Summary of the content on the page No. 1
VX-HDMI-FO
3D HDMI Fiber Extender
Extend video, 3D video (1080i), and audio signals
®
BLACK BOX
up to 1600 meters from an A/V source
via multimode fiber optic cable.
Using duplex multimode cable and 1080p video, extend the distance
up to 800 meters.
Customer Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S.
Support call 724-746-5500) FREE technical support 24 hours a day, 7 days
Information a week: Call 724-746-5500 or fax 724-746-0746 Mailing address:
Black Box Corporati
Summary of the content on the page No. 2
Trademarks Used in this Manual Trademarks Used in this Manual Black Box and the Double Diamond logo are registered trademarks of BB Technologies, Inc. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. Page 2 724-746-5500 | blackbox.com
Summary of the content on the page No. 3
FCC and IC RFI Statements FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interf erence to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part
Summary of the content on the page No. 4
NOM Statement 4. Todas las instrucciones de operación y uso deben ser seguidas. 5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc. 6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante. 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar d
Summary of the content on the page No. 5
NOM Statement 16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo. 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato; o C: El aparato ha sido expuesto a la lluvia; o
Summary of the content on the page No. 6
Table of Contents Chapter Page 1. Specifications ............................................................................................... 7 2. Overview ..................................................................................................... 8 2.1 Introduction ........................................................................................ 8 2.2 Features ............................................................................................... 8 2.3 What’s
Summary of the content on the page No. 7
Chapter 1: Specifications 1. Specifications 3D Video Supported — Yes Cable — 50/125-µ or 62.5/125µ duplex multimode fiber optic cable Extension Distance — 2560 feet (800 m), approx. 0.5 mi. (1080p); 5120 feet (1600 m), approx. 1 mi. (1080i) User Controls — Local unit: (1) EDID config button; Remote unit: None Video Resolution (Maximum) — Full HD: (1920 x 1080), WUXGA: (1920 x 1200) Connectors — Local unit: Input: (1) HDMI, Output: (1) HDMI, (1) IR (infrared), (1) SC fiber;
Summary of the content on the page No. 8
Chapter 2: Overview 2. Overview 2.1 Introduction The 3D HDMI Fiber Extender consists of a Local and a Remote Unit. It enables users to extend video, 3D video (1080i), and audio signals up to 5120 feet (1600 m, approx. 1 mi.) from an A/V source via duplex multimode fiber optic cable, or up to 2560 feet (800 m, approx. 0.5 mi., 1080p) using duplex multimode fiber optic cable. The HDMI digital display supports up to the maximum resolution of full HD (1920 x 1080)/WUXGA and (1920 x 1200)/UXGA (1
Summary of the content on the page No. 9
Chapter 2: Overview • (10) small screws • (8) small rare earth magnets for mounting • Quick Install Guide 2.4 System Requirements You will need to supply the following items: • HDCP compliant monitors with HDMI interface for the HDCP video source • HDMI cable 2.5 Hardware Description Figures 2-1 shows the local and remote units. Table 2-1 describes their components. R1 R2 R3 L1 L2 L3 R4 R5 L5 L4 L8 R6 R7 L8 L6 L7 Figure 2-1. Local (L) and Remote (R) units. 724-746-
Summary of the content on the page No. 10
Chapter 2: Overview Table 2-1. Local and remote units components. SC-SC fiber Connect the multimode optical fiber cable to L1 R1 interface this port. L2 — Connect to the HDMI source. HDMI connector — R2 Connect to the HDMI monitor. L3 R3 Power supply Apply the proper power to the unit. Yellow: Video signal OK/EDID configuration L4 R4 Video OK LED (see Chapter 5). Green: Power on L5 R5 Link OK/Power LED Blue: Connect to a powered-on extender unit. L6 R6 HDMI connector Connect to the HDMI mo
Summary of the content on the page No. 11
