteur d'accessoire de coupe pour éviter des blessures graves. CC4125 1. Placez l’écran de l’accessoire de coupe sur le logement de l’arbre. Veillez à ce que la patte d’attache de l’écran glisse dans l’encoche au bord de l’écran de coupe. Tournez l’écran dans