Chapter 3: Installation 3. Installation CAUTION: Do not stare into the beam or look directly into the ends of any fiber optic cables. You might be exposed to invisible laser radiation. The laser beam can injure the eye. 3.1 Preparing for Installation • Determine where the Local Unit and Remote Unit will be located • Use SC to SC duplex multimode fiber optic cable (50/125 or 62.5/125) to interconnect the local and remote units. • Make sure that the fiber cable length is long enough for the
Summary of the content on the page No. 12
Chapter 3: Installation 3.2 Installation Steps 1. Connect the video source to the local unit. 2. Connect the monitor to the local unit and/or remote unit. 3. Use an SC-to-SC duplex multimode fiber optic cable to link the SC-SC fiber ports on the Local and Remote Units together. 4. A fter all device connections are completed, connect the provided power cord into an appropriate power source, and plug the opposite end into the power connector on the unit. Page 12 724-746-5500 | blackbox.c
Summary of the content on the page No. 13
Chapter 4: Operation 4. Operation The LEDs on the Extender Units show the real-time status indicating the linking and communication between the local and the remote unit. The LED indicator on the top of the unit shows the status. The quality of the output signal depends upon the quality of the video source, cable, and display device used. Low-quality cables degrade output signals causing elevated noise levels. Use the proper cable and make sure the display device is capable of handling the
Summary of the content on the page No. 14
Chapter 5: EDID Configuration (Local Unit Only) 5. EDID Configuration (Local Unit Only) In some cases, display problems may occur because of incorrect EDID communication between the display monitor and the unit or inappropriate EDID data programmed by display manufacturers. Press the “EDID Config” button on the top panel of the local unit to enable the unit to configure EDID from EDID-compliant monitors or have the system automatically optimize all valid (audio and/or video) outputs. Table
Summary of the content on the page No. 15
Chapter 5: EDID Configuration (Local Unit Only) Mode 1: Auto Mixing + EDID Config Step 1. Press and hold the “EDID config” button for three seconds. Step 2. Release the button right after the Video OK LED flashes yellow quickly. Step 3. When the LED flashes yellow twice, it has learned the audio configuration, and the system will reboot. NOTE: If the LED flashes four times, it signifies failed EDID Config. Please try again. The system enters Auto Mixing and Config Local Monitor Audio EDID mode
Summary of the content on the page No. 16
Chapter 5: EDID Configuration (Local Unit Only) Table 5-2. LED Indicator functions. Press “EDID Video OK LED config” button for indicator Status Auto mixing (video) and 3 seconds Yellow: Flash quickly Copy local monitor EDID (audio) Copy local monitor EDID 6 seconds Yellow: Flash slowly (video + audio) Auto mixing (video + 9 seconds Off audio) Successful copy and — Yellow: Flash twice system reboot — Yellow: Flash four times Failed copy Page 16 724-746-5500 | blackbox.com
Summary of the content on the page No. 17
Appendix: Installing Duplex Multimode Fiber Cable Appendix. Installing Duplex Multimode Fiber Optic Cable 1. We recommend that you use OM3 multimode fiber optic cable (50/125 and 62.5/125) terminated with SC duplex connectors to interconnect the local unit and remote unit. Table A-1 shows the specifications. Table A-1. Duplex multimode fiber optic cable specifications. Cable Diameter (micron) 50/125 µm 62.5/125 µm Video signal 1080i 1080p 1080i 1080p Maximum cable 5120 ft. 2560 ft. 1640 ft 8
Summary of the content on the page No. 18
NOTES Page 18 724-746-5500 | blackbox.com
Summary of the content on the page No. 19
NOTES 724-746-5500 | blackbox.com Page 19
Summary of the content on the page No. 20
Chapter Black Box Tech Support: FREE! Live. 24/7. Tech support the way it should be. Great tech support is just 30 seconds away at 724-746-5500 or blackbox.com. About Black Box Black Box provides an extensive range of networking and infrastructure products. You’ll find everything from cabinets and racks and power and surge protection products to media converters and Ethernet switches all supported by free, live 24/7 Tech Support available in 30 seconds or less. © Copyright 2012. Black Bo